Material Safety Data Sheet - Propylene Glycol

1 Propylene Glycol - USP2/10 Safety data SheetValidation dateProduct and company identification::1 .Product nameMSDS #00033938 Product International Box 4980 The Woodlands, TX 77387 TELEPHONE NUMBERST ransportation/EmergencyCHEMTREC: (800) 424-9300 Technical Information:(281) 719-7780E-MAIL: case of emergencySpills Leaks Fire or Exposure Call Chemtrec: (800) 424-9300In Mexico: 01 800 00 214 00In Columbia: 01 800 91 6012:Enriching lives through innovationEnriching lives through innovationHazards identificationPhysical stateLiquid.: status:While this Material is not considered hazardous by the OSHA Hazard CommunicationStandard (29 CFR ), this MSDS contains valuable information critical to thesafe handling and proper use of the product.

2 This MSDS should be retained and availablefor employees and other users of this .GENERAL INFORMATIONRead the entire MSDS for a more thorough evaluation of the hazards.:Emergency overviewFOR EXCIPIENT USE HAZARD IF SWALLOWED - CAN ENTER LUNGS AND CAUSE PRODUCT IS NOT TO BE USED TO PRODUCE FOGS OR MISTS INTHEATRICAL, MUSICAL, OR OTHER ENTERTAINMENT hazard if swallowed. Can enter lungs and cause damage.: Propylene glycol57-55-660 - 100 Composition/information on ingredientsNameCAS number%3 .Page: 1/62/10 Glycol - USPWash out mouth with water. Move exposed person to fresh air. Aspiration hazard ifswallowed.

3 Can enter lungs and cause damage. Do not induce vomiting. Get medicalattention. Never give anything by mouth to an unconscious flush eyes with plenty of water, occasionally lifting the upper and lowereyelids. Check for and remove any contact lenses. Continue to rinse for at least 10minutes. Get medical attention if irritation contaminated skin with plenty of water. Remove contaminated clothing and medical attention if symptoms occur. Wash clothing before reuse. Clean shoesthoroughly before exposed person to fresh air. Keep person warm and at rest. If not breathing, ifbreathing is irregular or if respiratory arrest occurs, provide artificial respiration or oxygenby trained personnel.

4 Get medical attention if symptoms occur. If unconscious, place inrecovery position and get medical attention immediately. Maintain an open tight clothing such as a collar, tie, belt or aid measuresEye contactSkin contactInhalationIngestionNotes to physician:4 .Symptomatic and supportive therapy as needed. Following severe exposure medicalfollow-up should be monitored for at least 48 products may include the following materials:carbon oxidesUse an extinguishing agent suitable for the surrounding measuresProducts of combustionExtinguishing mediaPromptly isolate the scene by removing all persons from the vicinity of the incident if thereis a fire.

5 No action shall be taken involving any personal risk or without suitable a fire or if heated, a pressure increase will occur and the container may protectiveequipment for fire-fightersFire-fighters should wear appropriate protective equipment and self-contained breathingapparatus (SCBA) with a full face-piece operated in positive pressure mode.::5 .Special exposure hazards:None :Not suitable:Flash point:Closed cup: 99 C ( F)Flammable limits:Lower: : action shall be taken involving any personal risk or without suitable training. Evacuatesurrounding areas. Keep unnecessary and unprotected personnel from entering.

6 Do nottouch or walk through spilled Material . Put on appropriate personal protective equipment(see section 8).Stop leak if without risk. Move containers from spill area. Prevent entry into sewers,water courses, basements or confined areas. Wash spillages into an effluent treatmentplant or proceed as follows. Contain and collect spillage with non-combustible, absorbentmaterial sand, earth, vermiculite or diatomaceous earth and place in container fordisposal according to local regulations (see section 13). Dispose of via a licensed wastedisposal contractor. Note: see section 1 for emergency contact information and section13 for waste precautionsAccidental release measures:Avoid dispersal of spilled Material and runoff and contact with soil, waterways, drains andsewers.

7 Inform the relevant authorities if the product has caused environmental pollution(sewers, waterways, soil or air).Personal precautions:Methods for cleaning up:6 .Page: 2/62/10 Glycol - USPS tore in accordance with local regulations. Store in original container protected fromdirect sunlight in a dry, cool and well-ventilated area, away from incompatible materials(see section 10) and food and drink. Keep container tightly closed and sealed until readyfor use. Containers that have been opened must be carefully resealed and kept uprightto prevent leakage. Do not store in unlabeled containers. Use appropriate containmentto avoid environmental on appropriate personal protective equipment (see section 8).

8 Eating, drinking andsmoking should be prohibited in areas where this Material is handled, stored andprocessed. Workers should wash hands and face before eating, drinking and not ingest. Avoid contact with eyes, skin and clothing. Avoid breathing vapor or in the original container or an approved alternative made from a compatiblematerial, kept tightly closed when not in use. Empty containers retain product residue andcan be hazardous. Do not reuse and storageHandlingStorage::7 .Exposure controls/personal protectionUse a properly fitted, air-purifying or air-fed respirator complying with an approvedstandard if a risk assessment indicates this is necessary.

9 Respirator selection must bebased on known or anticipated exposure levels, the hazards of the product and the safeworking limits of the selected eyewear complying with an approved standard should be used when a riskassessment indicates this is necessary to avoid exposure to liquid splashes, mists protective equipment for the body should be selected based on the task beingperformed and the risks involved and should be approved by a specialist before handlingthis protectionEyesSkinRespiratoryConsult local authorities for acceptable exposure limits.:::Chemical-resistant, impervious gloves complying with an approved standard should beworn at all times when handling chemical products if a risk assessment indicates this :8.

10 Engineering controlsUse local exhaust ventilation to maintain airborne concentrations below the TLV. Suitablerespiratory equipment should be used in cases of insufficient ventilation or whereoperational procedures demand it. For guidance on engineering control measures referto publications such as the ACGIH current edition of 'Industrial Ventilation, a manual ofRecommended Practice.':Preventive MeasuresConditions of use, adequacy of engineering or other control measures, and actualexposures will dictate the need for specific protective devices at your workplace.:Physical and chemical properties9.