MATERIAL SAFETY DATA SHEET Blue Thunder …

1 MATERIAL SAFETY data SHEETBlue Thunder tough dirt cleaner #230133/2 For MSDS update: 1-800-361-7691By the criteria of theCONTROLLED PRODUCTS REGULATION this MATERIAL is a CONTROLLED PRODUCTIMATERIAL IDENTIFICATION AND USES upplier Identifier:Wood Wyant Inc., 2345 Autoroute desLaurentides, Bureau 100,Laval, Quebec H7S 1Z7 Trade Name: blue Thunder tough dirt CleanerWHMIS class:D2B, ERecommended Use:As a Ready To Use general all purposecleaner and degreaser (do not dilute) Health Rating:0 = Insignificant1 = Slight2 = Moderate3 = High4 = ExtremeHealth:2 Flammability: 0 Reactivity: 0 Special Warning: NoneIIHAZARDOUS Glycol Butyl Ether25 ppm1746 mg/Kg700 ppm111-76-2 1-5(skin)(oral-rat)(7hr - mouse)435 mg/Kg(dermal-rabbit)Sodium Metasilicate 2 mg/M3600 mg/KgN. 1-5 III PHYSICAL DATAP hysical State:LiquidVapour :Mild solvent % Non Volatile:2 - 3pH: - :BlueClarity: point: 1000 CViscosity:Water thinSolubility in Water:100%IV FIRE and EXPLOSION DATAF lash Point ( C TCC):NoneHazardousCombustion Products:NoneExtinguishing Media:As for surrounding Fire andExplosive Hazards:None Special Procedures:NoneVREACTIVITY DATAS tability:StableMaterials to Avoid:Strong acidsHazardous Decomposition Products:Oxides of carbon and nitrogenN.

2 Ap. = Not applicableN. Av. = Not AvailableVI TOXICITY DATAP rimary Route of (Entry) Exposure:Inhalation:Concentrated vapours may irritate nose and breathing passages and result in nausea, dizziness and drowsiness. Very unlikely under normal use. Spray mists will irritate nose and :Will cause corrosive :Will cause defatting, drying and peeling of affected area,possible burns with prolonged contact which may not beimmediately noticeable or :Will cause irritation, possible burns to mouth, throat and upperdigestive tract; nausea, vomiting, cramps and :As aboveChronic:Prolonged and repeated skin contact may cause ether component can be absorbed through the skin withprolonged and widespread skin FIRST AIDI nhalation:Remove victim to fresh air. Assist breathing as :Immediately flush with cool water. Remove contact lenses,continue flushing for 15 minutes, holding eyelids apart to ensurerinsing of the entire eye.

3 Contact a physician :Immediately wash affected area with soap and water. If irritationpersists, contact a :DO NOT INDUCE VOMITING. If victim is conscious, rinsemouth and give 1-2 glasses of water. Consult a physicianimmediately. Never give anything by mouth to an PREVENTATIVE MEASURESG loves: Wear nitrile or neoprene glovesEye Protection: Wear SAFETY glasses or Protective Equipment: As required to prevent contact with skin Controls: Local Exhaust:Not normally required. Use ventilating equipment if product is used in a confined area with poor and SpillProcedures:Small spills can be flushed down drain with plenty of spills should be absorbed with absorbent MATERIAL andplaced in suitable containers for disposal. Review Federal,Provincial and Local government regulations for Disposal:In accordance with Municipal, Provincial and Proceduresand Equipment:Remove and launder contaminated clothing.

4 Avoid breathing spray mists. Use appropriate protective equipment. Do not use on glass. Pre-test surfaces before first time use. Avoid contact with skin and :KEEP OUT OF REACH OF CHILDREN. Keep containersclosed. Keep from ADDITIONAL INFORMATIONTDG ShippingName:For drum package #230132: CORROSIVE LIQUIDS, (Sodium Metasilicate Solution) Class 8 UN 1760 PG III ;For 946ml package #230133: Limited Quantity Prepared by:Technical DepartmentDate:August 2005 Revision based on updated data from Suppliers