Transcription of nUCOr Fastener shear strength
1 shear strengthteChnICaL data sheetnUCOr FastenerShear strength is defined as the maximum load typically applied normal to a Fastener s axis that can be supported prior to fracture. Single shear is load applied in one plane that would result in the Fastener being cut into two pieces, while double shear would result in three Fastener pieces. Single shear values for fasteners are typically calculated based upon the nominal body diameter or body shear area, BSA. See the definitions following the table below. An appropriate factor of safety must be applied to the calculated Single shear strength values by the Engineer of Record. TDS-013 2-18-08 shear PLANESINGLE SHEARPPSHEAR PLANEDOUBLE SHEARPSHEAR PLANEPS hear configurationSNomiNal Bolt DiameterBoDy shear area, Sq iNGr 2a307a & BGr 5 / a325Gr 8 / a4901/4" , , , , " , , , , " , , , , " , , , , " , , , , " , , , , " , , , , " , , , , " , , , , " , , , , 1/8" , , , , 1/4" , , , , : > Ultimate Tensile strength , UTS - PSi - Lbs/Square inch > Ultimate shear strength , USS - PSi USS =.
2 6 X UTS > Body shear Area, BSA - Square inches > Single shear strength , SSS - Lbs SSS = USS X BSANomiNal Bolt DiameterGr 2a307a & BGr 5 / a325Gr 8 / a4901/4"74,00060,000120,000150,0005/16"7 4,00060,000120,000150,0003/8"74,00060,00 0120,000150,0007/16"74,00060,000120,0001 50,0001/2"74,00060,000120,000150,0009/16 "74,00060,000120,000150,0005/8"74,00060, 000120,000150,0003/4"74,00060,000120,000 150,0007/ 8 "60,00060,000120,000150,0001"60,00060,00 0120,000150,0001 1/8"60,00060,000105,000150,0001 1/4"60,00060,000105,000150,000 Single shear calculationS, Min. lbSultiMate tenSile strength , PSitoDay , that little n meaNS BiG thiNGS! This Technical data sheet is subject to change without prior notificationPo Box 6100 | St. Joe, indiana 46785 | ph: (800) 955-6826 or (260) 337-1726 | fax: (260) 337-1726 |