MATERIAL SAFETY DATA SHEET Blue Thunder …

1 MATERIAL SAFETY data SHEETBlue Thunder tough dirt cleaner #230133/2 For MSDS update: 1-800-361-7691By the criteria of theCONTROLLED PRODUCTS REGULATION this MATERIAL is a CONTROLLED PRODUCTIMATERIAL IDENTIFICATION AND USES upplier Identifier:Wood Wyant Inc., 2345 Autoroute desLaurentides, Bureau 100,Laval, Quebec H7S 1Z7 Trade Name: blue Thunder tough dirt CleanerWHMIS class:D2B, ERecommended Use:As a Ready To Use general all purposecleaner and degreaser (do not dilute) Health Rating:0 = Insignificant1 = Slight2 = Moderate3 = High4 = ExtremeHealth:2 Flammability: 0 Reactivity: 0 Special Warning.

2 NoneIIHAZARDOUS Glycol Butyl Ether25 ppm1746 mg/Kg700 ppm111-76-2 1-5(skin)(oral-rat)(7hr - mouse)435 mg/Kg(dermal-rabbit)Sodium Metasilicate 2 mg/M3600 mg/KgN. 1-5 III PHYSICAL DATAP hysical State:LiquidVapour :Mild solvent % Non Volatile:2 - 3pH: - :BlueClarity: point: 1000 CViscosity:Water thinSolubility in Water:100%IV FIRE and EXPLOSION DATAF lash Point ( C TCC):NoneHazardousCombustion Products:NoneExtinguishing Media:As for surrounding Fire andExplosive Hazards:None Special Procedures:NoneVREACTIVITY DATAS tability.

3 StableMaterials to Avoid:Strong acidsHazardous Decomposition Products:Oxides of carbon and nitrogenN. Ap. = Not applicableN. Av. = Not AvailableVI TOXICITY DATAP rimary Route of (Entry) Exposure:Inhalation:Concentrated vapours may irritate nose and breathing passages and result in nausea, dizziness and drowsiness. Very unlikely under normal use. Spray mists will irritate nose and :Will cause corrosive :Will cause defatting, drying and peeling of affected area,possible burns with prolonged contact which may not beimmediately noticeable or :Will cause irritation, possible burns to mouth, throat and upperdigestive tract.

4 Nausea, vomiting, cramps and :As aboveChronic:Prolonged and repeated skin contact may cause ether component can be absorbed through the skin withprolonged and widespread skin FIRST AIDI nhalation:Remove victim to fresh air. Assist breathing as :Immediately flush with cool water. Remove contact lenses,continue flushing for 15 minutes, holding eyelids apart to ensurerinsing of the entire eye. Contact a physician :Immediately wash affected area with soap and water.

5 If irritationpersists, contact a :DO NOT INDUCE VOMITING. If victim is conscious, rinsemouth and give 1-2 glasses of water. Consult a physicianimmediately. Never give anything by mouth to an PREVENTATIVE MEASURESG loves: Wear nitrile or neoprene glovesEye Protection: Wear SAFETY glasses or Protective Equipment: As required to prevent contact with skin Controls: Local Exhaust:Not normally required. Use ventilating equipment if product is used in a confined area with poor and SpillProcedures:Small spills can be flushed down drain with plenty of spills should be absorbed with absorbent MATERIAL andplaced in suitable containers for disposal.

6 Review Federal,Provincial and Local government regulations for Disposal:In accordance with Municipal, Provincial and Proceduresand Equipment:Remove and launder contaminated clothing. Avoid breathing spray mists. Use appropriate protective equipment. Do not use on glass. Pre-test surfaces before first time use. Avoid contact with skin and :KEEP OUT OF REACH OF CHILDREN. Keep containersclosed. Keep from ADDITIONAL INFORMATIONTDG ShippingName:For drum package #230132: CORROSIVE LIQUIDS, (Sodium Metasilicate Solution) Class 8 UN 1760 PG III ;For 946ml package #230133: Limited Quantity Prepared by:Technical DepartmentDate:August 2005 Revision based on updated data from Suppliers