Envirodye Blue Label - SST Australia

1 Envirodye blue LIQUID MARKING DYE Active Constituent: 90 g/l Sulphonated aromatic acid dye A COLOURANT FOR TURF AND A MARKER FOR USE WITH PESTICIDES AND MARKING FOAM 5 LITRES SST PRODUCTS 4/97 Bayfield Road East, Bayswater, Victoria 3153 ph : (03) 9720 6306 DIRECTIONS FOR USE Situation Application Critical comments Rate Broadacre Spray marking 100mL/100 Litres Suitable for use with pesticide spray solutions to enable clear identification of sprayed areas.

2 Back packs 10mL/10 Litres Foam Markers 25 - 50 mL Higher rate for deep blue foam colour. per 100 Litres Add direct to diluted foam marking solution. TURF Boom application to parks, 600 - 1000 mL For uniform appearance to green surfaces. ovals and fairways. per Hectare For greens 6 - 10 ml Use higher rate for a deep rich turf colour. per 100 sq. Mtr. For back packs and hand applicators. 30 ml per 5 Litre NOT TO BE USED FOR ANY PURPOSE OTHER THAN INDICATED ON THIS Label UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION.

3 GENERAL INSTRUCTIONS Add rinsings to spray tank or knapsack mix. A blue liquid marking dye to assist in clearer identification Do not dispose of undiluted chemicals on-site. of sprayed areas. A simple and cost effective system in all Break, crush, puncture and bury empty containers in spraying situations to reduce costly problems resulting a local authority landfill. If not available bury the from overapplication or missed areas untreated. When containers below 500mm in a disposal pit specifically used as a colouring agent with white foam markers, foam marked and set up for this purpose clear of waterways, will become blue in colour to allow clearer identification.

4 Vegetation and roots. Empty containers and product Application of SST Envirodye to turf, greens and fairways should not be burnt. imparts a deep rich colour to green surfaces and provides SAFETY DIRECTIONS a uniform appearance. Do not swallow. Avoid contact with skin or eyes. Wear MIXING INSTRUCTIONS rubber gloves, overalls and goggles or face shield. To achieve thorough mixing premix SST Envirodye with Wash hands with soap and water after use. water in ratio 1:10 before addition to spraytank or FIRST AID knapsack.

5 Add premix solution to spraytank first and If poisoning occurs contact a doctor or Poisons follow with water to half fill tank. Add other ingredients Information Centre (Ph 13 11 26). If in eyes, hold under agitation followed by water to top up tank. Wash eyes open and flood with water for at least 15 minutes out all spraying equipment thoroughly after use as product and see a doctor. Additional information is listed in the residue can cause discolouration of subsequent sprays. Material Safety Data Sheet. PROTECTION OF WILDLIFE, FISH, CRUSTACEANS CONDITIONS OF SALE AND ENVIRONMENT The use of SST Envirodye being beyond the control DO NOT contaminate streams, rivers or waterways with of the manufacturer, no warranty expressed or implied the chemical or used container.

6 Is given by SST Australia Pty Ltd regarding its suitability STORAGE AND DISPOSAL fitness or efficiency for any purpose for which it is Keep out of reach of children. used by the buyer, whether in accordance with the Store in closed, original container in a well ventilated directions or not and SST Australia Pty Ltd accepts area, as cool as possible. Triple or, preferably pressure no responsibility for any consequences whatsoever rinse containers before disposal. resulting from the use of this product.

7 NRA Approval No.: 50424/0998 Batch No. In an Emergency Date of Dial 000 Manufacture Police or Fire Brigade SST Australia Pty Ltd 4/97 Bayfield Road East, Bayswater, Victoria 3153 ph : +61 3 9720 6306