AIR CONDITIONER OPERATING MANUAL Wall Mounted …

1 AIR CONDITIONER OPERATING MANUAL . English Wall Mounted Type Contents Safety Precautions ..En-1. Indoor Unit Overview and Operations ..En-2. Remote Controller Overview and Operations ..En-3. Timer Human Sensor (Energy Saving) ..En-5. General Informations on Operation ..En-6. Care and Troubleshooting ..En-9. Before using this product, read these instructions thoroughly and keep this MANUAL for future reference. Safety Precautions To prevent personal injury to others, or property damage, read this section carefully before you use this product, and be sure to comply following safety precautions. Incorrect operation due to failure to follow the instructions may cause harm or damage, the seriousness of which is classified as follows: WARNING CAUTION. This mark warns of death or serious injury. This mark warns of injury or damage to property. This mark denotes an action that is PROHIBITED. This mark denotes an action that is COMPULSORY.

2 WARNING. This unit contains no user-serviceable parts. Always consult If you see lightning or hear thunder, there might be a lightning strike. authorized service personnel for repairing, installation, and To prevent electric shock hazard, turn off the air CONDITIONER relocation of this product. by using the remote controller, and do not touch the unit or Improper installation or handling will cause leakage, electric the power plug during thunderstorm. shock, or fire. Do not install the unit in area filled with mineral oil such as a In the event of a malfunction such as burning smell, factory or area containing a large amount of splashed oil or immediately stop operation of the air CONDITIONER , and steam such as a kitchen. disconnect all the power supply by turning off the electrical Do not start or stop the operation of this product by inserting breaker or disconnecting the power plug. Then consult or pulling out the power plug, or by turning on or off the authorized service personnel.

3 Circuit breaker. Do not use inflammable gases near the unit. Take care not to damage the power supply cable. If the supply cord is damaged, it must be replaced by the Do not expose yourself directly to the cooling airflow for many hours. manufacturer, its service agent or similarly qualified persons Do not insert your fingers or any other objects into outlet in order to avoid a hazard. port, open panel, or intake grille. Do not operate with wet hands. In the event of refrigerant leakage, be sure to keep away from fire or any flammables, and consult authorized service personnel. CAUTION. Provide occasional ventilation during use. Do not direct the airflow at fireplaces or heating apparatus. Always operate the unit with air filters installed. Do not block or cover the intake grille and the outlet port. Ensure that any electronic equipment is at least 1 meter Do not apply any heavy pressure to radiator fins.

4 Away from either the indoor unit or outdoor unit. Do not climb on, place objects on, or hang objects from the unit. Unplug the power supply cable when not using the indoor Do not place vase or water container on the unit. unit for an extended period. Do not place any other electrical products or household After long period of use, check whether the installation stand belongings under indoor unit or outdoor unit. does not deteriorate to prevent the unit from falling down. Dripping condensation from the unit might get them wet, and The airflow direction and the room temperature should be may cause damage or malfunction of your property. carefully considered when you use this product in a room Do not expose the unit directly to water. with infants, children, elderly or sick persons. Do not use this product for preservation of food, plants, This appliance is not intended for use by persons (including animals, precision equipment, art work, or other objects.)

5 This children) with reduced physical, sensory or mental may cause quality deterioration of those items. capabilities, or lack of experience and knowledge, unless Do not expose animals or plants to the direct airflow. they have been given supervision or instruction concerning Do not drink the drainage from the air CONDITIONER . use of the appliance by a person responsible for their safety. Do not pull the power supply cable to disconnect the plug. Children should be supervised to ensure that they do not Do not touch the aluminum fins of heat exchanger built-in play with the appliance. the indoor or outdoor unit to avoid personal injury when you install or maintain the unit. PART No. 9333003030 En-1. 1 11/13/2013 1:49:11 PM. Indoor Unit Overview and Operations 1 Intake grille 2. Before starting operation, make sure that the intake grille has been shut completely. Incomplete closing may have an effect on the proper function or performance of the product.

6 1. 2 manual AUTO button Use when the remote controller is lost or there is a malfunction. 14. Status Action Mode or operation 3. In operation Press more than 3 seconds. Stop Stopping Press more than 3 seconds and AUTO. less than 10 seconds. 4. Press more than 10 seconds. Forced cooling (Only for servicing.*). 5. After cleaning Press less than 3 seconds. Filter indicator reset 13. *:To stop forced cooling, press this button or START/STOP button on 6. the remote controller. 3 Front panel 12. 7. 4 Human Sensor See page 5 8. Used for Energy Saving Program. Controls temperature setting by detecting people in the room. 9. 11. 5 Vertical airflow direction louver 10. Each time you press SET button on the remote controller, the angle of the vertical airflow direction louver moves as follows: 11 OPERATION indicator (green). Lights in normal operation, and blinks slowly in Automatic defrosting COOL or DRY mode HEAT mode operation.

7 1. 2 1* 2 3 4 5 6 7* 12 Horizontal airflow direction louvers 3. 4. 5 *: Default setting in each mode. 6 7 CAUTION. Do not adjust by hand. Before you adjust the horizontal airflow direction, make sure that At the beginning of AUTO or HEAT mode, they may stay on position the vertical airflow direction louver has been stopped completely. 1 for a while for adjustment. If the angle is set to position 4 7 for more than 30 minutes in COOL Adjust two knobs by hand. or DRY mode, the louver will automatically return to position 3. Keeping the position 4-7 during COOL or DRY mode may cause 13 Air filter See page 7. condensation to form, and the drops may damage your property. 14 Air cleaning filters See page 8. 6 Power diffuser Purify or deodorize the air, and provide fresh airflow. In conjunction with movement of the vertical airflow direction louver, the angle of the power diffuser moves as follows: Indoor unit accessories Vertical airflow 1 2 3 4 5 6 7.

8 Direction louver Power diffuser 1 2 3 4. In SWING operation, power diffuser does not move. 7 Drain hose Remote Remote controller Tapping screws controller holder (M3 12 mm). 8 Remote controller signal receiver CAUTION. For appropriate signal transmission between remote controller and Air cleaning filters Filter holders indoor unit, keep the signal receiver away from the following items: - Direct sunlight or other strong lights - Flat-panel television screen WARNING. In rooms with instantaneous fluorescent lights, such as Take care to prevent infants and young children from acciden- inverter type ones, the signal may not be transmitted properly. tally swallowing the batteries. In such a case, consult the store of purchase. Remote controller holder installation 9 ECONOMY indicator (green). 1 2 3 Slide up Lights in ECONOMY operation and in 10 C HEAT operation. 10 TIMER indicator (orange). Screws Lights in TIMER operation, and blinks slowly when the timer setting Insert error is detected.

9 For details, refer to Auto-restart function on page 6. En-2 OPERATING MANUAL . 2 11/13/2013 1:49:20 PM. AIR CONDITIONER Wall Mounted Type Remote Controller Overview and Operations CAUTION. To prevent malfunction or damage of the remote controller: If leaking battery fluid comes in contact with your skin, eyes, - Place remote controller at where will not be exposed to or mouth, immediately rinse with plenty of clean water, and direct sunlight or excessive heat. consult your physician. - Remove batteries if the product is not going to be used for Obstacles such as a curtain or wall between the remote an extended period. controller and the indoor unit may affect the appropriate - Exhausted batteries must be removed immediately, and signal transmission. be disposed according to the local laws and regulations of your region. Do not apply strong shocks to the remote controller. Do not pour water on the remote controller.

10 Do not attempt to recharge dry batteries. Battery (R03/LR03/AAA 2) loading and remote controller preparation 3. 4. 1 6. 5. 2 7. 5 Press CLOCK ADJUST button to start clock setting. Notes: 6 Set the time by pressing SELECT button . Batteries are not included with this product. Pressing or changes the value by the minute. Use specified type of battery only. Pressing down on or changes the value by 10 minutes. Do not use new battery and used battery together. Batteries can be used about 1 year in ordinary use. 7 Press the CLOCK ADJUST button again to complete the clock If the remote control range noticeably got shorten, replace the setting. batteries, and press RESET button . You can quickly start operation with the following 3 steps: In initial setting, this function is activated. 1 START/STOP button To inactivate the function, consult the installer or authorized service personnel. 2 MODE button Even if the setting is changed, if the fan speed is set to AUTO in Switches operation mode in following order.