EN 301 908-13 - V11.1.2 - IMT cellular networks ...

1 ETSI EN 301 908-13 (2017-07). HARMONISED EUROPEAN STANDARD. IMT cellular networks ;. Harmonised Standard covering the essential requirements of article of Directive 2014/53/EU;. Part 13: Evolved Universal Terrestrial Radio Access (E-UTRA). User Equipment (UE). 2 ETSI EN 301 908-13 (2017-07). Reference REN/MSG-TFES-11-13-RED-C1. Keywords 3G, 3 GPP, cellular , digital, E-UTRA, IMT, LTE, LTE-Advanced, mobile, radio, regulation, UMTS. ETSI. 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE. Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16. Siret N 348 623 562 00017 - NAF 742 C. Association but non lucratif enregistr e la Sous-Pr fecture de Grasse (06) N 7803/88. Important notice The present document can be downloaded from: The present document may be made available in electronic versions and/or in print.

2 The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at If you find errors in the present document, please send your comment to one of the following services: Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI.

3 The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media. ETSI 2017. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTM and the ETSI logo are trademarks of ETSI registered for the benefit of its Members. 3 GPPTM and LTE are trademarks of ETSI registered for the benefit of its Members and of the 3 GPP Organizational Partners. oneM2M logo is protected for the benefit of its Members GSM and the GSM logo are trademarks registered and owned by the GSM Association. ETSI. 3 ETSI EN 301 908-13 (2017-07). Contents Intellectual Property Rights ..8. Modal verbs Introduction ..9.

4 1 Scope ..10. 2 References ..12. Normative references .. 12. Informative references .. 13. 3 Definitions, symbols and abbreviations ..14. Definitions .. 14. Symbols .. 16. Abbreviations .. 18. 4 Technical requirements specifications ..19. Environmental 19. Conformance requirements .. 19. 19. 20. Transmitter Maximum Output Power .. 20. Transmitter maximum output power for Single Carrier .. 20. 20. Limits .. 21. Conformance .. 21. Transmitter output power for intra-band contiguous Carrier Aggregation (DL CA and UL CA).. 21. 21. Limits .. 22. Conformance .. 22. Transmitter output power for UL-MIMO .. 22. 22. Limits .. 23. Conformance .. 23. Transmitter Spectrum Emission Mask .. 23. Transmitter spectrum emission mask for Single Carrier.

5 23. 23. Limits .. 23. Conformance .. 25. Transmitter spectrum emission mask for intra-band contiguous Carrier Aggregation (DL CA and UL CA) .. 25. 25. Limits .. 25. Conformance .. 26. Transmitter spectrum emission mask for UL-MIMO .. 26. 26. Limits .. 26. Conformance .. 26. Transmitter spectrum emission mask for Multi-Cluster PUSCH within a component carrier .. 26. 26. Limits .. 27. Conformance .. 27. Transmitter Spurious Emissions .. 27. Transmitter spurious emissions for Single Carrier .. 27. 27. Limits .. 27. Conformance .. 30. ETSI. 4 ETSI EN 301 908-13 (2017-07). Transmitter spurious emissions for intra-band contiguous Carrier Aggregation (DL CA and UL. CA) .. 30. 30. Limits.

6 30. Conformance .. 32. Transmitter spurious emissions for UL-MIMO .. 33. 33. Limits .. 33. Conformance .. 33. Transmitter spurious emissions for Multi-Cluster PUSCH within a component carrier .. 33. 33. Limits .. 33. Conformance .. 33. Transmitter Minimum Output Power .. 33. Transmitter minimum output power for Single 33. 33. Limits .. 34. Conformance .. 34. Transmitter minimum output power for intra-band contiguous Carrier Aggregation (DL CA and UL CA) .. 34. 34. Limits .. 34. Conformance .. 34. Transmitter minimum output power for UL-MIMO .. 34. 34. Limits .. 35. Conformance .. 35. Receiver Adjacent Channel Selectivity (ACS) .. 35. Receiver Adjacent Channel Selectivity (ACS) for Single Carrier.

7 35. 35. Limits .. 35. Conformance .. 36. Receiver Adjacent Channel Selectivity (ACS) for Carrier Aggregation in DL-only bands .. 36. 36. Limits .. 36. Conformance .. 36. Receiver Blocking Characteristics .. 36. Receiver Blocking Characteristics for Single Carrier .. 36. 36. Limits .. 37. Conformance .. 38. Receiver Blocking Characteristics for Carrier Aggregation in DL-only 38. 38. Limits .. 39. Conformance .. 40. Receiver Spurious Response .. 40. Receiver Spurious Response for Single Carrier .. 40. 40. Limits .. 40. Conformance .. 41. Receiver Spurious Response for Carrier Aggregation in DL-only bands .. 41. 41. Limits .. 41. Conformance .. 41. Receiver Intermodulation Characteristics.

8 41. Receiver Intermodulation Characteristics for Single Carrier .. 41. 41. Limits .. 41. Conformance .. 42. Receiver Intermodulation Characteristics for Carrier Aggregation in DL-only 42. 42. Limits .. 42. ETSI. 5 ETSI EN 301 908-13 (2017-07). Conformance .. 42. Receiver Spurious Emissions .. 42. Receiver Spurious Emissions for Single Carrier .. 42. 42. Limits .. 43. Conformance .. 43. Receiver Spurious Emissions in DL-only bands .. 43. 43. Limits .. 43. Conformance .. 43. Transmitter Adjacent Channel Leakage Power Ratio .. 43. Transmitter adjacent channel leakage power ratio for Single Carrier .. 43. 43. Limits .. 44. Conformance .. 44. Transmitter adjacent channel leakage power ratio for intra-band contiguous Carrier Aggregation (DL CA and UL CA).

9 45. 45. Limits .. 45. Conformance .. 46. Transmitter adjacent channel leakage power ratio for UL-MIMO .. 46. 46. Limits .. 46. Conformance .. 47. Transmitter adjacent channel leakage power ratio for Multi-Cluster PUSCH within a component carrier .. 47. 47. Limits .. 47. Conformance .. 47. Receiver Reference Sensitivity Level .. 48. General .. 48. Receiver Reference Sensitivity Level for Single Carrier .. 48. 48. Limits .. 48. Conformance .. 48. 5 Testing for compliance with technical Environmental conditions for testing .. 49. Interpretation of the measurement results .. 49. Essential radio test suites .. 50. 50. Transmitter Maximum Output Power .. 50. Transmitter maximum output power for Single Carrier.

10 50. Method of test .. 50. Test requirements .. 51. Transmitter maximum output power for intra-band contiguous Carrier Aggregation (DL CA and UL CA) .. 51. Method of test .. 51. Test requirements .. 52. Transmitter maximum output power for UL-MIMO .. 52. Method of test .. 52. Test requirements .. 52. Transmitter Spectrum Emission Mask .. 53. Transmitter spectrum emission mask for Single Carrier .. 53. Method of test .. 53. Test requirements .. 53. Transmitter spectrum emission mask for intra-band contiguous Carrier Aggregation (DL CA and UL CA) .. 54. Method of test .. 54. Test requirements .. 54. Transmitter spectrum emission mask for UL-MIMO .. 55. Method of test .. 55. ETSI. 6 ETSI EN 301 908-13 (2017-07).