Transcription of INSTALLATION GUIDE
1 AS/NZS 3718:2005WM-022852 SPECIFICATIONSRECOMMENDED USEMATERIALNOTE: PRODUCT DOES NOT INCLUDE FILTER OR FILTER CONNECTION FITTINGS. PRESSURE RATINGTEMPERATURE RATINGD isclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors. All ABI Products are designed in Australia. Copyright ABI Interiors Pty Ltd HOT WATER UNITSSTANDARDSDO NOT use cream cleaners or bleach. These substances are abrasiveDO NOT use cleaning pads with abrasive surfaces as this may scratch the materialRegularly clean with mild liquid detergent or soap and waterNote: Dimensions are nominal measurements onlyINSTALLATION GUIDENote: This product must be installed by a licensed is a general INSTALLATION GUIDE - there are many factors that are involved that can alter the INSTALLATION method.
2 This product installmust comply with AS/NZS 3500 Domestic, CommercialRecommended minimum working pressure 150kPaRecommended maximum working pressure 500kPaHot and cold water inlet pressure should be equalStorage tank: YesContinuous Flow: YesGravity Feed: Not suitableMaximum continuous working temperature 75 CIf the water temperature exceeds 75 C, an approved tempering valve must be fittedELYSIAN KITCHEN MIXEREXPLODED VIEWItem Description Code1 Spout2 Rubber O-Ring3 Aerator4-8 Outlet & Connections9 Grub Screw10 Body11 Dress Ring12-13 Flexible Hoses14 Horse Shoe Plate15 Cartridge16 Locking Nut17 Dome18 Cap19 Grub Screw20 HandleINSTALLATION MANUALT ools you will need:Plumbers PuttyAdjustable WrenchPhillips ScrewdriverThe hole dimension as 35mmFix the bolts to the bottom of the body, tighten it with a screwdriver. 35mmMAX30mmAdjustabale WrenchPipe TapeAllen Key1 Put the faucet into the hole.
3 Pass the horseshoe plates through the bolts, fasten the nuts and tighten345AB2 HOTCOLDOFFON23 90 WELS Star Rating 5 Star Flow Rate Registration WM-022852 MAX30610124372 Note: Dimensions are nominal measurements Brass
