Medical Vacuum Systems: Lubricated Vane

1 Product Specification GENERAL The Chemetron Medical Vacuum system is designed to create a suction system to remove unwanted fluids or gases from hospital/laboratory working areas. The Medical Vacuum system package is compliant with the NFPA 99 requirements for Medical Vacuum . Note that larger systems are shipped on 2 or more skids and require connection of clearly labeled wiring and piping between skids once they are mounted on-site. Medical Vacuum SYSTEM The package shall include multiple Vacuum pumps and associated equipment, one ASME tank and one Medical control panel. Each pump is factory piped to a common intake manifold. The system shall be completely tested prior to shipment. Vibration isolation pads are included with the system. ROTARY VANE Vacuum PUMP The Medical Vacuum pumps shall be of the rotary vane air cooled design, and manufactured in the USA.

2 Each Vacuum pump shall be direct-driven through a shaft coupling by a TEFC electric motor. Belt drives shall not be permitted. Each Vacuum pump shall be air cooled and have absolutely no water requirements. Each Vacuum pump shall have an end (ultimate) Vacuum of " Hg (15 torr). Lubrication shall be provided by an integral, fully recirculating oil supply that is filtered by an automotive-type, spin-on oil filter. Non-recirculating (once-through) or partial recirculating oil supply systems shall not be permitted. Each Vacuum pump shall be capable of operation with standard SAE 30 weight oil. The oil separation systems shall be integral and shall consist of no less than three stages of internally installed oil and smoke eliminators through which the exhaust gas stream must pass. This system shall consist of bulk separation, oil mist elimination, and smoke elimination, and shall be capable of removing + percent of all oil and smoke particles from the exhaust gas stream.

3 Each Vacuum pump shall include a built-in anti-suck-back valve, mounted at the pump inlet, and three sliding vanes. Each Vacuum pump shall be equipped with a 10 micron inlet filter for removal of particulates. The Vacuum pumps shall be mounted on vibration isolators. MOTOR The motor is continuous duty, NEMA rated, C-face, TEFC, suitable for 208-230, or 460V, 3 phase, 60 hertz electrical operation. AIR RECEIVER The system shall include an ASME rated air receiver rated for 200 psi MAWP. The tank shall be equipped with a Vacuum gauge, block and by-pass valves, and a manual drain. CONTROL PANEL The system shall include a UL listed control panel in a NEMA 12 enclosure with the following accessories for each pump: externally operable disconnect, magnetic starter with 3-leg overload protection, Hand/Off/Auto lighted selector switch, minimum run timer to prevent short cycling of the pump, and hour meter.

4 Standard features shall also include a main power on light, timed lead/lag pump alternation, a reserve pump-in-use alarm with visual and audible indications, and duplex control circuit transformers with fused primary and secondary protection. All alarms shall have dry contacts on a labeled terminal strip for remote alarm monitoring, and an acknowledge pushbutton for horn silencing. The lag Vacuum pump shall be able to start automatically if the lead Vacuum pump fails to operate. AVAILABLE OPTIONS High discharge air temperature shutdown alarm with visual and audible indicators and dry contacts Oil temperature gauges Internal tank lining for corrosion resistance Tank sight gauge Medical Vacuum Systems: Lubricated Vane Medical Vacuum Systems: Lubricated Vane Product Specification Duplex Lubricated Vane Tankmount 1 - 10 hp 208V230V460 VDLV010-80T144802,5467010106730 DLV015-80T1-1/277803,8197011117730 DLV020-80T21111805,0927014148835 DLV030-80T31717807,63870191810894 DLV050-120T15262612012,730713028151,049 DLV050-120T25383812012,730713532161,077 DLV075-200T7-1/2525220019,095794443231,7 27 DLV100-200T10777720025,460815553282,165N o te s.

5 1 - HP a nd NF P A S ys te m C a pa c ity is s ho wn with o ne o r m o re pum ps in re s e rve pe r NF P A 992 - B TU/HR Le ve ls a re s ho wn with re s e rve pum p(s ) o n s ta ndby3 - dB (A) is s ho wn with o ne pum p in re s e rve pe r NF P A99 TANK SIZEBTU/HR2dB(A)3 LEVELSYSTEM WEIGHTSYSTEM p lex Lu b ricated VaneNFPA System Cap acitySCFM @ 19" Hg EachMO DELHP1 Product Specification Medical Vacuum Systems: Lubricated Vane Duplex Lubricated Vane Vertical 1 - 3 hp Product Specification Medical Vacuum Systems: Lubricated Vane Duplex Lubricated Vane Vertical 5 hp Product Specification Medical Vacuum Systems: Lubricated Vane Duplex Lubricated Vane Basemount 7-1/2 - 25 hp Product Specification Medical Vacuum Systems: Lubricated Vane Triplex Lubricated Vane Basemount 5 - 10 hp Product Specification Medical Vacuum Systems: Lubricated Vane Triplex Lubricated Vane Basemount 15 - 25 hp Product Specification Medical Vacuum Systems: Lubricated Vane Quad Lubricated Vane Basemount 5 - 25 hp All specifications are nominal and subject to change without notice.

6 Warranty: See Allied Statement of Warranties for details. 2009 Allied Healthcare Products, Inc. 1720 Sublette Avenue St. Louis, MO 63110 USA 314/771-2400 800/444-3954 ISO 13485: 2003 Construction Customer Service USA: 800/444-3960 FAX: 314/771-7537 Canada/Mexico: 800/446-0552 FAX: 800/246-6201 International: 314/268-1683 FAX: 314/771-5183 Medical Vacuum Systems: Lubricated Vane Form 62-00-3800 June 2009 Product Specification