Hilti HIT-HY 200 with rebar

384 Hilti HIT-HY 200with rebar2013385 Hilti HIT-HY 200with rebar2013386 Hilti HIT-HY 200with rebar2013387 Hilti HIT-HY 200with rebar2013388 Hilti HIT-HY 200with rebar2013389 Hilti HIT-HY 200with rebar2013390 Hilti HIT-HY 200with rebar2013391 Hilti HIT-HY 200with rebar2013392 Hilti HIT-HY 200with rebar2013393 Hilti HIT-HY 200with rebar2013394 Hilti HIT-HY 200with rebar2013395 Hilti HIT-HY 200with rebar2013396 Hilti HIT-HY 200with rebar2013397 Hilti HIT-HY 200with rebar2013

Hilti HIT-HY 200 with rebar Benefits - suitable for cracked and non- cracked concrete C 20/25 to C 50/60. - Approved automatic cleaning with the use of the hollow drill-bit high loading capacity, excellent handling HY 200-R version with extended curing time for rebar applications small edge distance and anchor spacing possible

Tags:

  With, Rebar, Hilti, Hy 200, Hilti hit hy 200 with rebar

Information

Documents from same domain

ICC-ES Evaluation Report ESR-2269 - Hilti

www.hilti.com

1.0 EVALUATION SCOPE Compliance with the following codes: 2018, 2015, and 2012 International Building Code ® (IBC) 2018, 2015, and 2012 International Residential Code® (IRC) For evaluation for compliance with codes adopted by the Los Angeles Department of Building and Safety (LADBS), see ESR-2269 LABC and LARC Supplement.

  Report, Evaluation, Hilti, 2269, Icc es evaluation report esr 2269

HIT-1 ADHESIVE ANCHORING SYSTEM - Hilti

www.hilti.com

HIT-1 ADHESIVE ANCHORING SYSTEM Technical Supplement PRODUCT DESCRIPTION Hilti HIT-1 is a hybrid adhesive mortar combining resin, hardener, cement, and water. It’s formulated for fast curing and easy installation in a wide range of concrete and masonry base materials with temperatures ranging from 32°F (0°C) up to 95°F (35°C).

  Rinses, Adhesive, Cement, Hilti

HIT-RE 500 V3 - Hilti

www.hilti.com

Safety information for 2-Component-products 18/06/2020 US-OSHA - en 2/27 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs: Get medical advice/attention. If eye irritation persists: Get medical advice/attention.

  Medical, Safety, Hilti, Hit re 500 v3

OPENINGS IN COMPOSITE FLOOR DECKS - Hilti

www.hilti.com

in-situ reinforced concrete topping. The decking not only acts as a permanent formwork to the concrete, but also provides sufficient shear bond with the concrete so that, when the concrete has cured, the two materials act together compositely to resist the loads on the deck. Openings in floor decks are a common part of any building.

  Concrete, Reinforced, Hilti, Reinforced concrete

Hilti HIT-HY 200 with HIT-V

www.hilti.com

Anchor rods HIT-V GR / -HCR) are available in variable length MIO M12 TE 16 M16 M20 M24 TE 40 M27 - TE 70 M30 compressed air gun or blow out pump, set of cleaning brushes, dispenser Drill hole to the required embedment depth with an appropriately sized Hilti TE-CD Or TE-YD hollow drill bit with Hilti vacuum attachment. This drilling

  With, Anchor, Rods, Hilti, Anchor rods, Hilti hit hy 200 with hit

Hilti HIT-HY 200 with rebar

www.hilti.com

Hilti HIT-HY 200 with rebar Benefits - suitable for cracked and non- cracked concrete C 20/25 to C 50/60. - Approved automatic cleaning with the use of the hollow drill-bit high loading capacity, excellent handling HY 200-R version with extended curing time for rebar applications small edge distance and anchor spacing possible

  Rebar, Hilti

Page 1/8 Safety Data Sheet acc. to ISO 11014 - Hilti USA

www.hilti.com

Page 2/8 Safety Data Sheet acc. to ISO 11014 Printing date 05/19/2015 Version number 5 Reviewed on 05/19/2015 (Contd. of page 1) 40.2.7 H319 Causes serious eye irritation.

  Sheet, Data, Safety, Pages, Page 1, Hilti, 8 safety data sheet acc

KB-TZ2 TECHNICAL GUIDE

www.hilti.com

KB-TZ2 Technical uide April 2021 5 Table 4 - Allowable Hilti carbon steel KB-TZ2 strength in uncracked concrete for hammer drill and core drill installations 1,2,3,4 Nominal anchor

  Hilti

Hilti. Outperform. Outlast.

www.hilti.com

Selector Guide Through-Penetration Joint Reference Data Firestop Mortar (CP 637) Product description ... Concrete and masonry assemblies Expansion on setting (approx.)Walls and floors rated up to 4 hours ... Mix ratio (recommended, mortar to water):

  Guide, Concrete, Selector, Selector guide

HILTI TECHNICAL BULLETIN

www.hilti.com

Mar 04, 2018 · )n ≤ 1, where n=5/3 for 3/8- and 1/2-inch diameters (No. 3 and No. 4 rebar) and n=1 for 5/8 and 3/4-inch diameter or No. 5 and No. 6 rebar. 9 The critical spacing, s cr, is the smallest anchor spacing where full load values may be used. The minimum spacing, s min, is the minimum anchor spacing for which values are

  Hilti

Related documents

HILTI ANCHOR ROD SPECIFICATIONS AND TECHNICAL DATA

images.thdstatic.com

The following steel design information is for Hilti HAS threaded rods and HIT-Z anchor rods according to the material specifications on page 2, used in conjunction with Hilti adhesive anchors designed in accordance with ACI 318 Chapter 17. This includes Hilti HIT-HY 200, HIT-RE 500 V3, HIT-RE 100, HIT-HY 100, and HIT-ICE.

  Hilti, Hilti hit, Hy 200

Hilti HIT-HY 200 with HIT-V

www.hilti.com.au

(Hilti HIT-HY 200-R) Fire test report IBMB, Brunswick 3501/676/13 / 2012-08-03 a) All data given in this section according ETA-12/0084, issue 2013-06-20. Service temperature range Hilti HIT-HY 200 injection mortar may be applied in the temperature ranges given below. An elevated base material temperature

  With, Hilti, Hilti hit hy 200 with hit, Hilti hit, Hy 200

ANCHOR SELECTOR - hilti.com

www.hilti.com

HIT-HY 200-R ... 1-800-879-8000 | en español 1-800-879-5000 www.hilti.com Hilti (Canada) Corporation 1-800-363-4458 www.hilti.ca. Created Date: 1/4/2022 9:19:33 AM ...

  Hilti, Hy 200, Com hilti

HIT-HY 200-A/R INJECTION MORTAR - Hilti

www.hilti.co.uk

Hilti HIT- HY 200-A 500 ml foil pack (also available as 330 ml foil pack) -SafeSet technology: Simplified method of borehole preparation using either Hilti hollow drill bit for hammer drilling or Roughening tool for diamond cored applications - Suitable for non-cracked and

  Hilti, Hilti hit, Hy 200

HIT-HY 200-A - hilti.co.jp

www.hilti.co.jp

HIT-HY 200-A 1. 仕様図 本体・ミキシングノズル [単位：mm] 名 称 l 全 長 本体 l 部長さ c 主剤部 外径 d E1 硬化剤部 外径 d E2 HIT-HY 200-A 330ml 430 170 51 23 HIT-HY 200-A 500ml 500 240 51 23 2. 樹脂 主な樹脂成分 容 量（ml）

  Hilti, Hy 200

Hilti’s team of technical support

www.hilti.ca

Hilti HIT-HY 200-A Cartridge Hilti HIT-Z Anchor Rod Hilti HAS Threaded Rod Rebar Hilti HIS-N/RN Approvals/Listings ICC-ES (International Code Council) ESR-3187 in concrete per ACI 318-14 Ch . 17 / ACI 355 .2/ ICC-ES AC308 ESR-3963 in grout-filled CMU per ICC-ES AC58 ELC-3187 in concrete per CSA A23 .3-14 / ACI 355 .2

  Hilti, Hilti hit, Hy 200

Hilti HIT-HY 70 injection mortar for masonry

www.hilti.com.au

Hilti HIT-HY 70 injection mortar for masonry ... A distance from the edge of a broken brick of cmin = 200 mm is recommended, e.g. around window or door frames. b) Recommend to place one anchor per brick, in the middle of the brick face. c) Refer the Recommended loads table for the required setting depth.

  Hilti, Hilti hit

Related search queries