INDIRECT WATER HEATER PIPING COMPARISON 40
NOTE: Material costs are typical contractor prices as of 10/15/17 *3/4” Cu Tubing at $1.99 / ft. Type L **3/4” Cu Tubing at $1.62 / ft. Type M *1” Cu Tubing at $3.19 / ft. Type L **1” Cu Tubing at $2.49 / ft. Type M 80 Gallon Typical Side-Connect Indirect 80 Gallon Water Heater Heat-flo HF-80 Indirect Water Heater Domestic Piping Boiler Piping
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Hot Water Booster/ Storage Tanks - Hot Water …
www.heat-flo.comrequire. Homes with multiple baths, hot tubs, and body sprays increase the requirement for the “dump loads” that tankless coils, instantaneous water heaters, and plate heat exchangers can not provide.
Heat-Flo, Inc LIMITED WARRANTY
www.heat-flo.comHeat-Flo, Inc. LIMITED WARRANTY FOR INDIRECT WATER HEATER These Heat-Flo, Inc. warranties protect your indirect-fired water heater. These warranties are applicable to the original purchasers only.
STAINLESS STEEL INDIRECT WATER HEATERS
www.heat-flo.com• Bank together 80 and 115 gallon units for applications with high water heating demands. • Limited warranty residential installation, 5 year commercial. Heat-flo’s high efficiency indirect water heaters are made with quality stainless steel materials that provide excellent heat transfer and a longer tank life, as well as abundant hot
Related documents
FIBERGLASS REINFORCED PLASTIC (FRP) PIPING SYSTEMS ...
www.fiberbond.com5 Rev: June 1998 Typical Design Pressures of Process / Facilities Piping Material Typical Design Pressures FRP Up to 12in. diameter, most chemical plant applications are 150psig or lower.
A Recommended Approach to Piping Flexibility Studies to ...
www.betamachinery.comwww.BetaMachinery.com GMC 2011: Beta Machinery Analysis A Recommended Approach to Piping Flexibility Studies Page 2 1 Introduction Piping flexibility studies (thermal analyses) are commonly done on piping systems to ensure the stress,
Gas Piping FactsTANKLESS WATER HEATING
snowcrest.netGas Piping FactsTANKLESS WATER HEATING Information for properly sizing gas lines for use with tankless water heaters and other gas appliances Rheem Water Heating • 101 Bell Road
PE Pipe Joining Procedures - Energy Piping Systems
plasticpipe.orgChapter 9 PE Pipe Joining Procedures 329 Butt Fusion of PE Pipe Products with Different Wall Thicknesses PE pipes of the same outside diameter but having different specified wall thicknesses,
TYPICAL MANIFOLD SYSTEM - Franklin Fueling Systems
www.franklinfueling.comtypical manifold system 4 tanks recommended to be of same diameters or with top of tanks on the same plane. installation must conform to applicable
Typical Hydronic System and Primary-Secondary Pumping ...
www.advantageengineering.comSUBJECT: TYPICAL HYDRONIC SYSTEM AND FYI #286 6/3/2008 PRIMARY-SECONDARY PUMPING SYSTEM SCHEMATIC ADVANTAGE Engineering, Inc.525 East Stop 18 Road Greenwood, IN 46142 317-887-0729 fax: 317-881-1277 web site: www.AdvantageEngineering.com email: sales@AdvantageEngineering.com