Transcription of COAXIAL CABLES: RG-58/U RG-140/U GASKET RG-141/U NUT
1 COAXIAL CABLES: RG-58/U . RG-140/U GASKET . RG-141/U CLAMP. WASHER CONTACT SHELL. cable . NUT. FIG 1. CLAMP LOCATED..28 UNDER BRAID .09 .09 FIG 2 FIG 4..13 CUT cable END SQUARE. SLIDE NUT, SLIDE CLAMP OVER THE BRAID SO THAT ITS INNER. WASHER, AND GASKET OVER cable . SHOULDER BOTTOMS OUT AGAINST THE END OF THE. CUT JACKET TO DIMENSION SHOWN JACKET. FOLD BACK BRAID WIRES OVER CLAMP. CUT. AND REMOVE. BRAID FLUSH WITH THE LARGER END OF CLAMP AS SHOWN. CUT DIELECTRIC TO .13 LEAVING AN EXPOSED CONDUCTOR. LENGTH OF .09. 60-40 TIN LEAD SOLDER THE EXPOSED. CONDUCTOR. -DO NOT OVERHEAT- SOLDER HERE.
2 FIG 3 FIG 5. SLIDE CONTACT OVER CONDUCTOR AND SOLDER IN. COMB OUT BRAID AND TAPER TOWARD PLACE USING 60-40 TIN LEAD SOLDER. REMOVE EXCESS. CONDUCTOR. SOLDER FROM OUTSIDE OF CONTACT. DO NOT OVERHEAT. THE DIELECTRIC AS SWELLING MAY PREVENT cable . ASSEMBLY FROM INSERTING INTO SHELL. INSTRUCTION SHEET. PROPRIETARY AND CONFIDENTIAL THIRD ANGLE PROJECTION TITLE: THE INFORMATION CONTAINED IN THIS DRAWING IS THE. BNC PLUG ASSEMBLY. SOLE PROPERTY OF SOLID SEALING TECHNOLOGY. ANY. REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN. PERMISSION OF SOLID SEALING TECHNOLOGY IS PROHIBITED.
3 NUMBER: REV: NS10551 A. REV. APP'D DATE SCALE 1 DRAWN JS 10/01/2008. DIMENSIONS IN. A MH 10/20/2008 NS10551-11 INCHES [mm] ENG APPR. MH 10/20/2008 SHEET 1 OF 2. FIG 6. SLIDE SHELL OVER cable ASSEMBLY AND PUSH cable ASSEMBLY. INTO SHELL AS FAR AS IT WILL GO. FIG 7. SLIDE NUT INTO SHELL AND SCREW IN PLACE WITH WRENCH UNTIL. TIGHT. MAKE SURE TO HOLD cable AND SHELL RIGID WHILE ROTATING NUT. INSTRUCTION SHEET. PROPRIETARY AND CONFIDENTIAL THIRD ANGLE PROJECTION TITLE: THE INFORMATION CONTAINED IN THIS DRAWING IS THE. BNC PLUG ASSEMBLY. SOLE PROPERTY OF SOLID SEALING TECHNOLOGY.
4 ANY. REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN. PERMISSION OF SOLID SEALING TECHNOLOGY IS PROHIBITED. NUMBER: REV: NS10551 A. REV. APP'D DATE SCALE 1 DRAWN JS 10/01/2008. DIMENSIONS IN. A MH 10/20/2008 NS10551-15 INCHES [mm] ENG APPR. MH 10/20/2008 SHEET 2 OF 2.
