FORM VII - peso.gov.in

1 FORM VII Application for the issue of a licence to transport petroleum Class A and Class B in bulk on land by mechanically propelled vehicles Documents listed overleaf must be submitted with this application Part A - To be filled in and signed by the applicant. 1. Applicant's name and full postal address _____ 2. Particulars of the vehicle in which petroleum is proposed to be transported i. Make and Model ii. Engine number iii. Chassis number iv. Registered number v.

2 Date up to which the vehicle is registered owner vi. Name and full postal address of the registered vii. Number of compartments and certified capacity in kilolitres of each compartment : viii. Class or classes of petroleum proposed to be transported in the vehicle described above. ix. Number and date of approval of the design drawing of the vehicle by the Chief Controller of Explosives _____ _____ _____ _____ _____ _____ _____ _____ _____ _____ Compartment No 1 2 3 4 5 6 7 .. Total capacity in kilolitres Capacity in Kilolitre 3.

3 Does the tank vehicle described above fully conform to the requirements laid down in Third Schedule to the petroleum Rules, 1976, and the design drawing approved by the Chief Controller _____ of Explosives 4. Full postal address of the place where the vehicle will be normally stationed. _____ I /We declare that the particulars given above have been checked up by me/us and found correct. 1/We undertake to transport petroleum in the tank vehicle/trailer, particulars of which are given above, in accordance with the provisions of the petroleum Act 1934, and the rules framed there under and any other law or rule for the said Act and the rules framed.

4 There under is punishable for the first offence with simple imprisonment which may extend to one month or with fine which may extend to one thousand rupees or with both and for every subsequent offence with simple imprisonment which may extend to three months or with fine which may extend to five thousand rupees or with both. Date_____ _____ Place_____ Signature of the applicant Part B - To be filled in and signed by the recognized engineer.

5 I certify that the tank vehicle/trailer, the particulars of which are given in part A of this form has been examined and tested by me and found to be fully conforming to particulars shown in approved drawing No date complying with the requirements laid down in the Third Schedule to the petroleum Rules, 1976. Name Recognized qualification Place_____ Date _____ Full postal address _____ Signature Documents required to be submitted with this Application: 1.

6 Two copies of drawing approved under sub-rule (3) of rule 63. 2. Expired licence if the vehicle was previously licensed. 3. Required amount of fee paid in the manner specified in rule 13.