SAFETY DATA SHEET - glengarrychemicals.com

1 SAFETY data SHEETSECTION 1 : IDENTIFICATIONP roduct Name:GLENGARRY CS-1000 Product Use:Aluminium Corrosion Inhibitor SupplementSupplier:Glengarry Chemicals :416-737-1183ppgyAddress:33 Melford Drive, Unit 6,Fax:416-737-9793 Scarborough, Ontario. M1B 2G6 POISON CONTROL CENTRE:1-800-268-9017 SECTION 2 : HAZARD IDENTIFICATIONGHS Classification:Category 1:Serious eye damage/eye 1:Corrosive to 1:Corrosive to 1B:Skin 3:Specific target organ toxcity (respiratory System).Category 5:Acute toxicity, Word:WARNINGP ictogram:Hazard Statements:H290: May be corrosive to : May be harmful if : Causes skin : Causes serious eye : May cause respiratory : May cause damage to organs through prolonged or repeated Statements:P202:Do not handle until all SAFETY precautions have been read and :Keep only in original gP260:Do not breathe :Wash horoughly after handling.

2 P280:Wear protective gloves/protective clothing/face Statements:P301+P330+P331IF SWALLOWED: Rinse mouth. DO NOT INDUCE VOMITING. P303+P361+P353P304+P340+P310IF ON SKIN (or hair): Remove immediately all contaminated clothing. Rinse skin with water. IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable forP304+P340+P310P305+P351+P338+P310P332 +313If skin irritation occurs: Get medical +313If eye irritation persists: Get medical :Get medical advice/attention if you feel :Wash contaminated clothing before :P405:Store locked INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Glengarry CS-1000 Page 1 of 4 Disposal:P501:Dispose of container according to all applicable 3 : COMPOSITION/INFORMATION ON INGREDIENTSCOMPONENTSCAS (wt/wt)1344 09 81t 10S diili t1344-09-81 to 10 SECTION 4 : FIRST AID MEASURESEYES:Wash with copious amounts of water for at least 20 minutes keeping eyelids open.

3 If irritation persists repeat fl hiG t idi tdi l tttiSodium silicateSKIN:INHALATION:INGESTION:Most important symptoms and effects, both acute and delayedflushing. Get immediate medical wash the affected areas with plenty of water. If irritation persists, obtain medical person to fresh air and keep comfortable for breathing. Seek medical attention not attempt to give anything by mouth to an unconscious person. If person is alert and not convulsing rinse mouth out and give 1-2 glasses of water to dilute material and seek medical attention immediately. DO NOT INDUCE of any immediate medical attention and special treatment neededGeneral InformationSevere eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. May cause redness and general supportive measures and treat symptomatically.

4 Keep victim warm. Keep victim under exposed or concerned: Get medical advice/attention. Ensure that medical personnel are aware of the materials involved, and take precautions to protect themselves. Show this SAFETY data SHEET to the doctor in 5 : FIRE FIGHTING MEASURESF lammability: Not Extinguishing Media: Use extinguishing media suitable for surrounding Hazards Arising from the Chemical:None Protective Equipment and Precautions for Fire-fighters:Self contained breathing apparatus and protective clothing should be worn in fighting all fires involving chemicalsSelf contained breathing apparatus and protective clothing should be worn in fighting all fires involving 6 : ACCIDENTAL RELEASE MEASURESP ersonal Precautions, Protective Equipment and Emergency Procedures:Environmental Precautions: Use personal protective equipment.

5 Ensure adequate ventilation. Evacuate personnel to safe areas. Avoid contact with skin, eyes and inhalation of f thlkilliff t dPtt i ttbtfidDMethods and Materials for Containment and Cleaning Up:SECTION 7 : HANDLING AND STORAGEP revent further leakage or spillage if safe to do so. Prevent entry into waterways, sewers, basements or confined areas. Do not flush into surface water or sanitary sewer may be slippery use caution. Soak up with inert absorbent material ( sand, silica gel, acid binder, universal binder, sawdust). Keep in suitable, closed containers for disposal. Dispose of according to local, provincial and federal regulations. SECTION 7 : HANDLING AND STORAGEP recautions for Safe Handling:Conditions for Safe Storage:Do not handle until all SAFETY precautions have been read and understood. Use normal good industrial hygiene and SAFETY practices.

6 Avoid contact with eyes, skin, and clothing. Avoid generation of mist. Use recommended SAFETY equipment when handling. Wash thoroughly after storage at high temperatures and protect from freezing. Store away from incompatibles. Keep containers closed when not in use. Store locked CS-1000 Page 2 of 4 SECTION 8 : EXPOSURE CONTROLS/PERSONAL PROTECTIONE xposure GuidelinesCOMPONENTSCAS TLVOSHA PELNIOSHS odium silicate1344-09-8 Not AvailableNot AvailableNot AvailableLegendACGIH - American Conference of Governmental Industrial HygienistsOSHA - Occupational SAFETY and Health AdministrationNIOSH IDLH: The National Institute for Occupational SAFETY and Health Immediately Dangerous to Life or HealthAppropriate Engineering Controls:Individual Protection Measures:Eyes:Chemical SAFETY :Chemical resistant gloves and appropriate protective :Approved NIOSH respiratory protection if TLV/PEL is exceeded or if over exposure is Hygienic Practices:Ensure adequate ventilation, especially in confined storing or using this material should be equipped with emergency eyewash, and a SAFETY shower.

7 Good personal hygiene practices should always be 9 : PHYSICAL AND CHEMICAL PROPERTIESP hysical :Clear to hazy Threshold:No information - Gravity (water = 1) :110 115ypygpySpecific Gravity (water = 1) - point/Freezing point:~0 oCBoiling point:~100oCFlammability: Not Explosive Limit:Not Explosive Limit:Not Point: Not Temperature:Not Temperature:No information :No information Pressure (mm Hg) :No information Density (air = 1) :No information Rate :No information in Water Coefficient n-Octanol/Water: No information 10 : STABILITY AND REACTIVITYSECTION 10 : STABILITY AND REACTIVITYR eactivity:Not reactive under normal Stability: Material is stable under normal of Hazardous Reactions: Hazardous polymerization does not to Avoid: Incompatible Materials: Contact with incompatible alkali may react violently with strong mineral acids, and may produce hydrogen in contact with zinc, aluminium, tin and their Decomposition Products: None 11 : TOXICOLOGICAL INFORMATIONP rimary Route of Exposure:Eye contact, skin contact, ingestion and Corrosion/Irritation: Serious eye damage/irritation: Germ cell mutagenicity: Irritating to to or skin sensitization: Not evidence of genotoxicity.

8 In vitro/in vivo CS-1000 Page 3 of 4 Carcinogenicity: Reproductive toxicity: STOT-single exposure:STOT-repeated exposure:No evidence of reproductive toxicity or developmental classified. Not classifiedNo structural alerts. IARC, NTP, OSHA, ACGIH do not list this product as known or suspected exposure: Aspiration hazard: Component Acute Toxicity InformationCOMPONENTCAS LD50 DERMAL LD50 INHALATION LC50 Sodium silicate1344-09-81960 mg/Kg (rat)4640 mg/Kg (rabbit)Not availableSECTION 12 ECOLOGICAL INFORMATIONNot classified. No information 12 : ECOLOGICAL INFORMATIONCOMPONENTCAS Algae Freshwater FishWater FleaSodium silicate1344-09-8 Not AvailableLC50: 1108 mg/L, 96hEC50: 1700 mg/L (48 hours)(Brachydanio rerio)(Daphnia magna)Toxicity: Persistence and degradability: Bioaccumulative potential:Inorganic Substance has no potential for bioaccumulationNo information information potential: Mobility in soil: Other adverse effects: SECTION 13 : DISPOSAL CONSIDERATIONSW aste Disposal of substance: Dispose of in accordance with national, state/provincial and regional disposal: Dispose of in accordance with national, state/provincial and regional 14 : TRANSPORT INFORMATIONI norganic.

9 Substance has no potential for information in material will have local effect on ecosystems sensitive to changes in 14 : TRANSPORT Classification: Shipping Name:NOT REGULATEDUN Number:Not :Not Group:Not 15 : REGULATORY INFORMATIONWHMIS Classification:Class D2: Material Causing Other Toxic Effects Class E: CorrosiveSECTION 16 : OTHER INFORMATIONP reparation Information:Lt tR ii Dt11 A2017 IDt11 A2017 This product has been classified in accordance with the hazard criteria of the Hazardous Products Regulation (HPR), Hazard Communication Rule (2012), Regulation (EC) No 1907/2006 Latest Revision Date: 11-Aug-2017 Issue Date:11-Aug-2017 Version Notes:Prepared By:Regulatory document has been updated to comply with the Globally Harmonized System of Classification and Labeling of Chemicals (GHS). The information supplied above is presented in good faith and has been derived from sources believed to be reliable.

10 However, no warranty,express or implied, is extended regarding its accuracy or the results to be obtained from its use. Products supplied by our company are soldunder the condition that liability for any personal injury or damage whatsoever to any property real or personal arising from the handling or usewill, in all cases, remain with the handler or CS-1000 Page 4 of 4