SAFETY DATA SHEET - Crafco

1 SAFETY data SHEET1. IdentificationRoadsaver, Polyflex, Parking Lot, Asphalt Rubber, DF, Superflex, Matrix Binder, LoopDetector, Joint Adhesive, Polyfiber, Fiber Asphalt, Marker Adhesive, Quikstix, AsphaltAdhesive, PCF 100, High Slope, QWIKSEAL, QWIKDOT, Joint BinderProduct means of identificationPavement Crack and Joint Sealing and PreservationRecommended useNone restrictionsManufacturer/Importer/Suppli er/Distributor informationManufacturer: Crafco , :6165 West Detroit , AZ 85226 USAC ontact Name:Jim (North America)+ 1-703-527-3887 (International)2. Hazard(s) identificationNot hazardsNot hazardsNot hazardsNot defined hazards*Hazards not stated here are "Not classified", "Not applicable" or "Classification not possible".Label symbolSignal wordNot statementNot statementPreventionNot (s) not otherwiseclassified (HNOC)None Composition/information on ingredientsMixturesCAS numberCommon name and synonymsChemical name%8052-42-4 ASPHALT40 - 70 Other components below reportable levels64742-52-5 DISTILLATES (PETROLEUM),HYDROTREATED HEAVYNAPHTHENIC0 - 300 - 754.

2 First-aid measuresIf breathing is difficult, remove to fresh air and keep at rest in a position comfortable for medical attention, if needed. Call a physician if symptoms develop or / 7 Material name: Roadsaver, Polyflex, Parking Lot, Asphalt Rubber, DF, Superflex, Matrix Binder, Loop Detector, Joint Adhesive, Polyfiber, Fiber Asphalt, Marker Adhesive, Quikstix, Asphalt Adhesive, PCF 100, High Slope, QWIKSEAL, QWIKDOT, Joint Binder4988 Version #: 02 Revision date: 02-27-2018 Issue date: 02-23-2018 SDS USIn case of contact, immediately flush skin with plenty of water for at least 15 minutes whileremoving contaminated clothing and shoes. Thoroughly wash (or discard) clothing and shoesbefore contactImmediately flush eyes with plenty of water for at least 15 minutes. If a contact lens is present, DONOT delay irrigation or attempt to remove the lens.

3 Get medical attention if irritation develops contactRinse mouth. Do not induce vomiting. Do not use mouth-to-mouth method if victim ingested thesubstance. Call a POISON CENTER or doctor/physician if you feel importantsymptoms/effects, acute anddelayedIn case of ingestion, the decision of whether or not to induce vomiting should be made by theattending physician. Certain pre-existing conditions may make workers particularly susceptible tothe effects of this chemical: asthma, allergies, impaired pulmonary of immediatemedical attention and specialtreatment neededIf you feel unwell, seek medical advice (show the label where possible). Ensure that medicalpersonnel are aware of the material(s) involved, and take precautions to protect themselves. Showthis SAFETY data SHEET to the doctor in attendance.

4 Discard any shoes or clothing items that cannotbe information5. Fire-fighting measuresWater fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Addition of water or foam to the firemay cause extinguishing mediaDo not use a solid water stream as it may scatter and spread extinguishingmediaFire may produce irritating, corrosive and/or toxic gases. Development of hazardous combustiongases or vapours possible in the event of a fire. The following may develop: hazards arising fromthe chemicalFirefighters must use standard protective equipment including flame retardant coat, helmet withface shield, gloves, rubber boots, and in enclosed spaces, SCBA. Firefighters should wear fullprotective clothing including self contained breathing apparatus. Structural firefighters protectiveclothing will only provide limited protective equipmentand precautions forfirefightersIn case of fire and/or explosion do not breathe fumes.

5 Firefighters must use standard protectiveequipment including flame retardant coat, helmet with face shield, gloves, rubber boots, and inenclosed spaces, SCBA. ALWAYS stay away from tanks engulfed in flame. Fight fire from maximumdistance or use unmanned hose holders or monitor nozzles. In the event of fire, cool tanks withwater spray. By fire, toxic gases may be formed (COx, NOx). Keep run-off water out of sewers andwater sources. Dike for water fightingequipment/instructionsIn the event of fire and/or explosion do not breathe fumes. In the event of fire, cool tanks withwater spray. Use water spray to cool unopened methods6. Accidental release measuresKeep unnecessary personnel away. Wear appropriate protective equipment and clothing duringclean-up. Ventilate closed spaces before entering them.

6 Do not touch or walk through precautions,protective equipment andemergency proceduresELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Dike farahead of spill for later disposal. Following product recovery, flush area with return spills in original containers for and materials forcontainment and cleaning upPrevent further leakage or spillage if safe to do so. Runoff or release to sewer, waterway or groundis precautions7. Handling and storageThe product is non-combustible. If heated, irritating vapors may be formed. Do not use in areaswithout adequate ventilation. Wash hands thoroughly after handling. Wash hands after good industrial hygiene for safe handlingPrevent electrostatic charge build-up by using common bonding and grounding techniques. Store ina well-ventilated place.

7 Keep the container tightly closed and dry. Store in a closed container awayfrom incompatible materials. Keep out of the reach of for safe storage,including anyincompatibilities2 / 7 Material name: Roadsaver, Polyflex, Parking Lot, Asphalt Rubber, DF, Superflex, Matrix Binder, Loop Detector, Joint Adhesive, Polyfiber, Fiber Asphalt, Marker Adhesive, Quikstix, Asphalt Adhesive, PCF 100, High Slope, QWIKSEAL, QWIKDOT, Joint Binder4988 Version #: 02 Revision date: 02-27-2018 Issue date: 02-23-2018 SDS US8. Exposure controls/personal protectionOccupational exposure limitsUS. OSHA Table Z-1 Limits for Air Contaminants (29 CFR )ValueComponentsFormTypePEL5 (PETROLEUM),HYDROTREATED HEAVYNAPHTHENIC (CAS64742-52-5)US. ACGIH Threshold Limit mg/m3 Inhalable (CAS 8052-42-4)US. NIOSH: Pocket Guide to Chemical HazardsValueComponentsFormTypeCeiling5 (CAS 8052-42-4)STEL10 (PETROLEUM),HYDROTREATED HEAVYNAPHTHENIC (CAS64742-52-5)TWA5 biological exposure limits noted for the ingredient(s).

8 Biological limit valuesProvide adequate ventilation, including appropriate local extraction, to ensure that the definedoccupational exposure limit is not engineeringcontrolsIndividual protection measures, such as personal protective equipmentWear SAFETY glasses; chemical goggles (if splashing is possible). Wear chemical goggles; face shield(if handling molten material).Eye/face protectionSkin protectionChemical resistant gloves are recommended. If contact with forearms is likely wear gauntlet protectionWear suitable protective clothing and eye/face protection. Use of an impervious apron workers are facing concentrations above the exposure limit they must use appropriatecertified protectionDuring product use, there is a risk of thermal hazardsWhen using do not smoke. Avoid contact with eyes.

9 Avoid contact with skin. Keep away from foodand drink. Handle in accordance with good industrial hygiene and SAFETY hygieneconsiderations9. Physical and chemical Dark brownColorProduct is a black, semi-solid with a burnt tar thresholdNot point/freezing point150 - 250 F ( - C) ASTM D36 Softening PointInitial boiling point andboiling range> 800 F (> C)Flash point> F (> C)Evaporation rateNot (solid, gas)3 / 7 Material name: Roadsaver, Polyflex, Parking Lot, Asphalt Rubber, DF, Superflex, Matrix Binder, Loop Detector, Joint Adhesive, Polyfiber, Fiber Asphalt, Marker Adhesive, Quikstix, Asphalt Adhesive, PCF 100, High Slope, QWIKSEAL, QWIKDOT, Joint Binder4988 Version #: 02 Revision date: 02-27-2018 Issue date: 02-23-2018 SDS USUpper/lower flammability or explosive limitsFlammability limit - lower(%)Not limit -upper (%)Not limit - lower(%)Not limit - upper(%)Not pressureNot densityNot densityNot (ies)Solubility (water)Not coefficient(n-octanol/water)Not temperature> 700 F (> C)Decomposition temperatureNot informationDensityNot AvailablePercent volatile0 %Specific gravity1 - Stability and reactivityNot ReactiveReactivityMaterial is stable under normal stabilityHazardous polymerization does not of hazardousreactionsStrong oxidizing to avoidIncompatible with oxidizing materialsUpon decomposition, product emits acrid dense smoke with carbon dioxide, carbon monoxide, traceoxides of nitrogen and sulfur, and decompositionproducts11.

10 Toxicological informationInformation on likely routes of exposureInhalationMay be harmful if inhaled. However, this product does not currently meet the criteria contactFrequent or prolonged contact may defat and dry the skin, leading to discomfort and contactMay be irritating to cause gastrointestinal discomfort if swallowed. Do not induce vomiting. Vomiting mayincrease risk of product related to thephysical, chemical andtoxicological characteristicsNot on toxicological effectsAcute toxicityNot classified. May cause defatting of the skin, but is neither an irritant nor a corrosion/irritationNot eye damage/eyeirritationRespiratory or skin sensitizationRespiratory sensitizationNot sensitizationNon-mutagenic based on Modified Ames cell mutagenicity4 / 7 Material name: Roadsaver, Polyflex, Parking Lot, Asphalt Rubber, DF, Superflex, Matrix Binder, Loop Detector, Joint Adhesive, Polyfiber, Fiber Asphalt, Marker Adhesive, Quikstix, Asphalt Adhesive, PCF 100, High Slope, QWIKSEAL, QWIKDOT, Joint Binder4988 Version #: 02 Revision date: 02-27-2018 Issue date: 02-23-2018 SDS USCarcinogenicityThis product is not considered to be a carcinogen by IARC, ACGIH, NTP, or Monographs.