Owner’s Manual - SpeeCo

1 KINETIC LOG SPLITTERASSEMBLY & OPERATING INSTRUCTIONSO wner s ManualModel Number580899 WARNING: All operators must read this Manual before operating this log splitter. Follow the safety instructions in the Manual and in decals attached to the product. Failure to do so could result in serious injury or of Contents Page(s)Important Safety Information 1-4 Intended Use 1 Personal Protective Equipment 1 Safety Decals 2 General Safety 3 Work Area 3 Preparation of the Log 3 Operation of the Log Splitter 3 General Maintanence 4 Workplace Safety 4 Towing Safety 4 Assembly Instructions 5-13 Replacement parts

2 14-19 Operating Instructions 20-21 Towing 22 Warranty information 23 Specifications Back CoverThis is the SAFETY ALERT SYMBOL. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. BEFORE operating this log splitter, make sure that you wear safety gear such as goggles or safety glasses, steel toed shoes and tight fitting gloves (without loose cuffs or draw strings). Always wear a protective hearing device when operat-ing this log use this log splitter for any other purpose than splitting wood. It is designed for this use only. Any other use can cause serious injury or death.

3 PERSONAL PROTECTIVE EQUIPMENTINTENDED USENEVER wear loose clothing or jewelry that can be caught by moving parts of the log splitter. Keep clothing and hair away from all moving parts when operating this log 1 WARNING: Read and thoroughly understand all instructions in this Manual and on safety decals before assembling or operating this log splitter. Failure to do so may cause serious injury or death. Do not allow anyone to operate this log splitter who has not read this Manual . As with all power equipment, a log splitter can be dangerous if assembled or used improperly. Do not operate this log splitter if you have any questions concerning safe operation. To get answers to any questions, call our technical support department at NUMBER: 580386 LOCATION: TOP OF BEAM, UNDER SHIELDSAFETY DECALSMake sure that all safety warning decals are in good condition and readable.

4 Always replace missing or defaced decals. Contact SpeeCo at 1-800-525-8322 for replacement decals. PART NUMBER: 580388 LOCATION: TOP OF SHIELDPART NUMBER: 580387 LOCATION: TOP OF TONGUEPART NUMBER: 581696 LOCATION: TOP OF SHIELDPART NUMBER: S52062500 LOCATION: SIDE OF TOUNGEPART NUMBER: S52069100 LOCATION: FRONT OF SWING STAND (1), SIDES OF BEAM (2)Page 2 PART NUMBER: 584052 LOCATION: SIDE OF BEAM, TOWARD REARGENERAL SAFETY ALWAYS keep the operator s Manual nearby for reference. Reread the Manual periodically. ALWAYS establish a safety zone restricting bystanders to a 10 foot radius around the log splitter when log splitter is in operation. ALWAYS ensure that all operators are properly trained and have read and understand the operator s Manual . ALWAYS operate the log splitter with a clear mind, free of the influence of alcohol, drugs or medication.

5 ALWAYS wear close fitted clothing, free from lanyards, strings or jewelry which could be an entrapment hazard. ALWAYS keep clothing and hair away from moving parts. ALWAYS keep safety shields in place during operation. NEVER manually move the splitter uphill or OF THE LOGBoth ends of the log should be cut as square as possible to help prevent the log from riding out of the splitter duringoperation. Do not split logs greater than 24 inches in AREA ALWAYS operate this log splitter on firm level ground. ALWAYS wear proper footwear with adequate traction. ALWAYS operate your log splitter in an open area. (Exhaust fumes contain carbon monoxide which can be deadly when inhaled.) ALWAYS operate your log splitter on level ground. (Operating on a slope could cause the log splitter to roll over or logs to fall off.) ALWAYS properly chock the wheels to prevent movement of the log splitter while in operation.

6 ALWAYS operate your log splitter in daylight or under good artificial light. ALWAYS keep the work area clean. Remove split wood around your log splitter immediately so that you don t stumble over OF THE LOG SPLITTERThe log splitter is designed for a single operator, who stands in the operator zones , using the hand closest to the log to operate the safety latch, and the other hand to press the control handle. Failure to operate the log splitter in this position can result in serious injury or death. ALWAYS load the log onto the beam up against the wedge. ALWAYS be careful when moving or lifting the log splitter. Get help if unit is too heavy to move by yourself. ALWAYS properly chock the wheels to prevent movement of the log splitter while in operation. NEVER place hands, body parts or clothing under the shields during operation. Moving parts could cause entanglement.

7 KNOW how to stop the log splitter and disengage the controls before operating it. NEVER place hands or feet between the log and splitting wedge during forward or reverse stroke as this could result in serious injury or death. NEVER straddle or step over the log splitter during operation. NEVER reach or bend over the log splitter to pick up a log. NEVER try to split two logs on top of each other. NEVER try to cross split a log. NEVER attempt to load your log splitter when the ram or wedge is in motion. NEVER use your foot, a rope or any extension device to operate the controls. Only use both hands. NEVER move the log splitter while the engine is running. ALWAYS shut off the engine even if you are leaving the log splitter for a short period of time. NEVER touch the muffler and other hot areas of the engine during operation. Wait until the engine cools down.

8 ALWAYS make sure the engine is turned off while routinely cleaning debris from splitter, work area and engine ALWAYS make sure the leg is secured in the down position. ALWAYS make sure the tongue is fully retracted prior to splitting. NEVER use this log splitter for any other purpose than splitting 3 Failure to follow these instructions may result in injury or ZONE NEVER operate your log splitter when it is in poor mechanical condition or in need of repair. NEVER modify your log splitter in any manner. Such alterations may cause your log splitter to be unsafe and will void the warranty. NEVER tamper with the engine to run it at excessive speeds. The maximum engine speed is preset by the manufacturer and is within safety limits. See engine owner s Manual . Altering the speed setting will void the manufacturer s warranty. ALWAYS perform all recommended maintenance procedures before using your log splitter.

9 ALWAYS replace all damaged or worn parts immediately. ALWAYS remove the spark plug wire before performing any service or repair on your log splitter. ALWAYS check the level of the engine oil before operation. ALL replacement parts must meet manufacturer s specifications PERIODICALLY place a light amount of grease across the top of the rack. PERIODICALLY clean all splinters and wood debris from rack teeth and reapply grease. SEASONALLY grease the pinion bearings. PERIODICALLY check that all nuts, bolts, and screws are tight before operation. ALWAYS check the drive belts before use for condition, wear and proper belt tension. PERIODICALLY clean and lightly oil the top of the beam. ALWAYS soak the bronze clutch bushing in light weight oil at the start of every season and after every 100 hours of use. SEVERAL times throughout the splitting season check that the rack lift bearing is clean and free to turn.

10 If not, clean the bearing and support bolt and insert grease into the support bolt until bearing freely turns. ALWAYS check all local and state regulations regarding towing, licensing, and lights before towing your log splitter. ALWAYS check before towing to make sure that the log splitter is correctly and securely attached to the towing ve-hicle and that the safety chains are secured to the hitch or bumper of the vehicle with enough slack to allow turning. Always use a Class I, 2 ball with this log splitter. ALWAYS confirm coupler tightness each time before towing and after towing 50 miles. ALWAYS disconnect your log splitter from the towing vehicle before operating it. ALWAYS be careful when backing up with your log splitter in tow. It could jackknife. ALWAYS allow for added length of your log splitter when turning, parking, and crossing intersections and in all driving situations.