GSM 03.38 - Version 5.0.0 - Digital cellular ...

1 New presentation - see History boxGSMGSM 1995 SPECIFICATIONV ersion : ETSI TC-SMGR eference: TS/SMG-030338 QICS: words: Digital cellular telecommunications system, Global System for Mobile communications (GSM) Digital cellular telecommunications system (Phase 2+);Alphabets and language-specific information(GSM )ETSIE uropean Telecommunications Standards InstituteETSI SecretariatPostal address: F-06921 Sophia Antipolis CEDEX - FRANCEO ffice address: 650 Route des Lucioles - Sophia Antipolis - Valbonne - : c=fr, a=atlas, p=etsi, s=secretariat - Internet: +33 92 94 42 00 - Fax: +33 93 65 47 16 Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and theforegoing restriction extend to reproduction in all media.

2 European Telecommunications Standards Institute 1995. All rights 2 GSM Version : December 1995 Whilst every care has been taken in the preparation and publication of this document, errors in content,typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to"ETSI Editing and Committee Support Dept." at the address shown on the title 3 GSM Version : December 1995 ContentsForeword .. 51 Scope .. 72 Normative references .. 73 Abbreviations .. 74 SMS Data Coding Scheme .. 85 Cell Broadcast Data Coding 106 Individual parameters .. principles .. notes .. packing .. Point-to-Point Packing .. of 7-bit characters .. Cell Broadcast of 7-bit characters.

3 Tables .. alphabet .. 14 Page 4 GSM Version : December 1995 Blank pagePage 5 GSM Version : December 1995 ForewordThis Global System for Mobile communications Technical Specification (GTS) has been produced by theSpecial Mobile Group (SMG) Technical Committee (TC) of the European Telecommunications StandardsInstitute (ETSI).This GTS defines the language-specific requirements for GSM within the Digital cellulartelecommunications system (Phase 2/Phase 2+).This GTS is a TC-SMG approved GSM technical specification Version 5, which contains GSM Phase 2+enhancements/features to the Version 4 GSM technical specification. The European TelecommunicationsStandard from which this Phase 2+ GTS has evolved is Phase 2 GSM ETS 300 628 (GSM Version ).

4 GTS are produced by TC-SMG to enable the GSM Phase 2+ specifications to become publicly available,prior to submission for the formal ETSI standards approval procedure to become EuropeanTelecommunications Standards (ETS). This ensures the earliest possible access to GSM Phase 2+specifications for all Manufacturers, Network operators and implementors of the Global System for contents of this GTS are subject to continuing work within TC-SMG and may change following formalTC-SMG approval. Should TC-SMG modify the contents of this GTS it will then be republished by ETSI with an identifying change of release date and an increase in Version number as follows: Version :ythe third digit is incremented when editorial only changes have been incorporated in thespecification;xthe second digit is incremented for all other types of changes, technical enhancements,corrections, updates, is made within this TS to GSM-TSs (note).

5 NOTE:TC-SMG has produced documents which give the technical specifications for theimplementation of the Digital cellular telecommunications system. Historically, thesedocuments have been identified as GSM Technical Specifications (GSM-TSs). TheseTSs may have subsequently become I-ETSs (Phase 1), or ETSs/ETSI TechnicalReports (ETRs) (Phase 2). TC-SMG has also produced ETSI GSM TSs which give thetechnical specifications for the implementation of Phase 2+ enhancements of thedigital cellular telecommunications system. These Version GSM TechnicalSpecifications may be referred to as 6 GSM Version : December 1995 Blank pagePage 7 GSM Version : December 19951 ScopeThis Global System for Mobile communications Technical Specification (GTS) defines the language-specific requirements for GSM.

6 These are specific codepoints required by the Short Message Service(SMS) specifications which in turn are used not only for SMS (GSM , ) but also forUnstructured Data (GSM ) and may additionally be used for Man Machine Interface (MMI)(GSM ).The specification for the Data Circuit terminating Equipment/Data Terminal Equipment (DCE/DTE)interface (GSM ) will also use the codes specified herein for the transfer of SMS data to an referencesThis GTS incorporates by dated and undated reference, provisions from other publications. Thesenormative references are cited at the appropriate places in the text and the publications are listedhereafter.

7 For dated references, subsequent amendments to or revisions of any of these publicationsapply to this GTS only when incorporated in it by amendment or revision. For undated references, thelatest edition of the publication referred to applies.[1]GSM (ETR 100): "European Digital cellular telecommunication system(Phase 2); Abbreviations and acronyms".[2]GSM (ETS 300 511): "European Digital cellular telecommunication system(Phase 2); Man-Machine Interface (MMI) of the Mobile Station (MS)".[3]GSM (ETS 300 549): "European Digital cellular telecommunication system(Phase 2); Unstructured supplementary services operation - Stage 1".[4]GSM (ETS 300 536): "European Digital cellular telecommunication system(Phase 2); Technical realization of the Short Message Service (SMS) Point toPoint (PP)".

8 [5]GSM (ETS 300 537): "European Digital cellular telecommunication system(Phase 2); Technical realization of Short Message Service Cell Broadcast(SMSCB)".[6]GSM (ETS 300 559): "European Digital cellular telecommunication system(Phase 2); Point-to-Point (PP) Short Message Service (SMS) support on mobileradio interface".[7]GSM (ETS 300 560): "European Digital cellular telecommunication system(Phase 2); Short Message Service Cell Broadcast (SMSCB) support on themobile radio interface".[8]GSM (ETS 300 585): "European Digital cellular telecommunication system(Phase 2); Use of Data Terminal Equipment - Data Circuit terminatingEquipment (DTE - DCE) interface for Short Message Service (SMS) and CellBroadcast Service (CBS)".

9 3 Abbreviations Definitions used in this specification are listed in GSM 8 GSM Version : December 19954 SMS Data Coding SchemeThe TP-Data-Coding-Scheme field, defined in GSM , indicates the data coding scheme of theTP-UD field, and may indicate a message class. The octet is used according to a coding group which isindicated in bits The octet is then coded as follows:Coding Group BitsUse of bits indicationUnspecified message handling at the indicate the alphabet as follows:0000 Default coding groups1100 Message Waiting Indication Group: Discard MessageBits are coded exactly the same as Group 1101, however with bits set to 1100 the mobilemay discard the contents of the message, and only present the indication to the Waiting Indication Group: Store MessageThis Group allows an indication to be provided to the user about the status of types of messagewaiting on systems connected to the GSM PLMN.

10 The mobile may present this indication as anicon on the screen, or other MMI indication. The mobile may take note of the Origination Addressfor messages in this group and group 1100. For each indication supported, the mobile may providestorage for the Origination Address which is to control the mobile indicatorText included in the user data is coded in the Default a message is received with bits set to 1101, the mobile shall store the text of the SMSmessage in addition to setting the 3 indicates Indication Sense:Bit 30 Set Indication Inactive1 Set Indication ActiveBit 2 is reserved, and set to 0 Bit 1 Bit 0 Indication Type:00 Voicemail Message Waiting01 Fax Message Waiting10 Electronic Mail Message Waiting11 Other Message Waiting** Mobile manufacturers may implement the Other Message Waiting indication as an additionalindication without specifying the meaning.