Example: biology
Getting to the Bottom of CHIRP Technology - Airmar
Getting to the Bottom of CHIRP Technology Jen Matsis Vice President - Sales & Marketing AIRMAR Technology
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
www.airmartechnology.comInstallation Cored fiberglass hull—Follow separate instructions on page 4. CAUTION: The base must be liquid-tight.To ensure a tight bond, the hull surface under and around the base must be smooth, free of paint or any other finish, clean, and dry.
OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
www.airmartechnology.com2 Figure 5. Fairing Figure 6. Fairing NOTE: After the fairing is cut, the section with the cutting guide becomes the backing block. 20mm (3/4") cutting guide cavity for 22° max
OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
www.airmartechnology.cominstallation on the starboard side of the boat or away from you for installation on the port side (Figure 4). 4.Adjust the cutting fence, so the fairing will be cut in about two