Transcription of KMW Antenna Installation Guide
1 KMW Antenna Installation Guide For Antenna model ET-X-WM-18-65-8P General Information for Adjustable Clamp Weight [ ] Material Adjustable Clamp Hot-dip galvanized steel [SS400] Bolts & Nuts STS304 Mounting Pole Diameter ~ [ ~ ] Bolts/Nuts Required Tool Recommended Torque M8 Socket head bolt (to attach bracket onto the back of an Antenna ) 6mm Hex Wrench 120 104 Nm M10 Hex. Head bolt (to mount a bracket to the pipe) 17mm spanner 240 208 Nm M8 Hex. Head bolt (to securely hold bracket into a desired tilt ) 13mm spanner 350 304 Nm Step 1 Step 2 Antenna Height L Adjustable angle 61 1450mm 15 KMW Communications Inc.
2 Base Station Antennas For Mobile Communications Up part Down part L 1. Open the Antenna box and take out the adjustable clamp. 2. Inspect all the parts 3. Assemble the Up/Down part onto the Antenna using M8 socket head bolt & plain/spring washer 1. Assemble an upper fixed clamp with M10 Hex. Head bolts provided. 2. Tighten the fixing clamp using the double nut & plain / spring washer. 3. Assemble the lower fixed clamp same as above. KMW Antenna Installation Guide Mounting kits for ET-X-WM-18-65-8P Step 3 * Remove the second nut before tightening the first nut !!! * Tighten the first nut to the recommend torque then insert the second nut and tighten second nut to the recommended torque Loosen 4 points bolts to extend adjustable clamp Extend the adjustable clamp until the desired angle is reached using an angle indicator.
3 Tighten all nuts with a torque of [ ], first the inner nut and then the outer nut. Recommended torque for M8 NUT : [ ] There must be no open gap between any parts of the bracket that require tightening. Caution!Never use torque wrench on the second nut until the first nut is fully. tightened to the recommended torque specification! KMW Communications Inc. Base Station Antennas For Mobile Communications KMW Antenna Installation Guide Mounting kits for ET-X-WM-18-65-8P Step 4 RET Replacement 1. Separate RET cable. 2. Unscrew two M4 screws 3. Disconnect an inner cable 4. Replace RET Note Need to use a cross-head screwdriver to assemble and separate a RET box.
4 M4 Screw Recommended torque : [ ] *. Refer to the color coding for RF cables/connectors *. RF Connector recommended torque : [ ] *. AISG Connector recommended torque: ~ [5~ ] (The connector should be tightened by hand only!) *. Waterproof on the connectors Please be careful of damage to connector, down cap and RET by heat if waterproofing need a heat after connect cable. *. Warning! Do not turn on the power for a controller until all the cables have been properly installed. KMW Communications Inc. Base Station Antennas For Mobile Communications
