Programming and Troubleshooting Guide Mastercode 2 ...

1 2015 Spectrum Brands, and Troubleshooting GuideMastercode 2 Troubleshooting : installation 8 Troubleshooting : Door Jamming and Door Handing 9 Troubleshooting : Keypad 13 Troubleshooting : Battery 14 Battery FAQ 151 / 1562810 / 01 USA: 1-800-677-5625 Canada: 2015 Spectrum Brands, a Mastercode is an optional, added-security measure. It is not enabled by default. A Mastercode is used to add and delete user codes, but it cannot unlock the door (unless the same code is programmed as a user code, though this is not recommended). The Mastercode must be 4-8 timeout: If no button is pressed for fi ve seconds, the system will time out (indicated by three beeps and a red fl ashing keypad), and you will need to restart the Keep door open.

2 Press and HOLD the Program button until the keypad fl ashes green (about 5 seconds).2. Enter new Press Lock button Re-enter Press Lock button Programming is successful, the keypad will flash green once with one beep. If Programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure the Mastercode has not already been programmed. Attempt the procedure again, making sure to enter the same new Mastercode in step 2 and Make sure switch #3 is on, and press the Program button once. If you hear three beeps and see the keypad fl ash green, the Mastercode is : The lock will time out after fi ve / 1562810 / 01 USA: 1-800-677-5625 Canada: the MastercodeEnabling and Setting the Mastercode 2015 Spectrum Brands, procedure for adding user codes is different when the Mastercode is enabled.

3 For instuctions on how to add user codes when the Mastercode is disabled, see the installation and User Guide that came with your Keep door open. Press the Program button once. The keypad will fl ash green and you will hear three Enter Press Lock button Enter new user Press Lock button Programming is successful, the keypad will flash green once with one beep. If Programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure the user code is not a duplicate and that it is between 4 and 8 digits during your next attempt. Make sure the lock has room for an additional code. If all user codes are fi lled, delete a code to make room for this one.

4 Make sure to enter a valid Mastercode in step While the door is open and locked, test the user code to make sure it unlocks the / 1562810 / 01 USA: 1-800-677-5625 Canada: User Codes with the Mastercode Enabled 2015 Spectrum Brands, Keep door open. Press the Program button once. The keypad will fl ash green and you will hear three Press Lock button Enter Press Lock button Enter user code to be Press Lock button Re-enter user code to be Press Lock button continued on next page4 / 1562810 / 01 USA: 1-800-677-5625 Canada: a Single User Code with the Mastercode Enabled 2015 Spectrum Brands, Programming is successful, the keypad will flash green once with one beep.

5 If Programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure to enter the same valid code in steps 5 and 7. Make sure to enter a valid Mastercode in step While the door is open and locked, test the user code to make sure it no longer unlocks the Keep door open. Press the Program button once. The keypad will fl ash green and you will hear three Press Lock button Enter Press Lock button Press 9 six Press Lock button continued on next page5 / 1562810 / 01 USA: 1-800-677-5625 Canada: All User Codes with the Mastercode Enabled 2015 Spectrum Brands, Press 9 six Press Lock button Programming is successful, the keypad will flash green once with one beep.

6 If Programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure to enter a valid Mastercode in step 3 during your next attempt. 9. Press the Lock button while the door is open and unlocked. If the latch bolt does not extend to lock, then all codes have been successfully / 1562810 / 01 USA: 1-800-677-5625 Canada: 2015 Spectrum Brands, Keep door open. Press and HOLD the Program button until the keypad fl ashes green (about 5 seconds).2. Press Lock button Enter Press Lock button Re-enter Press Lock button Programming is successful, the keypad will flash green once with one beep. If Programming is unsuccessful, the keypad will fl ash red three times with three beeps.

7 Make sure the Mastercode has been enabled before trying to disable it. Attempt this procedure again, making sure to enter the same Mastercode in steps 3 and 5. 7. Make sure switch #3 is on, and then press the Program button once. If you don t immediately hear three beeps and see the keypad fl ash green, the Mastercode is : The lock will time out after fi ve / 1562810 / 01 USA: 1-800-677-5625 Canada: and Deleting the Mastercode 2015 Spectrum Brands, : InstallationIf you encounter any of the problems above, the deadbolt latch may be installed upside down. Remove the interior assembly, mounting plate, and exterior assembly from the door, and look at the latch inside the door the word UP is upside down and at the bottom of the latch, the latch is installed incorrectly.

8 Reinstall the latch, making sure the word UP faces upward. 8 / 1562810 / 01 USA: 1-800-677-5625 Canada: interior mounting screws are diffi cult to interior and exterior assembly won t mount parallel to the door interior assembly does not fi t on the mounting plate. 2015 Spectrum Brands, : Door Jamming and Door HandingThe door handing process was not executed during the door handing process in the installation hole in the door is the lock, and reinstall it without the adapter ring on the exterior side of the door. The wrong deadbolt latch is deadbolts require a tapered latch bolt for ease of operation. If the latch being used is from an older lock, it will likely not have a tapered latch bolt.

9 Remove the lock from the door, including the old latch. Replace with the new tapered latch that came with the lock and reinstall the lock. The deadbolt latch and strike are misaligned, causing the latch to the tab of the lower strike (for your knob or lever) to help align the upper latch and strike so that the latch bolt enters the strike when the door is lower latch and lower strike (for your knob or lever) are misaligned, putting too much load on the deadbolt a test, rotate the turnpiece on the deadbolt so the latch is retracted (unlocked), and close the door. If you have to push, pull or lift the door to get it to close, adjust the position of the lower strike.

10 9 / 1562810 / 01 USA: 1-800-677-5625 Canada: lock jams and the turnpiece does not rotate lock beeps, the keypad fl ashes red, and the door cannot lock. 2015 Spectrum Brands, hole in the door frame for the latch bolt is not drilled deep sure the hole in the door frame is drilled at least 1 (25 mm) deep. The mounting plate is placing tension on the torque to lock and unlock the door with the key. If it is unable to rotate, remove the interior assembly from the mounting plate. Test the key again. If it is still unable to rotate, loosen the screws on the mounting plate and reposition the plate so there is no tension on the cylinder torque blade.