HT/HS/HK Installation Procedures - Hendrickson

1 TECHNICAL PROCEDUREHT SerieS SuSpenSion SySTemSSuBJeCT: Installation Procedures LiT no: L577 DATe: January 2016 reViSion: C2L577 CHT SerieS Installation Procedures TABLe oF ConTen TSConventions Applied in This Document 3 General Service notes 3 During Service 3 Important Safety Notices

2 3 Contacting Hendrickson 5 Literature 5 Preparing Trailer for Service 6pre- Installation 6 Special Notes 6 Required Supplies 7 Pre- Installation Checklist

3 8If Installing on A Slider System: 8 Surface coat considerations 8 Axle/Suspension Beam positioning 8 Using HT Series Fixtures 8

4 Pre-assembled Beam and Frame Bracket 8 Unassembled Suspension Beams 10 Using a Y-beam Fixture 10 Positioning Axle With Fixture 10 Axle Installation Without An Axle Locating Fixture 11 Preparing Suspension Beams 11 Positioning Axle Without Fixture 11u-bolt Installation

5 13 Suspension Mounting 15 Frame Bracket Installation 15 Frame Bracket Support 15 Suspension Beam/Frame Bracket Assembly Welded Collar 15 Suspension Beam/Frame Bracket Assembly QUIK-ALIGN 17 Axle/Y-beam Subassembly Installation 18 Bushing Tube Sleeve Installation 19Y-Beam Pivot Connection Assembly

6 19 Shock Clevis Installation 19 Installing Air Springs and Shocks 20 Tire Clearance 20 Upper Air Spring Plate 21 Air Controls Installation 21 Axle Alignment 21 Final inspection 22 Appendix A.

7 Alteration of existing Axle Locating Fixture 233L577 C HT SerieS Installation Procedures ConVen TionS App Lie D in THiS DoCumenTThis section explains the techniques used in this document to convey important information, safety issues, how to contact Hendrickson and how to apply hyperlinks eXpLAnATion oF SiGnAL WorDSHazard signal words (such as DANGER, WARNING or CAUTION) appear in various locations throughout this publication Information accented by one of these signal words must be observed at all times Additional notes are utilized to emphasize areas of procedural importance and provide suggestions for ease of repair The following definitions comply with ANSI Z535 4 and indicate the use of safety signal words as they appear throughout the publication DAnGer: inDiCATeS immeDiATe HAZArDS WHiCH WiLL reSuLT in SeVere perSonAL inJury or.

8 Indicates hazards or unsafe practices which could result in severe personal injury or : indicates a hazardous situation which, if not avoided, could result in minor or moderate : indicates hazards or unsafe practices which could result in damage to machine or : An operating procedure, practice or condition that is essential to emphasize. Safety alert symbol used to indicate a condition exists that may result in personal injury or harm to individuals It must be applied to DANGER, WARNING and CAUTION statements, which emphasize severity LinKSLinks are identified by a dark grey line under the linked text Internal links allow the reader to jump to a heading, step or page in this document External links open the website or document referenced GenerAL Ser Vi Ce noTeSimporTAnT.

9 Special attention should be paid to the information included in eXpLAnATion oF SiGnAL you beginRead, understand and comply with: All instructions and Procedures All signal word (CAUTION, WARNING and DANGER) statements to help avoid personal injury or property damage Company s maintenance, service, Installation and diagnostic practices Vehicle manufacturer s safety instructions when working on the vehicle Vehicle manufacturer s instructions for recommended practices not described in this manual Local safety regulations DurinG