INSTALLATION GUIDE AND USER MANUAL - …

1 INSTALLATION GUIDE AND user MANUAL electric vehicle charging station Model: 30A EVoCharge EVSE Model Number: EV072-300-001A Product Safety Certification: UL and cUL Listed Description: SAE J1772 AC Level 2, 30A ( kW) Continuous Rated EV Charger 2012-2015 EVoCharge - All Rights Reserved All information in this document is subject to copyright and other intellectual property rights of EVoCharge. This material may not be modified, reproduced or copied, in whole or in part, without the prior written permission of EVoCharge. EVoCharge and EVoReel are trademarks of EVoCharge. All other trademarks contained in this document are the property of their respective owners and their use herein does not imply sponsorship or endorsement of their products or services.

2 All specifications and descriptions contained in this document are verified to be accurate at the time of printing. However, to support continuous improvement, EVoCharge reserves the right to make product modifications at any time without notice. Updated INSTALLATION GUIDE and users MANUAL is available at 2 IMPORTANT Read this MANUAL thoroughly and make sure you understand the procedures before you attempt to install or operate this equipment. The purpose of this MANUAL is to provide you with information necessary to safely install, operate and maintain this equipment. Keep this MANUAL for future reference.

3 EVoCharge recommends the charging station be installed by a qualified electrician, and INSTALLATION must be in accordance with all applicable state, local and national electrical codes and standards. Failure to observe this precaution could result in death or severe injury. Warranty: The charging station is covered by a two year limited warranty. For a detailed description of this warranty, contact EVoCharge: Email: Telephone: (800) 930-9450 3 MANUAL CONTENT SAFETY IMPORTANT REFERENCE INSTALLATION PLANNING & SERVICE SAVE THESE SAFETY INSTRUCTIONS The charging station must be grounded through a permanent wiring system or an equipment grounding conductor.

4 Do not install or use the charging station near flammable, explosive, harsh, or combustible materials, chemicals, or vapors. Turn off input power at the circuit breaker before installing or cleaning the charging station . Use the charging station only within the specified operating parameters. The charging station is designed only for vehicles that are compatible with the SAE J1772 AC Level 2 charging standard. Do not use the charging station if it is defective, appears cracked, frayed, broken or otherwise damaged, or fails to operate. Do not attempt to open, disassemble, repair, tamper with, or modify the charging station .

5 The charging station is not user serviceable. Contact EVoCharge for any repairs. Do not use the charging station when either you, the vehicle , or the charging station is exposed to severe rain, snow, electrical storm or other severe weather. When transporting the charging station , handle with care and do not subject it to strong force, drag or step on the charging station . Do not touch the charging station end terminals with sharp metallic objects. Do not forcefully pull the charge cable or damage it with sharp objects. Do not insert foreign objects into any part of the charging station vehicle connector.

6 Using with a worn or damaged AC outlet may cause burns or start a fire. If the AC wall plug feels hot while charging , unplug the unit and replace the AC outlet. To avoid a risk of fire or electric shock, do not use this device with an extension cord. Risk of explosion. This equipment has arcing or sparking parts that should not be exposed to flammable vapors. This equipment should be located at least 18 inches (460mm) above the floor. Risk of electric shock. Do not remove cover or attempt to open the enclosure of the charger unit. No user serviceable parts inside. Refer servicing to qualified service personnel.

7 Unit will attempt to reset in fault conditions. This device is intended only for charging vehicles not requiring ventilation during charging . Warning 4 -Continued on next page- This document contains important instructions and warnings that must be followed when installing and maintaining the charging station 5 Incorrect INSTALLATION and testing of the charging station could potentially damage either the vehicle s Battery and/or the charging station itself. Any resulting damage is excluded of the warranty for the charging station . Do not operate the charging station in temperatures outside its operating range of -22F (-30C) to 122F (50C).

8 Ensure that the charge cable is positioned so it will not be stepped on, tripped over, or subjected to damage or stress. To reduce the risk of electrical shock, connect only to properly grounded outlets. If the plug provided does not fit the outlet, do not modify the plug, arrange for a qualified electrician to inspect the outlet. This equipment should be installed, adjusted, and serviced by qualified electrical personnel familiar with the construction and operation of this type of equipment and the hazards involved. Failure to observe this precaution could result in death or severe injury. The user is responsible for conforming to all local and national electrical codes and standards applicable in the jurisdiction in which this equipment is installed.

9 Confirm with the local electrical requirements for the gauge, temperature rating, and type of wire material used for the overcurrent rating to support a dedicated circuit of 208/240 VAC 40A upstream of two-pole circuit breaker. Do not use this product if the EV Cable is frayed, has damaged insulation, or any other sign of damage. Do not use this product if the enclosure or the EV connector is broken, cracked, open, or shows any other indication of damage. Lockout all electrical source circuit feeding the charging unit in the open position before beginning wiring or terminations. Failure to follow the instructions could result in server bodily injury or death.

10 This unit is rated for indoor or outdoor INSTALLATION . If this unit is mounted outdoors, the hardware for connecting the conduits to the unit must be rated for outdoor INSTALLATION and be installed properly to maintain the proper NEMA rating on the unit. It is important that power wires are routed through an approved conduit or jacket from the circuit panel to the unit. Caution SAVE THESE SAFETY INSTRUCTIONS This document contains important instructions and warnings that must be followed when installing and maintaining the charging station For more information on how to charge your specific vehicle , refer to the owners MANUAL provided with your vehicle .