Customer User Guide - PLDT HOME
1. Turn the modem off for 5 minutes and then back on to refresh your connection 2. Wait for the modem to sync within 3 minutes ... //192.168.1.1 then press enter. ... Type the default username: admin, password: 1234 to log in. 3. Click "Setup" found on the upper-hand side of the page. 4. Choose "Basic" from the left-hand side to change your Wi ...
Tags:
Information
Domain:
Source:
Link to this page:
Related documents
Wired Modem Wireless Modem Customer Owned Modem
walledgarden.wowway.comIn your browser, type 192.168.0.1 — this is the device administration page address. If the model number on the front of your wireless modem is an Arris DG2470, DG3270, or TG2472: A. Log in using the Username: admin and the Password: password (case-sensitive).
IP Power 9258S / 9258T 9258S+Ping / 9258T + Ping ... - …
www.aviosys.com(E.g. If IP address is 192.168.1.100 , then another IP address 192.168.1.123 then these IP Addresses are in same subnet.) 5 .The default username and password of IP Power 9258 are: Username: admin Password: 12345678
User Guide
d15yx0mnc9teae.cloudfront.net(Router login Password): Install your Wireless Router NOTE: If there is an Ethernet cable currently connecting your modem to another device, disconnect the Ethernet cable from the device before you install the router. 1. Unplug your modem. 2. Plug your modem back in. Wait approximately 2 minutes until your modem turns on. 3.
User Manual
www.motorolacable.commodem. Here is a list of phone numbers for some major cable service providers. (Note that this list is subject to change.) Comcast 1 (855) 652-3446 Time Warner 1 (855) 704 4503 Bright House 1 (888) 289-8988 Suddenlink 1 (877) 794-2724 Cable One 1 (877) 692 2253 Cox 1 (888) 556-1193 RCN 1 (866) 832-4726
CGNVM DOCSIS 3.0 eMTA WiFi Gateway User’s Guide
mediacomcc.custhelp.comCGNVM DOCSIS 3.0 eMTA WiFi Gateway User’s Guide. Version 1.0 - 02/2015 SW Version CGNVM_4.5.10.10T3-MGCP-150429
Cisco RV340 Quick Start Guide
www.cisco.comSTEP 1 Open a command window by using Start > Run and enter cmd. STEP 2 At the Command window prompt, enter ping and the device IP address. For example, ping 192.168.1.1 (the default static IP address of the device). If you can reach the device, you should get a reply similar to the following: Pinging 192.168.1.1 with 32 bytes of data: Reply ...
User’s Guide - Midco
www.midco.comLAN1 Use these ports to connect your computers and other network devices, using Category 5 or 6 Ethernet cables with RJ45 connectors. LAN2 LAN3
Wi-Fi CellSpot Router TM-AC1900 Dual Band Router
www.t-mobile.com1 English Package contents TM-AC1900 AC adapter Network cable (RJ-45) A quick look at your Wi-Fi CellSpot Router 1) LAN 1~4 LED 6) Power LED 11) USB 3.0/2.0 ports