MAKE A Viking Longship Draw and - We and Us

1 draw andcut outa TEMPLATE like this from and us, Educational Design Services 2008 frontsideofboxCrease along the middlethe side panels andflatten the box. (fig. 2)of With the help of yourtemplate, draw the outlines oftwo half ship shapes on theflattened cardboard. (fig. 3)Cut away the top and bottom flaps of the cereal box. (fig. 1) dashed line on thetemplate should correspondwith the corner creasesof the cereal out the two half ship shapes (fig. 4) andpush up a ridge foldbetween the two sides. (fig. 5)from a cereal box about the size of this pageMAKE Afig.

2 1fig. 1sideofboxfig. 2fig. 3 Begin by making a follow the steps you intend to paint thefinished Viking Ship?Water paints will not taketo the glossy surface of thebox. At this stage, before anycutting and folding, it is agood idea to cover the outlineshapes with masking tape oradhesive address the shapeflat and stapleclose to the edgealong the curvedfront of each boat end.( ) 5fig. 4fig. 6x2x2fig. 7 Push down each ridge fold and form two flat-bottom boat (fig. 7)page 1 Viking LongshipJoin the two ends togetherusing staples and sticky-tape (or masking tape).

3 ( ) Dragon out the dragon head andglue it back-to-back over oneprow of the ship. (fig. 9) and colour a sail asshown on page 3. Use the dotted-linesto assist you is making your own colourdesign on the the Sail and Masta sheet of A4 paper tightly arounda pencil to make a hollow paper mast. dab of glue at the finish, will make ithold its shape. Trim the ends.(fig. 10a and fig 10b)Roll Start in the lower right corner and a along the black dotted line and fold overDragon Head ( cut out )How to Assemble the Sail and MastCut a long narrow strip of waste cardboardand fold it into two back-to-back L s.

4 ( fig. 11a) Secure to base of ship with sticky tape. (fig. 11b)The hollow mast should be able to slide down over it. (fig. 11c) 9stickytapefig. 11afig. 11bfig. 11cMake and colour a flag as shown on page 3 Cut a notch into a short narrow strip of cardboard and glue the flag around it.(fig. 12)Tie cotton thread to the front and backof the ship and press the notch down intothe hollow mast to tighten the cotton thread.(fig. 13)Finish and paint the ship according to your own 8fig. 10afig. 10bpage 2fig. 13fig. 12We and us, Educational Design Services 2008 The SailThe Flaga narrow strip of cardboardwith a notch cut into itpage 3We and us, Educational Design Services 2008