Example: stock market

Series A from 700 to 3000 VA - Masterguard Chloride

Secure Power AlwaysUPS Catalogue Series A from 700 to 3000 VAImportant note! The technical data enclosed is for general information. Please note that the operating instructions and references indicated on the products are for installation, operation and maintenance. Product designations All product designations used are trademarks or product names of Chloride Group PLC or its subsidiary companies. This publication is issued to provide outline information and is not deemed to form any part of any offer or contract. The company has a policy of continuous product development and improvement and we therefore reserve the right to vary any information quoted without prior to contactMKA4 CAT0 UKAG4MG/Rev.

2. SYSTEM DESCRIPTION 1. SCOPE MASTERGUARD Series A UPS from 700 VA to 3000 VA MKA4CAT0UKAG4MG/Rev. 1-01/2009 02 This document describes a continuous electrical power, within defined limits time period defined by the battery

Tags:

  Form, Series, 3000, Series a from 700 to 3000 va, 3000 va, 700 va

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of Series A from 700 to 3000 VA - Masterguard Chloride

1 Secure Power AlwaysUPS Catalogue Series A from 700 to 3000 VAImportant note! The technical data enclosed is for general information. Please note that the operating instructions and references indicated on the products are for installation, operation and maintenance. Product designations All product designations used are trademarks or product names of Chloride Group PLC or its subsidiary companies. This publication is issued to provide outline information and is not deemed to form any part of any offer or contract. The company has a policy of continuous product development and improvement and we therefore reserve the right to vary any information quoted without prior to contactMKA4 CAT0 UKAG4MG/Rev.

2 1-01/2009 Series Afrom 700 va to 3000 VAUPS Catalogue 200922344568991. SCOPE2. SYSTEM DESCRIPTION3. DEVICE DESCRIPTION4. GENERAL REQUIREMENTS5. BATTERY MANAGEMENT6. CONTROL PANEL7. REAR SIDE8. INTERFACES & CONNECTIVITY9. MECHANICAL DATA10. TECHNICAL DATA11. OPTIONS1001 Uninterruptible Power Supply2. SYSTEM DESCRIPTION1. SCOPEMASTERGUARD Series AUPS from 700 va to 3000 VAMKA4 CAT0 UKAG4MG/Rev. 1-01/200902 This document describes a continuous electrical power, within defined limits time period defined by the battery duty single-phase output, on-line double and without interruption, upon failure or system, which will be automatically conversion uninterruptible power supply degradation of the commercial AC recharged by the UPS upon restoration (UPS) system.

3 The UPS shall source. The continuity of conditioned of the commercial AC source. automatically provide continuity of electric power shall be delivered for the The systemas shown in the figure below, and shall interaction with the standard front provide the following benefits: panel with LED indicators and the optional LCD Display High energy efficiency in power An increasing number of devices are conversion, including ECO mode Intelligent load management provided sensitive to disturbances on the mains by the controllable output socketspower supply. The Series A UPS system Outstanding output power factor= shall provide high quality AC power for 0,9 (*) Possibility of operation as frequency connected equipment and offer the converter Easy-swappable internal batteries, for following features.

4 Simplified maintenance without Availability of internal automatic Protection against power failuresdisconnecting the loadsbypass to keep the load fed in the event of a UPS failure, reducing Improvement in the power supply Advanced battery management, disruption and maximising uptimequalityincreasing battery life Minimization of mains distortions Compatibility with all types of load Simplified commissioning, thanks to thanks to the enhanced input power the auto-detection of external battery factor A shall operate based on DSP- User-friendly notification and driven Double Conversion technology, UPS ModelA700-T A1000-T A1500-TA1000-RTA1500-RTA2000-RTA3000-RTH ousingTowerTowerTowerRack/TowerRack/Towe rRack/TowerRack/TowerRating (*)700VA/630W1000VA/900W1500VA/1350W1000 VA/900W1500VA/1350W2000VA/1800W3000VA/27 00 WBattery PackBP-A1000/1500-TBP-A1000/1500-RTBP-A2 000/ 3000 -RTHousingTower Rack/TowerRack/TowerCompatible UPSA1000-T / A1500-TA1000-RT / A1500-RTA2000-RT / A3000-RT(*) These ratings are only valid for the UPS without external battery packs and considering a nominal voltage of 230 V.

5 Check technical data for further details. Series A block diagramFilterPFCC hargerBoosterInverterFilterLNLNEE+V-V-+ Models availableThe Series A product range shall include the following single-phase pluggable models and external battery packs: MKA4 CAT0 UKAG4MG/Rev. 1-01/2009033. DEVICE Components/blockspure sinusoidal supply the energy and the Both filters work even if the unit is user can see the estimated battery CHARGER working in bypass by using the software or the The charger includes a temperature LCD which regulates the Operating modes charging process. When the mains BYPASS MODESTART-UP SEQUENCE voltage is within tolerances, the charger In this case, the load is directly fed from When the unit is connected to the provides a nominal recharge current up the AC mains.

6 It can be forced by the mains, it automatically starts to work in to to the batteries. This element is user or activated automatically by the bypass mode and thus powers current-limited; therefore, it can only UPS when detecting an overload or connected loads. To switch to line provide the nominal current, although other internal failure. This is also the mode, the user must press the inverter batteries may demand more current. start-up button. After inverter Typical recharge time for internal disconnection through the On/Off ECO MODE batteries is 4 hours (for 90% recharge).button, the unit returns to bypass mode If this mode is enabled, the unit will whenever the mains is in automatic by-pass when mains INVERTERThis sequence allows the load to be fed The inverter consists of a half-bridge is within tolerances.

7 Otherwise, it whenever which uses high frequency automatically switches to line mode (if switching , as the voltage input window is LINE MODEThe inverter is protected against output wider in line mode) or to battery mode. In use, the input AC is converted to DC, short-circuits and is very high efficiency (up to 97%) is and converted back to a pure sinewave. achieved in this mode of prevents the load from suffering LOGIC CONTROL BASED ON DSPL ogic control provided by a powerful power line problems (including total FREQUENCY CONVERTER MODED igital Signal Processor (DSP) shall loss of input AC power) and corrects The unit operates as a frequency sample the output voltage, the load power , providing 50 or 60 Hz at The inverter is constantly synchronised immediately detecting abnormal output when the input frequency is with the input line, thus allowing load voltage conditions and then operating within 40-70 Hz.

8 There is a power de-transfer from the inverter to the bypass the appropriate (50%) when using this mode. line to power the load in case of ECO mode and by-pass mode are not PFC CIRCUIT overloads or inverter from this power factor correction circuit provides a very high input current BATTERY MODEThe user can activate/deactivate UPS switches automatically to this power factor (~0,99), thus reducing the several of these operating modes via mode when detecting a mains failure input disturbances and optimizing the LCD Display.(and the unit is not in bypass mode). energy usage. It also contributes to avoid the introduction of disturbances to this element, the batteries voltage is increased up to DC bus voltage for the inverter to provide the pure sinusoidal output when the unit is working on battery the one hand, the input filter reduces disturbances coming from mains and sets up the signal for the PFC the other hand, inductances at the inverter output, together with output capacitors, act as a filtering element to obtain the output FilterPFCC hargerBoosterInverterFilterLNLNEE+V-V-+B ypass ModeLine ModeBattery ModeMASTERGUARD Series AUPS from 700 va to 3000 VA4.

9 GENERAL REQUIREMENTSMKA4 CAT0 UKAG4MG/Rev. 1-01 Standards and certificationsaccordance with the following Electrical and Electronic Equipment. international standards: Masterguard GmbH is certified by the Neutral/earthGerman T V as a company with a quality EN62040-1-1, EN 60950 (RD); general Series A neutral output is not connected and environmental management system and safety requirementsto the earth and battery negative voltage EN62040-2 Class C2, EMC requirementsin accordance with standards ISO 9001 is referenced to neutral ISO A shall also bear the T V and Series A shall not modify the neutral UL/cUL certifications for safety. Series A shall carry the CE mark in state, with the exception in battery mode accordance with the Safety Directive RoHSdue to the backfeed and the EMC Directive 2004/108/EC (superseding the Series A voluntarily complies with the 89/336/EEC, 92/31/EC and 93/68/EEC requirements of the Directive 2002/95/EC Directives).

10 Regarding Restriction of the Use of Certain Hazardous Substances (RoHS) in Series A is designed and manufactured in 5. BATTERY Battery configurationsThe UPS shall automatically detect the display. number of external battery packs A pre-alarm signal shall be activated Series A shall include the configurations before the end of battery back-up to alert connected via communication cables shown in the tables below: (bundled with the battery packs) the operator (BATTERY LOW signal). By Batteries shall be sealed, lead-acid and default, this signal shall be activated when interconnected between the UPS and the maintenance-free. Internal batteries in the the remaining battery capacity goes battery packs.


Related search queries