OSHA Training Institute Construction Focus Four: Outreach ...

1 osha Directorate of Training and EducationApril 2011 osha Training Institute Construction Focus four : Outreach Training Packet Construction Focus four : Outreach Training Packet Module Training Materials Introduction Lesson 1 Construction Focus four : Fall Hazards Lesson 2 Construction Focus four : Caught In or Between Hazards Lesson 3 Construction Focus four : Struck By Hazards Lesson 4 Construction Focus four : Electrocution Hazards osha Directorate of Training and Education April 2011 osha Training Institute Construction Focus four : Introduction Outreach Training PACKET Table of Contents Welcome ..1 Focus four Training Packet Outreach Trainer Setting the Participatory Principles of Adult Training Tips and Structure of Focus four Lessons.

2 4 Important Note:..5 Disclaimer:..5 osha 29 CFR 1926 Subpart C Key Construction Focus four Module Introduction April 2011 1 Welcome The Construction Focus four Module was developed in support of the Occupational Safety and Health Administration ( osha ) Construction Outreach Program s effort to help workers in the Construction industry understand the hazards they face and know what their employer s responsibilities are regarding protecting workers from workplace hazards. This Training module is required to be used in both the 10- and 30-hour osha Construction Outreach Training Program classes. Construction safety is one of osha 's top concerns.

3 Construction is among the most dangerous industries in the country and Construction inspections comprise 60% of osha 's total inspections. In 2009, preliminary data from the Bureau of Labor Statistics indicate that there were 816 fatal on-the-job injuries to Construction workers more than in any other single industry sector and nearly one out of every five work-related deaths in the that year. Also in 2009, private industry Construction workers had a fatal occupational injury rate nearly three times that of all workers in the United States: per 100,000 full-time equivalent Construction workers vs. for all workers. The data support osha s concern and thus the need for the development of this robust set of Construction Focus four Module Training materials.

4 Authorized Outreach Trainers will find that the materials present detailed content in a participatory format to enhance the effectiveness of their Training sessions. Trainers will also find the information provided in this Introduction section helpful when planning their Training sessions. In addition to program requirements, Training development considerations including Training tips and techniques are provided. Plus, the attachment included provides a quick reference to the key paragraphs within the osha Construction Industry standard 29 CFR 1926 Subpart C General Safety and Health Provisions . Another general Construction reference trainers should become familiar with is osha s Construction Industry Digest.

5 This booklet contains standards most frequently overlooked by the employer and standards covering particularly hazardous situations in Construction . Copies of this publication are available for download at: [Note: Trainers are encouraged to check regularly to ensure they have the most current osha published information.] Focus four Training Packet Includes Materials: Instructor/Student materials for the four lessons: Fall Hazards; Caught-In or -Between Hazards; Struck-By Hazards; and Electrocution Hazards. o For each of the lessons, there is an Instructor Guide with lesson test, PowerPoint presentation file(s), and student handouts ( , job aids, checklists) as developed.

6 DVD: Video Construction Safety: Choice or Chance ( BCTD, 2000. Used with permission. All rights reserved. Building and Construction Trades Department) as an option to consider to begin the Focus four section. The video is also available: o On the osha website at: o From the Resource Center Outreach Trainer Requirements Planning: This Construction Focus four Module is mandatory for both 10- and 30-hour Construction Outreach courses. Trainers should plan to use the materials as follows: 10-hour course = 4 hours minimum Note: Because most Construction fatalities are caused by fall hazards, falls must be covered for at least one hour and 15 minutes.

7 The other Focus four hazards must be covered for a minimum of one-half hour each. 30-hour course = 6 hours minimum [trainer can determine time of each lesson using the 10 hour course estimates as the minimum time required] Construction Focus four Module Introduction April 2011 2 Requirements for using the Construction Focus four Training materials: Plan the Focus four lessons to fit within the 10- or 30- hour course Review all materials prior to implementing this Training Present content to meet the stated goal and objectives of each of the lessons Follow the participatory Training model [explained in section below] by applying effective Training techniques Test the student s achievement of the objectives Authorized Trainers may: Use their own content and/or supplemental materials to deliver the content per each stated objective.

8 Note that the use of the BCTD video provided is also optional Use the Questions for Review provided as the lesson test or the trainer may develop their own set of test questions to measure the student s achievement of the stated objectives Edit the PowerPoint presentations to meet the needs of their specific Training context, audience and/or environment Setting the Stage To begin the series of instruction, trainers have the option to play the video Construction Safety: Choice or Chance ( BCTD, 2000. Used with permission. All rights reserved.) developed by the Building and Construction Trades Department. This 15-minute video highlights the four leading causes of fatalities on Construction sites and stresses the responsibility for safety as a joint effort of government, management, and employees.

9 osha (2000, April). State the course objectives so the participants are aware of the Training expectations and continue the 4-hour session by presenting the four lessons: Fall Hazards; Caught-In or -Between Hazards; Struck-By Hazards; and Electrocution Hazards. Become familiar with the information that is provided in the Trainer Guidance section of each instructor guide. Also, when using the instructor guide, remember the information in the Notes column offers trainer s reference and/or additional information regarding the topic or standard. The trainer can use this space to add their own notes on the Training . Participatory Model The application of the participatory model principles and structure was a main Focus during the development of the Construction Focus four Module.

10 The model s approach draws on the participants own experiences. Conducting the active Training encourages teamwork and group problem solving. Participants have the opportunity to analyze health and safety problems in a group and develop possible solutions. The majority of the time, this results in valuable exchanges between workers and trainers about their lives and work. Participatory methods are effective instructional strategies that work quite well for all audiences, including those who have difficulty reading and writing. Conducting the active Training also allows time for instructor observation of the class. This helps the trainer determine who may be having difficulty with the concepts thus letting the trainer know if adjustments to their presentation are necessary.