Example: tourism industry
Safety Requirements for Work On or Adjacent to the ...
Most towers carry more than one circuit, so each circuit has to be positively identified. Circuit Identification Colour Plates are located on each side of the tower, attached to the climbing leg above the anti-climb device. Each circuit will be identified by a different colour. There may be additional colour plates on the tower at each cross arm.
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Page 1 of 8 Connecting you to our network …
www.spenergynetworks.co.ukPage 1 of 8 SP Energy Networks, Connecting you to our network application form This form relates to: • New electrical connections • Upgrades to …
GENERAL SPECIFICATION FOR THE CIVIL SUB-03 …
www.spenergynetworks.co.ukENGINEERING AND BUILDING DESIGN AND CONSTRUCTION OF SECONDARY SUBSTATIONS SUB-03-017 ... National Structural Steelwork Specification for Building Construction (BCSA Publication). GENERAL SPECIFICATION FOR THE CIVIL ENGINEERING AND BUILDING DESIGN AND CONSTRUCTION OF SECONDARY
General Specification for the Civil Engineering and ...
www.spenergynetworks.co.ukGENERAL SPECIFICATION FOR THE CIVIL ENGINEERING AND BUILDING DESIGN AND CONSTRUCTION OF PRIMARY SUBSTATIONS ... National Structural Steelwork Specification for Building Construction (BCSA Publication). GENERAL SPECIFICATION FOR THE CIVIL
GENERAL SPECIFICATION FOR THE CIVIL SUB-03-017 …
www.spenergynetworks.co.ukgeneral specification for the civil engineering and building design and construction of secondary substations sub-03-017 appendix 1 10/07/2018
LOW VOLTAGE EARTHING POLICY AND EART-01-002 …
www.spenergynetworks.co.ukIt is a requirement of the Electricity Safety Quality and Continuity Regulations, regulation 24 (4) & (5) that: Unless he can reasonably conclude that it is inappropriate for reasons of safety a distributor shall, when providing a new connection at low …
ScottishPower Distribution Cables & Equipment
www.spenergynetworks.co.uknetwork up to the mid 1990’s, prior to the introduction of XLPE cables. The standard conductor size used was 185mm. Fig.3 – 3 core HSL cable was installed in short sections for connections up
ELECTRICAL INSULATION TESTING OF HV EQUIPMENT SUB …
www.spenergynetworks.co.ukoverstress Equipment by inappropriate repetition of type or routine tests under inadequate site conditions. However, it is necessary to confirm that no damage has occurred during transportation ... accordance with section 10.4.2, table 9. Table 5 Surge Arresters New Previously In Service No pressure test. 5kV Insulation Resistance Test ...
Technical Specification for Secondary Substation Earthing
www.spenergynetworks.co.ukThis specification allows SPEN to demonstrate compliance with relevant national and international standards as well as statutory legislation and licence conditions. This document has been issued to align with latest releases of the ESQCR, BS EN 50522, ENA TS 41-24 and ENA EREC S34. This document replaces EART-02-003. 2. ISSUE RECORD
33kV and 11kV Overhead Line Strategy
www.spenergynetworks.co.uk33kV OHL (SPD) 5,072 216 8,808 11kV OHL (SPD) 28,238 1521 51,208 33kV OHL (SPM) 3,395 152 5,893 11kV OHL (SPM) 26,136 1414 46,268 Table 3-2: ED1 volumes for EHV/HV asset replacement and refurbishment Our Cost Benefit Assessments 50 and 61 in Annex C6 – Cost Benefit Analysis – SPEN justify our investment