MATERIAL SAFETY DATA SHEET - Accrabond

1 INSTA bond 398 Page 1 of 4 MATERIAL SAFETY data SHEETA pril 2007 SECTION 1 PRODUCT AND COMPANY IDENTIFICATIONP roduct Name:INSTA bond 398 Anaerobic Sealing Compound & Gasket MakerNSN # 8030-01-137-6964 Company: ACCRA bond Hacks Cross RoadOlive Branch, MS 38654 Emergency Phone Numbers: ACCRA bond Inc.(662) 895-4480 CHEMTREC (800) 424-9300 SECTION 2 INFORMATION ON COMPONENTSC hemical NameCAS NumberWeight % ACGIH TLVACGIHSTELOSHA PEL-TWASKINM ethacrylated Polyol109-16-050 - 65N/EN/EN/EYesDialkyl EsterProprietary20 - 35N/EN/EN/ENoAcrylic Copolymer96-33-310 - 20N/EN/EN/ENoModified Sodium SulfimideTrade Dioxide7631-86-91-5N/EN/EN/ENoCumene ppmN/ ppmN/EN/EYesSECTION 3 HAZARDS IDENTIFICATIONINGESTION:May be moderately :May cause moderate skin injury (reddening, swelling) and/orsensitization which may not occur immediately.

2 Prolonged contact withthis product may cause :Even though product has low volatility, vapors can be :Will cause eye irritation and possible eye ORGANS:None RATING:Health 2 Flammability 1 Reactivity 1 SECTION 4 FIRST AID MEASURESINGESTION:Do not induce vomiting. Have victim rinse out mouth with water, thendrink sips of water to remove taste from mouth. Get medical attention. INSTA bond 398 Page 2 of 4If vomiting occurs spontaneously, keep head below hips to :Remove contaminated clothing and wash contact area with soap andwater for 15 minutes. If dermatitis occurs, seek medical :In case of exposure to high concentration of vapors, remove person tofresh air. If respiratory irritation persists, seek medical :Immediately flush with plenty of water (under eye lids) at least 15minutes. If redness, burning, blurred vision or swelling persists, consulta physician 5 FIRE FIGHTING MEASURESFLASHPOINT:> 200 F (Setaflash)EXTINQUISHING MEDIA:Use water fog, foam, dry chemical or carbon dioxide to FIRE FIGHTINGF irefighters should wear full protective clothing and self-contained MEASURES:breathing apparatus.

3 Thoroughly decontaminate fire fighting equipmentand fire fighting apparel after the 6 ACCIDENTAL RELEASE MEASURESACCIDENTAL RELEASEIn the event of a spill, immediately remove any source of ignition. MEASURES:Using appropriate personal protective equipment and non-sparking tools, contain spilled MATERIAL . Cover the liquid with inert absorbent. Scoop all contaminated MATERIAL into containers for proper 7 HANDLING AND STORAGEHANDLING AND STORAGE:Store below 100 F for maximum stability. Do not store in directsunlight or near high heat sources. To prevent loss of inhibitor, do notblanket or sparge with nitrogen. Store samples in original packaging. Ifproduct has solidified, do not attempt to use. Wash skin thoroughly withsoap and water after handling. Solvents should not be used to cleanhands or skin because they increase the penetration of the MATERIAL intothe skin.

4 SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTIONVENTILATION:Good air circulation and ventilation is adequate. RESPIRATORY PROTECTION:A respirator protection program that meets OSHA must befollowed whenever workplace conditions warrant the use of a PROTECTION:Butyl or nitrile gloves should be used along with appropriate PROTECTION:Chemical splash SAFETY eyewear is always 398 Page 3 of 4 SECTION 9 PHYSICAL AND CHEMICAL PROPERTIESAPPEARANCE:Purple, viscous liquidODOR:MildSPECIFIC IN WATER:Practically InsolubleVAPOR PRESSURE:N/AVOLATILE ORGANIC CONTENT:< lbs/galSECTION 10 STABILITY AND REACTIVITYSTABILITY:This product is stable under normal polymerization may occur. Uncontrolled polymerization may POLYMERIZATION:cause rapid evolution of heat and increase in pressure that could resultin violent rupture of sealed decomposition products may include oxides of carbon andDECOMPOSITION nitrogen, hydrocarbon fragments and organic decomposition :INCOMPATIBILITY:Free radical initiators, including peroxides, strong oxidizing agents,copper, copper alloys, carbon steel, iron-containing constituents, andstrong TO AVOID.

5 Storage above 100 F, exposure to direct sunlight or other UV sources,loss of dissolved air or polymerization inhibitor, contamination withincompatible 11 TOXICOLOGY INFORMATIONC hemical Name LD50 LC50 Methacrylated Polyol4920 mg/kg (oral rat)N/ACumene Hydroperoxide500 mg/kg (drem rabbit)700 ppm (inh rat)SECTION 12 ECOLOGICAL INFORMATIONECOLOGICAL INFORMATION:Keep product from entering 13 DISPOSAL INFORMATIONDISPOSAL INFORMATION:Dispose of in accordance with federal, state and local 398 Page 4 of 4 SECTION 14 TRANSPORTATION INFORMATIONUN OR ID NUMBER:Not SHIPPING NAME:Not :Not CLASS/DIVISION:Not TRANSPORTATION:Not :49 CFR Part 172 SECTION 15 REGULATORY INFORMATIONSARA TITLE 313:Cumene Hydroperoxide (80-15-9).

6 TSCA 12 (B):No substances found that require HAZARD CATEGORY:As defined, this MATERIAL is considered a chronic health hazardand a reaction PROPOSITION 65:This product contains saccharin which is known to causecancer in laboratory animals. If the MATERIAL is used asintended, there is no requirement for Proposition 65 16 OTHERTo the best of our knowledge, the information contained herein is accurate. However, no liability whatsoeveris assumed for the accuracy or completeness of the information contained herein. Final determination ofsuitability of any materials is the sole responsibility of the user. All materials may present unknown healthhazards and should be used with caution. Although certain hazards are described herein, we cannotguarantee that these are the only hazards that exist.