To Select And Mount Transducers In
Found 3 free book(s)
2022 TRANSDUCER SELECTION GUIDE - Garmin
www8.garmin.comADDITIONAL TRANSDUCERS // PAGE 24 • Transom Mount • Thru-hull Traditional • Thru-hull CHIRP Traditional • In-hull • Pocket Mount ACCESSORIES AND SENSORS // PAGE 32 • Accessories • Smart Sensors • NMEA 2000® PANOPTIX LIVESCOPE ™ Our award-winning Panoptix LiveScope sonar brings real-time scanning sonar to life.
INSTALLATION PANOPTIX LIVESCOPE INSTRUCTIONS …
static.garmin.comAssembling the Transom-Mount Hardware. 1 Attach the transducer mount bracket to the transducer using the mounting screws and lock washers . 2 Attach the transducer mount bracket to the transom mount bracket using the bolts , flat washers , and lock nuts . NOTE: The recommended torque applied to the bolts is 15 lb-ft. (20 N-m). 7
Thru-Hull Transducer Updating the Device Software card ...
static.garmin.comnecessary to mount the transducer. If the deadrise angle of your mounting location exceeds 5°, you should use a fairing block to mount the transducer. Deadrise Angle Deadrise is the angle formed between a horizontal line and a boat hull at a single point. You can measure the deadrise angle with an angle finder, a protractor, or a digital level.