1 TB 091015 Rev. 0. Page 1 of 3. E-CLIP INSTALLATION and REMOVAL . (RTS System Applications). The INSTALLATION of the E- clips is as follows. Place one of the E- clips on top of the barrier at each hinge joint. After the clips are on the barrier, another person can then insert the clips into the tool. See picture below. The tool is used to hold the E- clips during the INSTALLATION . Align the E-CLIP in the grove on the bottom of hinge pin and tap the end of the tool with your hand. The tool can now be pulled away leaving the E-CLIP attached to the hinge pin. With your hand spin the clip to insure that they are seated properly.
2 10/15/09. TB 091015-Rev. 0. Page 2 of 3. The picture below shows the final placement of the E clip installed on the pin. NOTE: Ensure that the E-CLIP is seated in grove properly or the pin will work its way out. 10/15/09. TB 091015-Rev. 0. Page 3 of 3. REMOVAL . Turn center of E-CLIP toward the side of the barrier. Using standard pliers grab center of E-CLIP firmly and pull clip from pin. NOTE. The E- clips are reusable, store in a dry location. 10/15/09.