S40-70FT SERIES TECHNICAL GUIDE - Hyster

1 S40-70FT SERIESTECHNICAL DIMENSIONSC ircled dimensions correspond to the line numbers on the tabulated chart inside the TECHNICAL GUIDE . Dimensions are in inches (millimeters). (645) (350) (300) (929) (914) S40-70FT (1178)S55 FTS (1231)Non-suspensionSemi-suspensionFull- suspension Std. (1067) (1079) (1067)Opt. (1000) (1012) (112) Forward5 BackMODELLIFT CAPACITYLOAD CENTERPRlb (kg)in (mm)in (mm)percentS40FT4000 (1814)24 (610) (418)50%S50FT5000 (2268)24 (610) (472)45%S55 FTS5500 (2495)24 (610) (405)47%S60FT6000 (2721)24 (610) (541)39%S70FT7000 (3175)24 (610) (591)39%3S40-55FT SPECIFICATIONSRL = Rated Load NL = No LoadNOTE: Above specifications, unless otherwise listed, are for a standard truck without optional equipment.

2 Right Angle Stack and Equal Intersecting Aisle are calculated using a 40 wide : Performance specifications / ratings are for truck equipped as described under Standard Equipment in this TECHNICAL GUIDE . Performance specifications are affected by the condition of the vehicle and how it is equipped, as well as by the nature and condition of the operating area. Specifications are subject to change and the proposed application should be discussed with your authorized Hyster Company : Hyster lift trucks meet the design and construction requirements of , per OSHA Section (a)(2), and also comply with the revision in effect at time of manufacture.

3 Certification of compliance with the applicable ANSI standards appears on the lift NameHyster Company2 ModelS40 FTS50 FTS55 FTSE nginePSI Capacitylb (kg)4000 (1814)5000 (2268)5500 (2495)4 Load Center, Distancein (mm) (610) (610)5 Power Type - LPG, Diesel, Dual FuelLPGDual FuelLPGLPGDual FuelLPGLPGDual FuelLPG6 Operator TypeSit-Down RiderSit-Down Rider7 Step Heightin (mm) (350) (350)8 Tire Type - Cushion, Solid, PneumaticCushionCushion9 Wheels, Number - Front / Rear 2x/22x/2 DIMENSIONS10 Lift Height, Top of Fork (TOF)in (mm)129 (3292)129 (3292)11 Lift Heights, Std. Limited Free Lift (LFL) w/o LBR (TOF) in (mm)5 (140)5 (140)Lift Heights, Optional Full Free Lift (FFL) w/o LBR (TOF)in (mm)62 (1575)62 (1575)12 Standard Carriage Widthin (mm) (980) (980)13 Forks, Thickness x Width x Lengthin X X X X 42 Forks, Thickness x Width x Length(mm)(40 X 100 X 1067)(40 x 100 x 1067)14 Fork Spread, Outside Dimensions in (mm) (974) (974)15 Mast Tilt Angles, Forward / Backwarddegrees5F/5B5F/5B16 Length To Face of Forksin (mm) (2238) (2291) (2228)17 Overall Width, Standard Treadin (mm) (1067) (1108)Overall Width, Wide Treadin (mm) (1242) (1242)18 Height, Standard Mast - Loweredin (mm)85 (2135)

4 85 (2135)19 Height, Standard Mast - Extended with LBRin (mm)178 (4515)178 (4515)Height, Standard Mast - Extended without LBRin (mm)151 (3840)151 (3840)20 Height, Standard Overhead Guard in (mm)84 (2128)84 (2128)Height, Optional Overhead Guard in (mm)82 (2061)82 (2061)21 Turning Radius, Minimum Outside (OTR)in (mm) (1950) (2000) (1937)22 Length, Center of Wheel to Face of Forksin (mm) (390) (390)23 Aisle Width, Right Angle Stack (Add Length of Load) in (mm) (2340) (2390) (2327)24 Equal Aisle, 90-Degree Intersecting Aislein (mm) (1875) (1897) (1885)PERFORMANCE25 Travel Speed, Powershift Transmission RL/NLmph (km/h) ( ) ( ) ( ) ( ) ( ) ( )26 Lift Speed, Standard 2-Stage LFL RL/NLft/min (m/s)120/124 (.)

5 61/.63)122 /126 (.62/.64)120/124 (.61/.63)122 /126 (.62/.64)120/124 (.61/.63)124 /126 (.63/.64)Lift Speed, Optional 2-Stage FFL RL/NLft/min (m/s)106/110 (.54/.56)106/112 (.54/.57)106/110 (.54/.56)106/112 (.54/.57)106/110 (.54/.56)108/112 (.55/.57)Lift Speed, Optional 3-Stage FFL RL/NLft/min (m/s)112/116 (.57/.59)114/120 (.58/.61)112/116 (.57/.59)114/120 (.58/.61)112/116 (.57/.59)116/120 (.59/.61)Lift Speed, Optional 4-Stage FFL RL/NLft/min (m/s)120/124 (.61/.63)122/126 (.62/.64)120/124 (.61/.63)122/126 (.62/.64)120/124 (.61/.63)122/126 (.62/.64)27 Lowering Speed, Standard 2-Stage LFL RL/NLft/min (m/s)114/98 (.58 /.50)114/98 (.58 /.

6 50)Lowering Speed, Optional 2-Stage FFL RL/NLft/min (m/s)98/83 (.50 /.42)98/83 (.50 /.42)Lowering Speed, Optional 3-Stage FFL RL/NLft/min (m/s)106/93 (.54 /.47)106/93 (.54 /.47)Lowering Speed, Optional 4-Stage FFL RL/NLft/min (m/s)108/73 (.55 /.37)108/73 (.55 /.37)28 Maximum drawbar pull RL/NLlb (kg)5322/1764 (2414/800)4680/1764 (2123/800)5282/1676 (2396/760)4643/1676 (2106/760)5260/1676 (2386/760)4623/1676 (2097/760)Drawbar Pull, Standard Transmission @ 1 mph RL/NL4453/1764 (2020/800)4050/1764 (1837/800)4418/1676 (2004/760)4012/1676 (1820/760)4398/1676 (1995/760)3993/1676 (1811/760)29 Gradeability, Standard Transmission @ 1 mph RL/NL%39/2435/2433/2130/2131/2028/20W , Standard Truck (2-Stg.

7 LFL) NLlb (kg)7803 (3539)8587 (3895)9113 (4134)Weight, Standard Truck (2-Stg. LFL) RLlb (kg)11803 (5554)13587 (6163)14613 (6628)32 Axle Loading, Static Front / Rear NLlb (kg)3570/4233 (1619/1920)3402/5185 (1543/2352)3454/5659 (1567/2567)Axle Loading, Static Front / Rear RLlb (kg)10366/1437 (4702/652)11897/1690 (5396/767)12799/1814 (5806/823)TIRES & WHEELS33 Tire Size, Front21 X 7 x 1521 X 8 x 1534 Tire Size, Rear16 x 5 x x 6 x (mm) (1430) (1430)37 Ground Clearance, Lowest Point NL (w/RL subtract 6mm)in (mm) (91) (91)38 Ground Clearance, Center of Wheelbase NLin (mm) (125) (125)39 Service Brake - Method of Control / OperationFoot/HydraulicFoot/Hydraulic40 Parking Brake - Method of Control / OperationHand/MechanicalHand/MechanicalP OWERTRAIN41 Battery TypeMaintenance FreeMaintenance Free42 Volts / Cold Cranking Ampsv / cca12/47512/47543 Engine, Manufacturer / ModelPSI Output @ Rated RPMhp (kw)59 (44) @ 270059 (44) @ 250059 (44) @ 270059 (44) @ 250059 (44) @ 270059 (44) @ 250045 Torque @ Rated RPMft Lbs (kg/m)121 ( ) @ 2000131 (18) @ 1000121 ( ) @ 2000131 (18) @ 1000121 ( ) @ 2000131 (18) @ 100046 Number of Cylinders / DisplacementNo / cc (ci)4/2351 (143)4/2491 (152)4/2351 (143)4/2491 (152)

8 4/2351 (143)4/2491 (152)47 Transmission Type, StandardElectronic PowershiftElectronic PowershiftStandard Speeds, Forward - Reverse 1-11-149 Hydraulic Tank Capacity (Drain and Refill)gal (liter) ( ) ( )50 Fuel Tank Capacity (Dual Fuel - Gasoline )gal (liter) ( ) ( ) ( )NA51 Auxiliary Hydraulic Pressure Relief for AttachmentsPSI (Mpa)2250 ( )2250 ( )4S60-70FT SPECIFICATIONSRL = Rated Load NL = No LoadNOTE: Above specifications, unless otherwise listed, are for a standard truck without optional equipment. Right Angle Stack and Equal Intersecting Aisle are calculated using a 40 wide : Performance specifications / ratings are for truck equipped as described under Standard Equipment in this TECHNICAL GUIDE .

9 Performance specifications are affected by the condition of the ve-hicle and how it is equipped, as well as by the nature and condition of the operating area. Specifications are subject to change and the proposed application should be discussed with your authorized Hyster Company : Hyster lift trucks meet the design and construction requirements of , per OSHA Section (a)(2), and also comply with the revision in effect at time of manu-facture. Certification of compliance with the applicable ANSI standards appears on the lift NameHyster Company2 ModelS60 FTS70 FTEnginePSI Capacitylb (kg)6000 (2722)7000 (3175)4 Load Center, Distancein (mm) (610)5 Power Type - LPG, Diesel, Dual FuelLPGDual FuelLPGLPGDual FuelLPG6 Operator TypeSit-Down Rider7 Step Heightin (mm) (350)8 Tire Type - Cushion, Solid, PneumaticCushion9 Wheels, Number - Front / Rear 2x/2 DIMENSIONS10 Lift Height, Top of Fork (TOF)in (mm)126 (3209)11 Lift Heights, Std.

10 Limited Free Lift (LFL) w/o LBR (TOF) in (mm)5 (150)Lift Heights, Optional Full Free Lift (FFL) w/o LBR (TOF)in (mm)58 (1490)12 Standard Carriage Widthin (mm) (980)13 Forks, Thickness x Width x Lengthin X X 42 Forks, Thickness x Width x Length(mm)(50 X 125 X 1067)14 Fork Spread, Outside Dimensions in (mm) (974)15 Mast Tilt Angles, Forward / Backwarddegrees5F/5B16 Length To Face of Forksin (mm) (2373) (2429)17 Overall Width, Standard Treadin (mm) (1108) (1158)Overall Width, Wide Treadin (mm) (1242)18 Height, Standard Mast - Loweredin (mm)87 (2185)19 Height, Standard Mast - Extended with LBRin (mm)175 (4435)Height, Standard Mast - Extended without LBRin (mm)152 (3855)20 Height, Standard Overhead Guard in (mm)84 (2128)Height, Optional Overhead Guard in (mm)82 (2061)21 Turning Radius, Minimum Outside (OTR)in (mm) (2066)22 Length, Center of Wheel to Face of Forksin (mm) (402) (402)23 Aisle Width, Right Angle Stack (Add Length of Load) in (mm) (2468) (2521)24 Equal Aisle, 90-Degree Intersecting Aislein (mm) (1943) (1986)PERFORMANCE25 Travel Speed, Powershift Transmission RL/NLmph (km/h) ( ) ( ) ( ) ( )26 Lift Speed, Standard 2-Stage LFL RL/NLft/min (m/s)104/108 (.)