Soldered Electrical
Found 7 free book(s)Body Builder Electrical Guide - International® Trucks
www.internationaltrucks.comIn addition to this Body Builder Electrical Data Book, publication CT-471, Body Builder Data, may be required. ... Spliced wires should be twisted together and soldered. Use a heat shrink tube with a meltable inner wall to seal the connection. Do not expose splices to the weather. WARNING – To avoid serious personal injury, possible death, or ...
High noise immunity • CMOS low power dissipation • Latch ...
assets.nexperia.com(1) This is not a ground pin. There is no electrical or mechanical requirement to solder the pad. In case soldered, the solder land should remain floating or connected to GND. Fig. 6. Pin configuration SOT763-1 (DHVQFN16) 74HC_HCT4040Product data sheet All information provided in this document is subject to legal disclaimers.
High noise immunity • JESD8C (2.7 V to 3.6 V) 74HC4051 ...
assets.nexperia.comThere is no electrical or ... In case soldered, the solder land should remain floating or connected to VCC. Fig. 6. Pin configuration SOT763-1 (DHVQFN16) 6.2. Pin description Table 2. Pin description Symbol Pin Description E 6 enable input (active LOW) VEE 7 supply voltage
Conductors & Terminations - Electrical Sector – Eaton
www.cooperindustries.com56 ©2005 Cooper Bussmann Conductors & Terminations Application Considerations 4. The quick connect terminal is not seated properly. If the male-female connections are
LT1965 - 1.1A, Low Noise, Low Dropout Linear Regulator
www.analog.comelectrical characteristics PARAMETER CONDITIONS MIN TYP MAX UNITS Minimum Input Voltage (Notes 4, 12) ILOAD = 0.5A ILOAD = 1.1A (TJ < 125°C) ILOAD = 1A (H-Grade, TJ > 125°C) l 1.65 1.8 2.3 2.3 V V V Regulated Output Voltage (Note 5) LT1965-1.5, VIN = 2.1V, ILOAD = 1mA LT1965-1.5, 2.5 < VIN < 20V, 1mA < ILOAD < 1.1A l 1.477 1.455 1.5 1.5 1.523 ...
LTC5510 - 1MHz to 6GHz Wideband High Linearity Active Mixer
www.analog.comAC ELECTRICAL CHARACTERISTICS The l denotes the specifications which apply over the full operating temperature range, otherwise specifications are at TC = 25°C. EN = High, PLO = 0dBm, PIN = –10dBm (–10dBm/tone for two-tone tests), unless otherwise noted. Test circuit shown in Figure 1. (Notes 2, 3, 4) PARAMETER CONDITIONS MIN TYP MAX UNITS
LM321 Low Power Single Operational Amplifier datasheet ...
www.ti.comtemperature is PD = (TJ(MAX) - TA)/ θJA. All numbers apply for packages soldered directly onto a PC board. 6.2 ESD Ratings VALUE UNIT V(ESD) Electrostatic discharge Human-body model (HBM), per ANSI/ESDA/JEDEC JS-001(1) ±300 V (1) JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process.