Shaker Manual US - Wittus

1 Shaker Stove Installation and User Manual Imported by: PO Box 120 Pound Ridge NY 10576 Listed by: PFS Corporation Cottage Grove Wisconsin USA Read this Manual carefully and save the instructions. Revised 5/17 2 Installation and User Manual Table of Contents Introduction and Purpose 3 Technical Data 4-5 Service Packet 6 Outside Air Supply 6 Installation of Your Stove 7-8 Connection to the Chimney 9-11 Air Flow and Combustion 12 Permitted Fuels 13 Initial Use 14 Heating Up 15 Operation 16-18 Cleaning Instructions 19-20 Spare Parts List 21 Maintenance of the Stove 21-22 Testing and Approvals 23 Warranty 23 Troubleshooting 24 3 Introduction and Purpose The purpose of this Manual is to guide and instruct Shaker stove owners in proper burning

2 To achieve environmentally friendly combustion and to minimize the risk of incorrect use and operation of the stove. Failure to follow instructions may result in property damage, bodily injury, or even death. It is therefore very important to read this entire Manual carefully before you install and use your new Shaker stove, and save the instructions. Correct operation is also vital with regard to our applicable warranty terms. For more information on wood burning visit the website BEFORE YOU INSTALL YOUR STOVE WE RECOMMEND THAT YOU CONTACT YOUR DEALER OR LOCAL BUILDING INSPECTOR OR FIRE MARSHALL TO HELP YOU FOLLOW THE RULES AND REGULATIONS IN YOUR LOCAL AREA.

3 WE ALSO RECOMMEND THAT YOUR DEALER CHECK THE STOVE BEFORE INSTALLATION FOR COMPLETENESS AND FUNCTIONALITY. If your stove is not installed properly, a home fire may result. To reduce the risk of fire, follow the installation instructions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. Not approved for use in a mobile home. Take particular note of this symbol throughout the Manual . This indicates special attention. Follow the Manual during installation and operating of the stove.

4 4 Technical Data Shaker Stove: Description Data Test data: Safety approval for United States UL 1482 Safety approval for Canada ULC S627 Environmental approval (EPA Certified) gm/hr emission rate Heating: Optimal heat output 20kBTU (6kW) Heat output range (minimum-maximum) 10-23kBTU (3-7kW) Heating capacity range 520-1,330ft2 (20-50m2) Efficiency 78% Stove dimensions: Stove height 41 (103,5 cm) Stove width short / long bench 33 (84cm) / 72 (184cm) Stove depth 21 (53cm) Firebox dimensions: Firebox height 14 (35cm) Firebox width 16 (40cm) Firebox depth 13 (32cm) Area: Door opening area to the fire chamber (564 cm2) Weight: Weight of stove without a table 247lbs.

5 (112kg) Weight of the table - long / short 71lbs. (32kg) / 38lbs. (17kg) Venting: Optional venting outlets top or back vent Stove pipe: Diameter of the stove pipe 6 (15cm) Height to center of pipe back vent 36 (915mm) Outside air supply: Diameter of the air supply connector 4 (10cm) Air supply outlet back side of stove Material data: Cladding on body and table steel Color black 5 20 18 500 460 6 Service Packet The Shaker stove is delivered with a service packet. It contains the installation and user Manual , the heat protector handle, and a glove.

6 Please note that the glove supplied with the stove is equally suitable for left and right-handed persons. Outside Air Supply Ensure that there is sufficient combustion air in the room in which the stove is installed, and that there is an adequate supply of combustion air to the stove, which can be supplied from another room or from outside. With the Shaker air system, the stove uses combustion air from either another room or outside (through a connection to the firebox via the outside air connector). Stoves with combustion air supply from outside are particularly suited for rooms with negative pressure ( use of exhaust fan).

7 Please refer to your dealer, as this connection should always be made by a qualified person. outside air supply 7 Installation of Your Stove The distances (see Fig. on page 8) of the stove to combustible materials or walls are listed in the table below. These are the minimum clearances for installation, and any reductions must first be approved by the regulatory authority. Clearances to noncombustible materials are 2 (5cm), but note that noncombustible must be solid cement or block (not brick or tile over combustible material. Use floor plates under the stove made with non-combustible fire-resistant materials such as steel, tile, or glass.)

8 Before installation, make sure the floor can carry the weight of the stove (in the Technical data section of this Manual ). Fig. Label Description US Canada inches cm inches cm I. A Distance to side walls 39 39 I. B Distance to back wall 32 32 II. C1 Corner to side walls door side 37 37 II. C2 Corner to side walls back side 32 32 I. D Connector pipe to side walls 21 53 21 53 I. E Connector pipe to back wall 16 41 16 41 II. F1 Corner pipe to side walls door side 22 56 22 56 II. F2 Corner pipe to side walls back side 20 51 20 51 III.

9 Fuel-door floor plate protection 16 41 18 46 III. Side floor plate protection 8* 20* 8 20 III. Back floor plate protection 0 0 8 20 Ceiling to top of stove 36 92 36 92 Ceiling to connector pipe 18 46 18 46 Distance to combustibles from glass 16 41 18 46 *Beyond the sides of the fuel loading door 8 *Note that the Parallel Wall and Corner Wall Installation clearances (diagrams I. and II.) are based on the dimensions at the top of the stove - 16 (40cm) wide x 14 (35cm) deep. **The Floor Plate clearances (diagram III.) are based on the dimensions at the base of the stove unit (not including the bench) - 20 (50cm) wide x 18 (46cm) deep.

10 Therefore, the required minimum size for the Shaker floor plate is 36 (91cm) wide x 34 (86cm) deep in the US and 46 (115cm) wide x 34 (86cm) deep for Canada. With the long bench, the required minimum size for the Shaker floor plate is 80 (203cm) wide x 34 (86cm) deep in the US and 88 (224cm) wide x 34 (86cm) deep for Canada. I. - Parallel Wall Installation II. - Corner Wall Installation III. Floor Plate Clearances * ** 9 Connection to the Chimney The Shaker stove can be connected from top or rear. The diameter of the stove pipe is 6 (152 cm).