Henry Blueskin VP160 Air Barrier System Installation Manual
3 1. Introduction This installation manual includes materials and installation procedures for Henry® Blueskin® VP160 Self-Adhered Water Resistive Air Barrier system. Blueskin® VP160 meets the current IBC and IECC air barrier requirements for a water resistive barrier (WRB) as referenced in ICC ESR-2975.
Tags:
Installation, Water, Resistive, Water resistive, Water resistive air
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
TECHNICAL DATA SHEET - Henry
henry.comImpermeable to air, moisture vapor and water Compatible with Henry® Air-Bloc fluid applied air barriers Self-gasketing when penetrated and under compression with self-tapping screws Usage Blueskin SA is designed for use as a self-adhered air, vapor and water resistive barrier. It can also be used as a transition sheet
Sheet, Data, Technical, Barriers, Water, Technical data sheet, Resistive, Air barrier, Water resistive
Air-Bloc All Weather STPE
henry.comHenry® Air-Bloc All-Weather STPE is a low VOC, UV and fire-resistant fluid applied, elastomeric membrane designed to provide a vapor permeable, water resistive air barrier when applied to above-grade wall assemblies. It is single-component, moisture cure
Water, Step, Weather, Resistive, Water resistive air, All weather stpe
TECHNICAL DATA SHEET Blueskin WP200 - Henry
henry.comREVISION: 02/27/17 Henry Company 999 N. Sepulveda, Ste 800, El Segundo CA 90245-2754 Technical Services- Phone (800) 486-1278 – Email: techservices@henry.com www.henry.com Blueskin WP 200 Self-Adhesive Waterproofing Membrane Uses Blueskin WP200 is designed for use as a self-adhered s heet waterproofing membrane in above or below grade applications.
Sheet, Data, Data sheet, Heet, Sh eet
TECHNICAL DATA SHEET
henry.comREVISION: 11/17/15 Henry Company, 999 N. Sepulveda Blvd., Ste. 800, El Segundo, CA 90245 Technical Services - Phone: (800) 486-1278 – Email: techservices@henry.com www.henry.com Henry CM100 Fast Curing, Elastomeric Fluid Membrane Uses Henry CM100 may be used as a waterproofing and roofing membrane on horizontal or vertical surfaces. Ideal alternative to hot
Air & Water Barrier Membrane - Henry
henry.comConcrete . ASTM C836 load suction pressure-Low Temperature Flexibility and Crack Bridging @ –20°C . ASTM C836 -Aging-Long Term Flexibility . CGSB 71 -GP-24M -Nail Sealability . ASTM D1970 --Resistance to Mold, Mildew & Fungal growth . ASTM D5590 . ASTM E84-VOC Content . Gray . 60% . 10.8 lbs/gal (1.3 kg/l) 2 Hours to touch dry . 24 Hours to ...
WATERPROOFING SYSTEMS - Henry
henry.comSecondary Containment Structures • Tunnels • Underground ... Drainage & Irrigation Channels • Potable Water Reserves • Seals Embedded Steel, PVC or HDPE Pipe Penetrations HENRY DRAINAGE COMPOSITES: A BETTER ENGINEERED SOLUTION FOR MANAGING THE FLOW OF WATER ... highway drainage systems.
HE784 - AQUA-BLOC® WB - henry.com
henry.comLimited Warranty We, the manufacturer, warrant only that this product is free of defects, since many factors which affect the results obtained from this product - such as weather, workmanship, equipment utilized and prior condition of the substrate - are
TECHNICAL DATA SHEET - Henry
henry.comAir Permeance - Material @1.57psf (75Pa) 0.0001 cfm/ft² (0.0005 L/[sec-m²]) ASTM E2178 Air Leakage - Assembly Pass ASTM E2357 Elongation 250% ASTM D412 Tensile Strength 140 psi (965 kPa) ASTM D412 Flame Spread Index 10, Class A ASTM E84 Smoke Developed 15, Class A ASTM E84 Fire Testing Complies with NFPA 285 in various wall
Sheet, Data, Testing, Technical, Technical data sheet, Leakage, Air leakage
Henry 925 BES Sealant
henry.comHenry® 925 BES Sealant is a premium, moisture cure sealant for construction joints subject to dynamic joint movement. This one-part, low odor, moisture cure product provides excellent weathering resistance, flexibility, very low VOC, through use of a silyl-terminated polyether (STPE) polymer. Upon curing, it is paintable with latex based paints.
TECHNICAL DATA SHEET - Henry
henry.comcast-in-place concrete, concrete block, steel, aluminum and galvanized metal. Strike masonry joints full-flush. Concrete surfaces must be smooth and without large voids, spalled areas or sharp protrusions. Concrete must be cured a minimum of 14 days. Curing
Sheet, Data, Technical, Steel, Technical data sheet, Galvanized
Related documents
HARDIPLANK Installation Instructions
www.structuretech1.comresistive barriers with all siding products. James Hardie will assume no responsibility for water infiltration within the wall. HANDLING & STORAGE: Store flat and keep dry prior to installation. Installing siding wet or saturated may result in shrinkage at butt joints. Carry planks on edge. 1” from plank top stud figure 1 3/8” from plank ...
Installation, Instructions, Barriers, Water, Installation instructions, Resistive, Resistive barriers
Technical Guide: DensGlass® Sheathing
sweets.construction.comsheathing installation are paramount without the headaches and expense of delamination, deterioration, sagging and warping. ... DensGlass Sheathing is the ideal substrate for a wide variety of air and water-resistive barriers including building wraps, fluid applied coatings, self-adhering membranes and spray foam applications. See page 10 for ...
Installation, Barriers, Water, Resistive, Resistive barriers
TR1510 HardieTrim HZ5 Installation Instructions LR
www.jameshardiepros.comwater-resistive barrier siding 16 in. max. NOTE: Follow your window/door manufacturer’s installation instructions for caulking guidance between window and trim. Butt to Siding Trim the opening prior to the installation of the siding. Position trim boards on the wall and secure. Allow proper fastener spacing at edges and ends. corner studs ...
TECHNICAL DATA SHEET - Henry
henry.comImpermeable to air, moisture vapor and water Compatible with Henry® Air-Bloc fluid applied air barriers Self-gasketing when penetrated and under compression with self-tapping screws Usage Blueskin SA is designed for use as a self-adhered air, vapor and water resistive barrier. It can also be used as a transition sheet
Sheet, Data, Technical, Barriers, Water, Technical data sheet, Resistive, Air barrier, Water resistive
Exterior Insulation and Finish System Application Guide
academy.parexusa.comresistive barrier membrane. Uses: Secondary water and air-resistive barrier in the Commercial Drainage EIFS system. WeatherBlock: A 100% Acrylic co-polymer fast drying vapor retarder, elastomeric waterproof and air barrier coating which can be either rolled, brushed, or spray applied. Uses: Secondary water and air resistive barrier in the
Water, Finish, Exterior, Insulation, Resistive, And air, Air and water, Exterior insulation and finish, Water and air resistive
Contents
www.huberwood.comlaminated with a water-resistive facer on the exterior and a rigid foam insulation panel bonded on the opposite (interior) face. When properly installed andtaped, ZIP System - R-Sheathing provides a water-resistive barrier, air barrier and exterior insulation in one product. It may also be
Sto Gold Coat
www.stocorp.comFluid-applied Vapor Permeable Air Barrier, WRB Technical Data Sto Gold Coat is a fluid-applied vapor permeable air barrier and water-resistive barrier (WRB) with built-in anti-freeze properties. It is used over prepared vertical above grade concrete, concrete masonry, brick masonry, wood and glass mat gypsum sheathing behind StoTherm® ci and other
3M Fire Barrier Sealant CP 25WB+
multimedia.3m.com3M™ Fire Barrier Sealant CP 25WB+ Product Data Sheet 1. Product Description 3M™ Fire Barrier Sealant CP 25WB+ is a high-performance, ready-to-use, gun-grade, latex-based, intumescent sealant that dries to form a monolithic firestop seal that also acts as a barrier to airborne sound transmission. 3M™ Fire Barrier Sealant CP 25WB+ helps control the spread of fire, smoke and noxious gasses ...