Example: quiz answers

Cisco 110 Series Unmanaged Switches Quick Start Guide

Quick Start GuideCisco 110 Series Unmanaged Switches2 110 Series Unmanaged Switches Unbox239954110 Series Unmanaged Switches 3 Rack-mount (Optional) - Size 14 110 Series Unmanaged Switches

110 Series Unmanaged Switches 5 Rack-mounting SG110-24 and SG110-24HP. 6 110 Series Unmanaged Switches ... Reduced Air Flow - Installation of the equipment in the rack should be such that the amount of air

Tags:

  Cisco, Flows, Switches

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of Cisco 110 Series Unmanaged Switches Quick Start Guide

1 Quick Start GuideCisco 110 Series Unmanaged Switches2 110 Series Unmanaged Switches Unbox239954110 Series Unmanaged Switches 3 Rack-mount (Optional) - Size 14 110 Series Unmanaged Switches Rack-mount (Optional)

2 - Size 2110 Series Unmanaged Switches 5 Rack-mounting SG110-24 and SG110-24HP6 110 Series Unmanaged Switches Rack-mounting SG112-24110 Series Unmanaged Switches 7 Safety Instructions for Rack MountingSafety Instructions - Rack MountThe following or similar rack-mount instructions are included with the installation ) Elevated Operating Ambient - If installed in a closed or multi-rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient.

3 Therefore, consideration should be given to installing the equipment in an environment compatible with the maximum ambient temperature (Tma) specified by the ) Reduced Air Flow - Installation of the equipment in the rack should be such that the amount of air flow required for safe operation of the equipment is not ) Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical ) Circuit Overloading - Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of the circuits might have on overcurrent protection and supply wiring.

4 Appropriate consideration of equipment nameplate ratings should be used when addressing these ) Reliable Earthing - Reliable Earthing of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other than direct connections to the branch current ( use of power strips). 8 110 Series Unmanaged Switches Wall-mount (Optional)

5 , in/43 mmSF110D-08/08HP/16/16HP, SG110D-08 in/63 mmSF110-16/24, SG110-16 in/94 mm110 Series Unmanaged Switches 9 Wall-mount if needed (continued)SF110D-05/08, SG110D-05, SF110D-16/16HP1= mm2= in/15 mm3= mm4= mmSF110D-08HP, SG110D-08/08HP1= mm2= mm3= mm4= mmSF110-16/24, SG110-16/16HP 1= in/8 mm2= mm3= mm4= mm124310 110 Series Unmanaged Switches Wall Mount - Placement OptionsTo install the switch.

6 Either set it on its four rubber pads and place it on a flat surface, or mount it on a wall using the wall-mount slots on the bottom panel of the use the wall mount option, follow these steps: Step 1 : Attach two screws to the wall such that the wall-mount slots of the switch lineup with the two - The screws should be in (43 mm) - The screws should be in ( mm) - The screws should be in ( mm) wall-mount slots are two criss-cross slots on the bottom panel of the 2: Maneuver the switch to insert the screws into the two wall-mount Series Unmanaged Switches 11 Power On Switch23995712 110 Series Unmanaged Switches

7 Attach Devices239958110 Series Unmanaged Switches 13 Ambient Temperature RatingsSwitch ModelTemperature RangeSF110D-0532o to 122o F (0o to 50o C) SF110D-0832o to 122o F (0o to 50o C) SF110D-08HP32o to 122o F (0o to 50o C) SF110-1632o to 122o F (0o to 50o C) SF110D-1632o to 122o F (0o to 50o C) SF110D-16HP32o to 122o F (0o to 50o C)SF110-2432o to 122o F (0o to 50o C) SF112-2432o to 122o F (0o to 50o C)SG110D-0532o to 122o F (0o to 50o C) SG110D-0832o to 122o F (0o to 50o C)SG110D-08HP32o to 122o F (0o to 50o C) SG110-1632o to 122o F (0o to 50o C) SG110-16HP32o to 122o F (0o to 50o C) 14 110 Series Unmanaged Switches SG110-2432o to 122o F (0o to 50o C)

8 SG110-24HP32o to 113o F (0o to 45o C)SG112-2432o to 122o F (0o to 50o C) Switch ModelTe m p e r a t u r e R a n g e110 Series Unmanaged Switches 15110 Series Unmanaged , Compliance, and Safety on the Resources tab, and scroll down to Technical User License lot 26 related test HeadquartersCisco Systems, West Tasman DriveSan Jose, CA US: 1-866-606-1866 Support, Global: and the Cisco Logo are trademarks of Cisco Systems, Inc.

9 And/or its affiliates in the and other countries. Alisting of Cisco 's trademarks can be found at Third party trademarks mentioned arethe property of their respective owners. The use of the word partner does not imply a partnership relationship betweenCisco and any other company. (1005R) 2014 Cisco Systems, Inc. All rights reserved. 78-100337-01B0


Related search queries