MOTOR CONTROL CENTER AND TANK CONTROL PANEL

1 Navajo Area Indian Health Service Technical Provisions for MOTOR CONTROL CENTER and Tank CONTROL PANEL Version 3 MOTOR CONTROL CENTER AND TANK CONTROL PANEL TECHNICAL PROVISIONS TABLE OF CONTENTS SECTION DESCRIPTION PAGE TP General Information TP 1-1 TP COR Responsibilities TP 1-2 TP Contractor Responsibilities TP 1-3 TP Programmer Responsibilities TP 1-4 TP FCC License TP

2 1-4 TP Record Drawings TP 1-5 TP Performance Test TP 1-5 TP Warranty TP 1-7 TP General PANEL Requirements TP 2-1 TP PANEL Materials and Components TP 2-1 TP Operations and Maintenance Manual TP 2-1 TP Wiring TP 2-1 TP Surge Protection

3 TP 2-2 TP Enclosure TP 2-2 TP Site Conditions TP 2-2 TP AC Tank PANEL TP 3-1 TP Description of Operation TP 3-1 TP PANEL Materials and Components TP 3-1 TP Drawings TP 3-3 TP Solar Tank PANEL

4 TP 4-1 TP Description of Operation TP 4-1 TP PANEL Materials and Components TP 4-1 TP Drawings TP 4-3 TP PLC CONTROL PANEL TP 5-1 TP Description of Operation TP 5-1 TP PANEL Materials and Components TP 5-1 TP Drawings TP 5-4

5 TP Starter Panels TP 6-1 TP Description of Operation TP 6-1 TP Simplex with Magnetic Starter TP 6-1 TP Duplex with Magnetic Starters TP 6-4 TP Simplex with Soft Starter TP 6-5 TP Duplex with Soft Starters TP 6-9 TP Simplex with Phase Converter TP 6-10 TP Appendix TP 7-1 TP

6 Conductor Color Code TP 7-1 TP PLC CONTROL PANEL Test Sheet TP 7-2 TP Starter PANEL Test Sheet TP 7-3 TP Radio Test Sheet TP 7-4 TP Tank Transducer Form TP 7-5 TP Pumphouse Wiring TP 8-1 TP General Information These Technical Provisions set forth the minimum requirements for fabricating and installing a radio telemetry

7 Operated MOTOR CONTROL system for the water system. The water system is located (see attached map). Items required by these specifications shall be installed at the pumphouse(s) and tank(s) as noted on the attached map. One hundred twenty (120) volts is (is not) available at the tank site(s). Under these Technical Provisions the Contracting Officer s Representative (COR) is a representative of the Indian Health Service s Office of Environmental Health and Engineering.

8 The Contractor is the person or persons, partnership, firm, or corporation who enters into the contract awarded by the Navajo Engineering and Construction Authority (NECA). The Programmer is a representative of the Navajo Tribal Utility Authority (NTUA) who is responsible for programming the CONTROL system. Although these Technical Provisions require the installation of certain components, it shall be the Contractor s responsibility to build and install a complete and operational MOTOR CONTROL CENTER (MCC), tank CONTROL PANEL and radio CONTROL system using the required components.

9 In addition, the Contractor shall provide the COR with the operation and maintenance manuals as described in TP Payment shall be made after performance of the system is tested as described in TP Upon completion of the installation, the Programmer shall complete all software programming required for MOTOR CONTROL operation. The MCC consists of two