1 SAFETY data SHEET . 1. Identification Product identifier Gunk Engine Cleaner - Foamy Other means of identification SDS number FEB1. Part No. FEB1. Tariff code Recommended use Engine Cleaner Recommended restrictions None known. Manufacturer/Importer/Supplier/Distribut or information Manufacturer Company name RSC Chemical Solutions Address 600 Radiator Road Indian Trail, NC 28079. United States Telephone Customer Service: (704) 821-7643. Technical: (704) 684-1811. Website E-mail Emergency phone number Emergency Telephone: (303) 623-5716. Emergency Contact: RMPDC (877-740-5015). 2. Hazard(s) identification Physical hazards Flammable aerosols Classification not possible Health hazards Skin corrosion/irritation Category 2. Serious eye damage/eye irritation Category 2A. Carcinogenicity Category 2. Specific target organ toxicity, repeated Category 2. exposure Aspiration hazard Category 1. Environmental hazards Not classified. OSHA defined hazards Not classified. Label elements Signal word Danger Hazard statement May be fatal if swallowed and enters airways.
2 Causes skin irritation. Causes serious eye irritation. Suspected of causing cancer. May cause damage to organs through prolonged or repeated exposure. Precautionary statement Prevention Obtain special instructions before use. Do not handle until all SAFETY precautions have been read and understood. Do not breathe mist or vapor. Wash thoroughly after handling. Wear protective gloves/protective clothing/eye protection/face protection. Response If swallowed: Immediately call a poison center/doctor. Do NOT induce vomiting. If on skin: Wash with plenty of water. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If exposed or concerned: Get medical advice/attention. If skin irritation occurs: Get medical advice/attention. If eye irritation persists: Get medical advice/attention. Take off contaminated clothing and wash before reuse. Storage Store locked up. Material name: Gunk Engine Cleaner - Foamy SDS US. FEB1 Version #: 03 Revision date: 11-16-2016 Issue date: 05-29-2015 1 / 13.
3 Disposal Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise None known. classified (HNOC). Supplemental information of the mixture consists of component(s) of unknown acute oral toxicity. of the mixture consists of component(s) of unknown acute dermal toxicity. of the mixture consists of component(s) of unknown acute inhalation toxicity. 3. Composition/information on ingredients Mixtures Chemical name Common name and synonyms CAS number %. Petroleum Gases, Liquefied, 68476-86-8 5 - < 10. Sweetened; Petroleum Gas;. Petroleum naphtha 64742-94-5 3-<5. Kerosine (petroleum) 8008-20-6 1-<3. Nonylphenolethoxylate 9016-45-9 1-<3. Tert-butylbenzene 98-06-6 1-<3. 1,4-diethylbenzene 105-05-5 <1. 2-Butoxyethanol 111-76-2 <1. Morpholine 110-91-8 <1. NAPHTHALENE 91-20-3 < 1,2,3-trimethylbenzene 526-73-8 < 1,2,4-Trimethylbenzene 95-63-6 < Tri thanolamine 102-71-6 < 2-methoxyethanol 109-86-4 < 4-ethylmorpholine 100-74-3 < Benzene, 1,3-diethyl- 141-93-5 < DIETHANOLAMINE 111-42-2 < Diethylbenzene 25340-17-4 < ETHYLENEDIAMINE 107-15-3 < Other components below reportable levels 70 - < 80.
4 *Designates that a specific Chemical identity and/or percentage of composition has been withheld as a trade secret. 4. First-aid measures Inhalation Move to fresh air. Call a physician if symptoms develop or persist. Skin contact Remove contaminated clothing. Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention. Wash contaminated clothing before reuse. Eye contact Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention if irritation develops and persists. Ingestion Call a physician or poison control center immediately. Rinse mouth. Do not induce vomiting. If vomiting occurs, keep head low so that stomach content doesn't get into the lungs. Most important Aspiration may cause pulmonary edema and pneumonitis. Severe eye irritation. Symptoms may symptoms/effects, acute and include stinging, tearing, redness, swelling, and blurred vision. Skin irritation.
5 May cause redness delayed and pain. Prolonged exposure may cause chronic effects. Indication of immediate Provide general supportive measures and treat symptomatically. Keep victim under observation. medical attention and special Symptoms may be delayed. treatment needed General information IF exposed or concerned: Get medical advice/attention. If you feel unwell, seek medical advice (show the label where possible). Ensure that medical personnel are aware of the material(s). involved, and take precautions to protect themselves. 5. Fire-fighting measures Suitable extinguishing media Water fog. Foam. Dry Chemical powder. Carbon dioxide (CO2). Unsuitable extinguishing Do not use water jet as an extinguisher, as this will spread the fire. media Material name: Gunk Engine Cleaner - Foamy SDS US. FEB1 Version #: 03 Revision date: 11-16-2016 Issue date: 05-29-2015 2 / 13. Specific hazards arising from During fire, gases hazardous to health may be formed. the Chemical Special protective equipment Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
6 And precautions for firefighters Fire fighting Containers should be cooled with water to prevent vapor pressure build up. equipment/instructions Specific methods Use standard firefighting procedures and consider the hazards of other involved materials. General fire hazards No unusual fire or explosion hazards noted. 6. Accidental release measures Personal precautions, Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear protective equipment and appropriate protective equipment and clothing during clean-up. Do not breathe mist or vapor. Do emergency procedures not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be contained. For personal protection, see section 8 of the SDS. Methods and materials for Refer to attached SAFETY data sheets and/or instructions for use. Stop leak if you can do so without containment and cleaning up risk.
7 Move the cylinder to a safe and open area if the leak is irreparable. Keep combustibles (wood, paper, oil, etc.) away from spilled material. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material ( cloth, fleece). Clean surface thoroughly to remove residual contamination. Put material in suitable, covered, labeled containers. For waste disposal, see section 13 of the SDS. Environmental precautions Avoid discharge into drains, water courses or onto the ground. 7. Handling and storage Precautions for safe handling Obtain special instructions before use. Do not handle until all SAFETY precautions have been read and understood. Pressurized container: Do not pierce or burn, even after use. Do not use if spray button is missing or defective. Do not spray on a naked flame or any other incandescent material. Do not smoke while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or expose containers to heat, flame, sparks, or other sources of ignition.
8 Ground and bond containers when transferring material. Do not re-use empty containers. Do not breathe mist or vapor. Avoid contact with eyes, skin, and clothing. Avoid prolonged exposure. Should be handled in closed systems, if possible. Use only in well-ventilated areas. Wear appropriate personal protective equipment. Wash hands thoroughly after handling. Observe good industrial hygiene practices. Conditions for safe storage, Level 1 Aerosol. including any incompatibilities Store locked up. Contents under pressure. Do not expose to heat or store at temperatures above 120 F/49 C as can may burst. Do not puncture, incinerate or crush. Do not handle or store near an open flame, heat or other sources of ignition. Keep out of the reach of children. Store away from incompatible materials (see Section 10 of the SDS). 8. Exposure controls/personal protection Occupational exposure limits The following constituents are the only constituents of the product which have a PEL, TLV or other recommended exposure limit.
9 At this time, the other constituents have no known exposure limits. US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR ). Components Type Value 2-Butoxyethanol (CAS PEL 240 mg/m3. 111-76-2). 50 ppm 2-methoxyethanol (CAS PEL 80 mg/m3. 109-86-4). 25 ppm 4-ethylmorpholine (CAS PEL 94 mg/m3. 100-74-3). 20 ppm ETHYLENEDIAMINE (CAS PEL 25 mg/m3. 107-15-3). 10 ppm Morpholine (CAS 110-91-8) PEL 70 mg/m3. 20 ppm Material name: Gunk Engine Cleaner - Foamy SDS US. FEB1 Version #: 03 Revision date: 11-16-2016 Issue date: 05-29-2015 3 / 13. US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR ). Components Type Value NAPHTHALENE (CAS PEL 50 mg/m3. 91-20-3). 10 ppm Petroleum naphtha (CAS PEL 400 mg/m3. 64742-94-5). 100 ppm US. ACGIH Threshold Limit Values Components Type Value Form 1,2,3-trimethylbenzene TWA 25 ppm (CAS 526-73-8). 1,2,4-Trimethylbenzene TWA 25 ppm (CAS 95-63-6). 2-Butoxyethanol (CAS TWA 20 ppm 111-76-2). 2-methoxyethanol (CAS TWA ppm 109-86-4). 4-ethylmorpholine (CAS TWA 5 ppm 100-74-3).
10 DIETHANOLAMINE (CAS TWA 1 mg/m3 Inhalable fraction and 111-42-2) vapor. ETHYLENEDIAMINE (CAS TWA 10 ppm 107-15-3). Kerosine (petroleum) (CAS TWA 200 mg/m3 Non-aerosol. 8008-20-6). Morpholine (CAS 110-91-8) TWA 20 ppm NAPHTHALENE (CAS TWA 10 ppm 91-20-3). Petroleum naphtha (CAS TWA 200 mg/m3 Non-aerosol. 64742-94-5). Tri thanolamine (CAS TWA 5 mg/m3. 102-71-6). US. NIOSH: Pocket Guide to Chemical Hazards Components Type Value 1,2,3-trimethylbenzene TWA 125 mg/m3. (CAS 526-73-8). 25 ppm 1,2,4-Trimethylbenzene TWA 125 mg/m3. (CAS 95-63-6). 25 ppm 2-Butoxyethanol (CAS TWA 24 mg/m3. 111-76-2). 5 ppm 2-methoxyethanol (CAS TWA mg/m3. 109-86-4). ppm 4-ethylmorpholine (CAS TWA 23 mg/m3. 100-74-3). 5 ppm DIETHANOLAMINE (CAS TWA 15 mg/m3. 111-42-2). 3 ppm ETHYLENEDIAMINE (CAS TWA 25 mg/m3. 107-15-3). 10 ppm Kerosine (petroleum) (CAS TWA 100 mg/m3. 8008-20-6). Morpholine (CAS 110-91-8) STEL 105 mg/m3. 30 ppm TWA 70 mg/m3. 20 ppm Material name: Gunk Engine Cleaner - Foamy SDS US. FEB1 Version #: 03 Revision date: 11-16-2016 Issue date: 05-29-2015 4 / 13.