Transcription of Cascadia SAM PIN LAYOUT - DTNA eComponents
1 SAM CAB Ignition Controlled Pins Turned on by FETs depending on ignition switch status, with three types, BAT, ACC, or IGN Logic Controlled Outputs Turned on and off by FETs depending on SAM inputs (from CAN and other input pins), interlocks and parameter settings. Theyare unfused, but will turn off in the case of an over current. Not all are powered pins, some pins are turned on and off to a ground, and are noted by GND. Ground Return Pins Dedicated ground pins connected internally to the SAM GND. Logic Controlled, Relayed, Fused Outputs Fused and controlled by a relay depending on either ignition switch status or by inputs to the control side of all the relays are fused through one fuse on each SAM.
2 Fused Passthoughs Constant BAT power through a fuse SAM Inputs All the inputs, either CAN inputs or sensor feedback. Many of these inputs are chopped signals. Logic Controlled, Fused Output Turned on and off by FETs depending on SAM inputs. Same as logic controlled outputs but fuse protected. SAM Hardware Start of production August 2, CHASSISSTI-498 (05/11)F4(15A)F5(10A)F8(15A)F10(30A)F11( 30A)F12(20A)F13(20A)F2(15A)F26(5A)F25(10 A)F1(30A)F3(30A)F19(20A)F6(15A)F7(15A)F1 5(20A)F16A(3A)F23(15A)F9(20A)F27(10A)F28 (10A)F30(20A)F24( )F31(20A)F21(15A)F35(15A)F34(3A)F17(20A) F36(15A)F39(15A)F40(15A) fromPNDBINTERNAL SAM PC BOARDSAM CAB INPUTSFUSED PASSTHROUGHSLOGIC CONTROLLED, RELAYED, FUSED OUTPUTSGND toMGJBNOTE R9.
3 The SAM switches relay 9 on supplyingpower to fuse 13 when the headlightswitch is on thus turning on the trailertail in emergency power mode, theSAM switches relay 9 on and off, whichswitches the power to fuse 13 on andoff thus flashing the trailer tail : R8R8 is a single throw relay, it will onlyhave 4 prongs. Either pin 87 or pin87a will be missing, depending on theintended functionality of the prong 87a is missing the circuit willbe normally open, the trailer powercircuit is enabled only if the key is inIGN position or enabled through aswitch (depending on SAMparameterization)If prong 87 is missing, the circuit isnormally closed (BAT).
4 If a 5 prong relay is used, the trailerpower will be always R1:This relay has +12v at pin 86 and isgrounded to the SAM CHAS at pin other relays except for SAM CHASR3 are powered through pin 85 andgrounded at pin R3:This relay has +12v at pin 86 and isgrounded to the SAM CHAS at pin other relays except for SAM CHASR1 are powered through pin 85 andgrounded at pin (5A)INTERNAL SAM PC BOARDX57/15 - Fuel Water Separator Heater Element, IGNX53/9 - Trailer Turn Lamp LeftX53/3 - Rear View Camera, IGNX57/1 - Power Feed EAPU/WIF Module, IGNX55/2 - Trailer Marker LampsX54/1 - Trailer ABS Connector (7)
5 , IGNX55/4 - Trailer Stop LampsX55/1 - Trailer Power, BAT or IGNX52/6 - Power Feed ABS/BS, IGNX55/3 - Trailer Tail Lamps Power Feed EAPU (Air Processing Unit), BAT - X57/13 Power Feed 1 ABS/BS, BAT - X52/7 Power Feed 2 ABS/BS, BAT - X52/4X51/3 - Hard wired ISS, ChasX51/1 - SAM_Chas CAN_L - CabinX51/2 - SAM_Chas CAN_H - CabinX53/5 - Trailer ABS Connector (7), ABS DetectionX56/4 - Diff Lock Solenoid Return, FA1 and FA2X56/5 - Diff Lock Feedback Switch Return, FA1X56/6 - Diff Lock Feedback Switch Return, FA2X58/7 - Fuel Level Sensor, FeedbackX59/3 - Backup Switch, ReturnX59/9 - Fuel Water Separator Sensor, FeedbackX59/10 - Temperature Sensor Rear Axle 1, FeedbackX59/13 - Temperature Sensor Rear Axle 2, FeedbackX59/15 - Diff Lock Feedback Switch Return, RA1X59/16 - Diff Lock Solenoid Return, RA1 and RA2X59/18 - Transmission Neutral Switch, ReturnX59/21 - Diff Lock Feedback Switch Return.
6 RA2 FUSEDPASS-THROUGHSLOGIC CONTROLLED OUTPUTSLOGIC CONTROLLED RELAYED, FUSED OUTPUTS308630863086 Note:R8 Note: R9F1 (20A)F3 (20A)F4 (10A)BAT fromPNDBGND : R1 Note: R3 IGNITIONCONTROLLEDOUTPUTSGROUND RETURN PINSSAM CHAS INPUTS87a30858687308586To F14To F14 BATBATN ormallyClosed(BAT power)Normally Open(IGN orSwitch power)863087a8587863087a8587NC Relay -Pin 87missingNO Relay -Pin 87amissingF2 (20A)F5 (20A)F7 (10A)F9 (30A)F11 (30A)F12 (30A)F14 (30A)F6 (15A)F8 (20A)F13 (20A)87a878587a878587a8785 GROUND RETURN PINSLOGIC CONTROLLED OUTPUTSIGNITION CONTROLLED OUTPUTSX2/7 PTO, Hardwired InterlockX8/1 Door Open Switch, Driver Side ReturnX10/3 Belt Buckle Contact SignalX10/6 Vehicle Power Shut Down Signal OIX10/9 Inside Temperature Sensor, FeedbackX10/12 A/C Compressor Clutch RequestX10/15 *Belt Buckle Contacts GNDX11/15 *Rain/Light Sensor, LINX11/17 Top of Clutch, Cruise Control DisableX11/20 Bottom of Clutch.
7 Starter ControlX12/1 Rear Baggage Comp Light Switch CenterX12/2 Rear Baggage Comp Light Switch LeftX12/5 Rear Baggage Comp Light Switch RightX13/2 SAM Cab CAN_L_CABINX13/3 SAM Cab CAN_H_CABINX13/4 *Ignition Switch - OFFX13/5 Ignition Switch - ACCX13/6 Ignition Switch - ON (Ignition)X13/8 Park Brake Switch ReturnX13/10 Low Air Pressure Switch ReturnX13/12 Service Brake Pressure Switch ReturnX13/13 Horn Switch UC BypassX13/14 *Start Enable - Crank InterlockX13/15 Ignition Switch CRANKX17/5 Door Open Passenger Side, ReturnX18/11 Hood Tilt Switch Signal ReturnX19/10 HVAC Pressure Transducer, FeedbackX19/15 Air Filter Restriction Restriction Sensor, ReturnX19/19 *PTO Response (Feedback)
8 X20/16 Temp Sensor Outside Air, FeedbackX20/21 Washer Fluid Lever, FeedbackX21/8 Alternator ChargingX21/9 Wiper ParkedX21/13 LVD Sense, Bat/Emergency SupplyX4/1 Power Feed Spare Output 1, BATX4/2 *Power Feed Spare Output 3, BATX5/1 Power Feed Spare Output 2, BATX5/2 *Power Feed Spare Output 4, BATX1/12 *Heated Seats, IGNX6/15 12V Power Receptacle 1 (Dash, Cigar), BATX6/9 12V Power Receptacle 2 (Dash, Phone), BATX3/15 12V Power Receptacle 3 (Sleeper, Cigar), BATX3/10 *GPS, IGNX6/5 *Power Feed Driver Information System, IGNX6/6 Fleet Management System, IGNX6/8 *Power Feed Gauge Pyrometer, IGNX6/10 Power Feed Gauge Axle Temp, IGNX6/11 Power Feed Gauge Engine Oil Temp, IGNX2/9 Diagnostic Connector, IGNX6/16 Instrument Cluster, IGNX1/1 *Transmission Temp Gauge & Shift Selector, IGNX1/4 *Hands free phone/Dash Splice, IGNX2/14 *Collision Avoidance System, IGNX3/6 *SRS Airbag, IGNX3/9 *Amplifier Power, ACCX8/8 Mirror Heating, DriverX17/2 Mirror Heating PassengerX14/2 12V Power Receptacle 6.
9 BATX14/1 12V Power Receptacle 5, BATX2/15 Area Lighting (Lwr Bunk & Slpr Wrk Srfc), BATX16/17 Baggage Compartment Light Switch supply, BATX16/7 Dome Lamp Cab, BATX3/3 12V Power Receptacle 4 (Sleeper, Cigar), BATX1/13 *Auxiliary Circulation Fan, Sleeper, BATX16/13 Reading Lamp, (Switched Locally) 4, BATX17/1 Power window Pass, ACCX8/7 Power Window Driver, ACCX1/3 Cabin HVAC Controller, BATX1/6 Sleeper HVAC Controller, BATX1/9 Transmission Shift Control Panel, BATX2/12 MSF, BATX2/3 OBD J1939, BATX2/6 OBD DCDI, BATX1/7 *Hands Free Phone, BATX3/11 Radio, BATX7/4 Cabin HVAC Fan Motor, BATX7/3 Sleeper HVAC Fan Motor, BATX8/4 Door Control Driver, BATX2/13 *Collision Avoidance System, BATX8/6 Door Lock, BATC abin HVAC Controller, ACC X1/10 Sleeper HVAC Controller, ACC X1/15 VCU/CPC, IGN X2/4*Advertising Light.
10 ACC X3/4*Body Builder Connector: IGN X9/11 Tire Pressure Monitoring, IGN X10/1 Mirror Adjust Switch, ACC X10/2 Service Brake Pressure Switch, Supply X10/7 Pwr Feed Slpr Thermostat OI, IGN X10/10 Radio, ACC X10/18*Rain/Light Sensor, BAT X11/21 Rear Baggage Compartment Lights X12/12 Ignition Switch - BAT X13/7 Park Brake Switch Supply X13/9 Low Air Pressure Switch Supply X13/11*Lane Guidance, IGN X16/2*Auxiliary Circulation Fan-Windshield, ACC X16/5*Air Intake Warmer/Grid Heater, IGN X19/11 Air Filter Restriction Restriction Sensor, Supply X19/13 HVAC Pressure Transducer.