Transcription of Real Pro's WIRE FORMING TOOL INSTRUCTIONS
1 Real Pro's wire FORMING tool INSTRUCTIONSTo Make a Closed EYE Loop1. Place your wire shaft between pinswith short end pointed up. Bend longend around tall pin in counter clock-wise direction about of a revolu-tion (270 degrees) to from Remove wire shaft. Place eye ofshaft over pin on crank with shortend up and long end through slot inhead. Turn crank clockwise slowlyso that short end of shaft slides intogrove on With short end engaged in groove,push crank toward head and turnclockwise at the same time. Con-tinue turning crank until short end ofwire is completely wrapped aroundshaft.
2 You will hear a click whenthis Make an Open EYE wire shaft between pins withshort end pointed to the left. Bendshort end away from you to form a 30degree angle. Leave at least 5/8"between short end and long end around tall pin inclockwise manner until it stops atshort pin. wire will spring wire loop around tall pin andswing back to right until long end hitsshort pin. Apply pressure to placekink in long loop should look like #4. Toclose this type of loop use a plasticbead or use a coil spring or write for your free tackle kit &component catalogue:Real Pro's SportFishingPO Box 17 Hepworth, Ontario N0H 1P0 Tel.
3 (519) 371-3766 Fax: (519) 371-3754
