Example: stock market

Charger Owner's Manual Models: For 6 and 12 Volt …

1 GENERAL BATTERY you use your battery Charger , be sure to read allinstructions and cautions printed on: Battery Charger Battery Vehicle or unit using battery Charger on LEAD ACID type rechargeable batter-ies only, such as used in autos, trucks, tractors, airplanes,vans, RV's trolling motors, etc. Charger is not intended to sup-ply power to low-voltage electrical system other than in anautomotive : Do not use battery Charger for charging dry-cellbatteries that are commonly used with home batteries may burst and cause injury to persons anddamage to only attachments recommended or sold by of non-recommended attachments may result in fire, elec-tric shock, or disconnecting the battery Charger , pull by the plug notby the cord.

2 PERSONAL PRECAUTIONS AND SAFETY 1. Make sure you have either a 12 volt or a 6 volt lead-acid battery and select battery charger switch accordingly.

Tags:

  Manual, Model, Owner, Volt, Charger, Charger owner s manual models, For 6 and 12 volt, 12 volt, 6 volt

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of Charger Owner's Manual Models: For 6 and 12 Volt …

1 1 GENERAL BATTERY you use your battery Charger , be sure to read allinstructions and cautions printed on: Battery Charger Battery Vehicle or unit using battery Charger on LEAD ACID type rechargeable batter-ies only, such as used in autos, trucks, tractors, airplanes,vans, RV's trolling motors, etc. Charger is not intended to sup-ply power to low-voltage electrical system other than in anautomotive : Do not use battery Charger for charging dry-cellbatteries that are commonly used with home batteries may burst and cause injury to persons anddamage to only attachments recommended or sold by of non-recommended attachments may result in fire, elec-tric shock, or disconnecting the battery Charger , pull by the plug notby the cord.

2 Pulling on the cord may cause damage to cord battery power cord so it cannot be stepped on, trippedover, or subjected to damage or not operate Charger with damaged cord or plug. Have cordreplaced not operate Charger if it has received a sharp blow, beendropped, or otherwise damaged in any way. Take it to a quali-fied professional for inspection and not disassemble Charger . Take it to a qualified professionalwhen service or repair is required. Incorrect reassembly mayresult in electric shock or reduce risk of electric shock, unplug Charger from outletbefore attempting any maintenance or Do not use an extension cord unless absolutely neces-sary.

3 Use of an improper extension cord could result in fireor electric shock. If an extension cord must be used, makesure that: Pins on plug of extension cord are the same number, size,and shape as those of plug on Charger . Extension cord is properly wired and in good electrical con-dition. Wire size is large enough for AC ampere rating of Charger ,as specified below:_____Length of cord (feet): 2550 100 150 AWG size of cord:1818 1816_____11. Always charge battery in a well ventilated operate in a closed-in or restricted area without ad-equate : Risk of explosive Locate Charger as far away from battery as DC Charger Do not expose Charger to rain or charge a frozen battery.

4 If battery fluid (electrolyte) isfrozen, bring into a warm area to thaw before allow battery acid to drip on Charger when readingspecific gravity or filling set a battery on top of place Charger directly above battery being from battery will corrode and damage touch the battery clips together when the Charger crank engine with Charger attached to Rules for Safe Operation and Instructions CarefullyWorking in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normalbattery operation. For this reason, it is of utmost importance that each time before using your Charger , youread this Manual and follow the instructions 's Manual Save Important Safety InstructionsWARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a chemicalknown to the State of California to cause cancer and birth defects or other reproductive harm.

5 Wash hands after :SE-82-6 & SE-30026 and 2 AmpBattery ChargerFor 6 and 12 volt BatteriesSCHUMACHER ELECTRIC CORPORATION801 BUSINESS CENTER DRIVE MOUNT PROSPECT, ILLINOIS 60056-2179 Send Warranty Product Repairs to: 1025 E. Thompson, Hoopeston, IL 60942-0280 Call Customer Service if you have questions: 1-800-621-548500-00-000531/01032 PERSONAL PRECAUTIONS AND sure you have either a 12 volt or a 6 volt lead-acidbattery and select battery Charger switch battery terminals. Take care to keep corrosion fromcoming in contact with your required, add distilled water in each cell until battery acidreaches levels specified by battery manufacturer.

6 This helpspurge excessive gas from cells. Do not overfill. For a bat-tery without cell caps, carefully follow manufacturer's re-charging all battery manufacturer's specific precautions, suchas removing or not removing cell caps while charging, andrecommended rates of sure area around battery is well ventilated while batteryis being charged. Gas can be forcefully blown away byusing a piece of cardboard or other non-metallic materialas a necessary to remove battery from vehicle to charge, al-ways remove grounded terminal from battery first. Makesure all accessories in the vehicle are off, so as not tocause an marine (boat) battery must be removed and charged onshore.

7 To charge it on board requires equipment speciallydesigned for marine the proper charge rate and voltage setting. SeeFigure 2 BATTERY Charger SELECTION Charge Time:RecommendedRateHoursUses2 AMP3-8 MOTORCYCLES,12 VOLTSNOWMOBILES, LAWNMOWERS,ONLYOR MAINTAIN CHARGE IN AUTO,TRUCK, RV'S6 AMP6-8 TROLLING MOTORS,6 ORRECREATIONAL VEHICLES12 VOLTAUTOMOBILES, TRUCKS, VANSFIGURE 2 BATTERY Charger SELECTION : Wear complete eye protection and clothingprotection, when working with lead-acid sure someone is within range of your voice or closeenough to come to your aid when you work with or near alead-acid plenty of fresh water and soap nearby for use if batteryacid contacts skin, clothing, or eyes.

8 If battery acid contactsskin or clothing, wash immediately with soap and touching your eyes while working with a battery. Acidparticles (corrosion) may get into your eyes! If acid entersyour eye, immediately flood eye with running cold water forat least 10 minutes. Get medical attention all personal metal items such as rings, bracelets,necklaces, and watches when working with a lead-acidbattery. A lead-acid battery can produce a short-circuit currenthigh enough to weld a ring (or the like) to metal, causing asevere care not to drop a metal tool or other metal onto thebattery. Metal may cause sparking or short circuit the batteryor another electrical devise.

9 Sparking may cause operate battery Charger in an open well smoke or allow a spark or flame in the vicinity of thebattery or engine. Batteries generate explosive gases!PREPARING TO CHARGENOTE: The temporary adapter should be used only until a properly grounded outlet can be installed by a qualified : NEVER alter the AC cord or plug provided. If it will not fit outlet, have proper outlet installed by a qualified connection can result in a risk of an electric shock. DANGER: Before using an adaptor as illustrated, be certain that centerscrew of outlet plate is grounded. The green-colored rigid ear or lug extending from adaptor must be connected to a properly groundedoutlet.

10 Make certain it is grounded. If necessary, replace original outlet cover plate screw with a longer screw that will secure adapter earor lug to outlet cover plate and make ground connection to grounded AND AC POWER CORD CONNECTIONSC harger should be grounded to reduce risk of electric is equipped with an electric cord having an equip-ment-grounding conductor and a grounding plug. The plug mustbe plugged into an outlet that is properly installed and groundedin accordance with all local codes and battery Charger is designed for use on a nominal 120- volt circuit and has a grounded plug that looks like the plugillustrated FIGURE 1 (A).


Related search queries