AIRPLANE MAINTENANCE MANUAL - AME Academy

1 AIRPLANE MAINTENANCE MANUALFor theCIRRUS DESIGN SRSRSRSR22 CIRRUS DESIGN INCORPORATED4515 Taylor CircleDuluth, MN 55811 FAA APPROVAL HAS BEEN OBTAINED ON THE TECHNICAL DATA IN THIS PUBLICATION THAT AFFECTS AIRPLANE TYPE 1999 CIRRUS DESIGN CORPORATION DULUTH, MINNESOTA, USAP/N 13773-001 ISSUED Nov 2000 REVISION 1 July 200113773-001 AMM-RevLogPage 1 Log of RevisionsRevisionNumberIssue DateDate InsertedInserted ByRevisionNumberIssue DateDate InsertedInserted By30 Nov 200013773-001 AMM-TmpRevLogPage 1 Log of Temporary RevisionsTR NumberIssue DateDate InsertedInserted ByDate RemovedRemoved By30 Nov 200013773-001 AMM-IntroPage 1 INTRODUCTION1.

2 COVERAGEThis Cirrus Design SR22 AIRPLANE MAINTENANCE MANUAL was prepared by Cirrus Design Technical Publica-tions. This MANUAL contains information necessary to enable a trained mechanic to inspect, service, clean, trouble shoot, functionally test, and repair systems and equipment in the Cirrus Design SR22. It also includes information necessary for the mechanic to perform MAINTENANCE or make minor repair to units in the AIRPLANE normally requiring such action on the flight line or in the MAINTENANCE hangar. This MANUAL covers the as delivered AIRPLANE Cirrus Design SR22 AIRPLANE MAINTENANCE MANUAL was prepared using GAMA Specification #2 (Spec-ification for Manufacturers MAINTENANCE data), Revised September 1982 as a content model and format guide.

3 However, as the specification is written to cover a whole class of aircraft rather than a particular model, some deviations from the specification were made for MAINTENANCE MANUAL does not reflect part numbers and cannot be used for ordering replacement parts. Spares and replacement parts should be ordered using the current Cirrus Design SR22 Illustrated Parts schematics within the description and operation sections of this MANUAL are for general information purposes only. Troubleshooting shall be performed using the Wiring MANUAL , and the optional avionics and electrical wiring diagrams provided at USING THE MAINTENANCE MANUALThis MAINTENANCE MANUAL is divided into four major sections, each of which is separated into chapters.

4 Each chapter contains its own list of effective pages and table of Page Numbering SystemPage numbers used in this MAINTENANCE MANUAL consist of two-element numbers separated by dashes, under which the page number and date are the chapter/system element number is followed by zeros in the section/subsystem (32-00) the information presented on the page is applicable to the entire section/subsystem number is used to identify information applicable to section or subsystems within a chapter or system respectively. The subject/ unit element number progresses from the number 10 in accordance with GAMA Specification No.

5 2 and the number of section/subsystem units system/subsystem data is page numbered WARNINGS, CAUTIONS, AND NOTESW arnings, Cautions, and Notes are used to highlight or emphasize important call attention to use of materials, processes, methods, procedures, or limits which must be fol-lowed precisely to avoid bodily call attention to methods and procedures which must be followed to avoid damage to call attention to methods which make the procedure Nov 200013773-001 AMM-IntroPage 230 Nov 20004. LIST OF PUBLICATIONSThe following publications should be used in conjunction with this MANUAL .

6 MANUAL Title - EngineManufactureX30568 AModel IO-550 Overhaul ManualTeleydyne Continental MotorsX30634 AModel IO-550 MAINTENANCE ManualTeleydyne Continental MotorsX30569 AModel IO-550 Parts CatalogTeleydyne Continental MotorsX30565 MAINTENANCE and Operator s ManualTeleydyne Continental MotorsX30592 Starter Service InstructionsTeleydyne Continental MotorsX30593 AFuel Injection Systems Overhaul and Parts CatalogTeleydyne Continental MotorsX40000 TCM Ignition Systems Master Service ManualTeleydyne Continental MotorsManual Title - PropellerManufacture115 NPropeller Owner s MANUAL and Log Book Hartzell202 AStandard Practices ManualHartzellAW-9511-2 The Smooth Propeller.

7 How to Perform a Dynamic Propeller BalanceChadwick Helmuth13841-R2 Chadwick Helmuth Vibrex 2000 Users GuideChadwick HelmuthManual Title - AvionicsManufacture8747 System 55 Autopilot Pilot s Operating HandbookS-TEC Corporation190-00149-01 GMA 340 Audio Panel Installation and Operation ManualGarmin International190-00140-02 GNS 430 - 400 Series Installation MANUAL Garmin International190-00187-02 GTX 327 Transponder Installation and Operation ManualGarmin International572-0555 ICDS 2000 Operations HandbookARNAV SystemsManual Title - MiscellaneousManufacture13772-001 Pilot s Operating HandbookCirrus Design Corporation13774-001SR22 Illustrated Parts CatalogCirrus Design Corporation13773-001 AMM-IntroPage 331 July 20015.

8 REVISIONSThis MANUAL has been prepared in loose-leaf form for ease in inserting revisions. Tabbed dividers, through-out the MANUAL , are in standard GAMA format and numbering and allow quick reference to data in each section. Logical and convenient Tables of Contents are located at the beginning of each chapter to aid in locating specific data within that revisions will be issued periodically. These revisions are printed on white paper and contain a revision instruction sheet to assist the user in filing the change. Upon receipt of a numbered revision, file it according to the provided instructions as soon as possible.

9 Additionally, a record of filing must be made on the following Log of Revisions page. 6. REVISION BARSC hanges to data in an existing section will be identified by a revision bar in the outer margin of the bars are used in figures to indicate TEMPORARY REVISIONST emporary revisions are used to provide time sensitive information and changes as they become available. Temporary revisions provide, with the least possible delay, new information which assists in maintaining safe and efficient flight/ground revisions are incorporated at the next regularly scheduled revision and become a permanent part of the MAINTENANCE receipt of a Temporary Revision, file the revision in the applicable chapter in accordance with filing instructions that appear on the Temporary Revision.

10 Additionally, a record of filing the Temporary Revision must be made in the Log of Temporary Revisions for that AMM chapter. Typically, the Log Of Temporary Revisions for a chapter will be replaced by a blank log when a numbered revision for that chapter is Revisions should be removed from this MANUAL only when removal instructions are noted on the regular revision summary sheet or by instructions noted on a superseding Temporary REVISION SERVICER evision Service for this MANUAL is available from Cirrus Design Technical Publications at the address below:Cirrus Design4515 Taylor CircleDuluth, MN 55811 Phone: 218 727-2737 Fax.