EN 303 413 - V1.1.1 - Satellite Earth Stations and Systems ...

1 ETSI EN 303 413 (2017-06) Satellite Earth Stations and Systems (SES); global navigation Satellite system (GNSS) receivers; Radio equipment operating in the 1 164 MHz to 1 300 MHz and 1 559 MHz to 1 610 MHz frequency bands; Harmonised Standard covering the essential requirements of article of Directive 2014/53/EU HARMONISED EUROPEAN STANDARD ETSI ETSI EN 303 413 (2017-06) 2 Reference DEN/SES-00404 Keywords GNSS, harmonised standard, navigation , receiver, Satellite ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistr e la Sous-Pr fecture de Grasse (06) N 7803/88 Important notice The present document can be downloaded from: The present document may be made available in electronic versions and/or in print.

2 The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at If you find errors in the present document, please send your comment to one of the following services: Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI.

3 The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media. ETSI 2017. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTM and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3 GPPTM and LTE are Trade Marks of ETSI registered for the benefit of its Members and of the 3 GPP Organizational Partners. oneM2M logo is protected for the benefit of its Members GSM and the GSM logo are Trade Marks registered and owned by the GSM Association. ETSI ETSI EN 303 413 (2017-06) 3 Contents Intellectual Property Rights .. 5 Foreword .. 5 Modal verbs terminology.

4 5 Executive summary .. 5 Introduction .. 6 1 Scope .. 7 2 References .. 7 Normative references .. 7 Informative references .. 7 3 Definitions and abbreviations .. 9 Definitions .. 9 Abbreviations .. 9 4 Technical requirements specifications .. 10 Environmental profile .. 10 Conformance specifications .. 10 GUE adjacent frequency band selectivity performance .. 10 Definition .. 10 Specifications.

5 10 Conformance .. 11 Spurious emissions .. 12 Definition .. 12 Limit .. 12 Conformance .. 12 5 Testing for conformance with technical requirements .. 12 Environmental conditions for testing .. 12 Interpretation of the measurement results .. 13 Test methodology for adjacent frequency band selectivity test .. 13 General .. 13 Test setup for conducted measurements .. 13 Test equipment .. 13 EUT configuration .. 13 Test setup for radiated measurements.

6 14 General .. 14 Test equipment .. 14 EUT configuration .. 14 GUE adjacent frequency band selectivity test .. 15 General .. 15 Test conditions .. 15 Test method for GUE utilizing the 1 559 MHz to 1 610 MHz RNSS band .. 15 Test method for GUE utilizing the 1 164 MHz to 1 300 MHz RNSS bands .. 16 Receiver spurious emissions test .. 16 Test conditions .. 16 Test method .. 16 Conducted measurement.

7 16 Introduction .. 16 Pre-scan .. 17 Measurement of the emissions identified during the pre-scan .. 18 Radiated measurement .. 18 Annex A (informative): Relationship between the present document and the essential requirements of Directive 2014/53/EU .. 19 ETSI ETSI EN 303 413 (2017-06) 4 Annex B (normative): Details of parameters used in technical requirements specifications (clause 4) .. 20 Adjacent frequency signal .. 20 Definition .. 20 Recommended measurement technique for the adjacent frequency signal settings .. 21 GNSS signals.

8 21 Definition .. 21 GNSS signal details .. 21 GNSS Satellite details .. 22 Annex C (informative): C/N0 degradation 23 General .. 23 Definition .. 23 Example calculation of nominal 1 dB degradation of C/N0 .. 23 Annex D (informative): Test Report Application Form for ETSI EN 303 413 .. 25 The right to copy .. 25 General .. 25 Information as required by clause and clause .. 25 Information as required by clause .. 27 Annex E (informative): Bibliography .. 28 Annex F (informative): Change history .. 29 History .. 30 ETSI ETSI EN 303 413 (2017-06) 5 Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI.

9 The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server ( ). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Harmonised European Standard (EN) has been produced by ETSI Technical Committee Satellite Earth Stations and Systems (SES).

10 The present document has been prepared under the Commission's standardisation request C(2015) 5376 final [ ] to provide one voluntary means of conforming to the essential requirements of Directive 2014/53/EU on the harmonisation of the laws of the Member States relating to the making available on the market of radio equipment and repealing Directive 1999/5/EC [ ]. Once the present document is cited in the Official Journal of the European Union under that Directive, compliance with the normative clauses of the present document given in table A-1 confers, within the limits of the scope of the present document, a presumption of conformity with the corresponding essential requirements of that Directive and associated EFTA regulations.