Taubmans Ultimate Enamel Gloss D1100 - …

1 Taubmans Ultimate Enamel GlossD1100 DescriptionDescriptionDescriptionDescrip tionTaubmans Ultimate Enamel is a ultra premium, low VOC Enamel that uses Alkyd is a high performance water based product that flows and levells like a traditional oilbased Enamel . It also offers an extended open time and therefore it is the ideal choice forhigh end proffesional for doors, trim, plaster, masonary and forRecommended forRecommended forRecommended forInterior and exteriorFeaturesFeaturesFeaturesFeatures Durable filmDurable filmDurable filmDurable filmAlkyd technology provides a hard wearing durable consciousEnvironmentally consciousEnvironmentally consciousEnvironmentally consciousWater based technology - environment and user wet edgeExcellent wet edgeExcellent wet edgeExcellent wet edgeThe extended wet edge times make it the best choice for high end LevellingExceptional LevellingExceptional LevellingExceptional LevellingUltimate Enamel has excellent flow and levelling properties similar to those of traditional oilbased OpacityHigh OpacityHigh OpacityHigh OpacityExcellent coverage and hiding

2 VOCLow VOCLow VOCLow VOCU ltimate Enamel is low in VOC (Volatile Organic Compounds) and low in washability. Maximum after seven RangeColour RangeColour RangeColour RangeExtensive colour range. Refer to Taubmans Consumer or Architectural/Specifier And RecoatingDrying And RecoatingDrying And RecoatingDrying And RecoatingNormally dries to touch in 1-2 hours and may be recoated after 4-6 hours at 25 deg. C and50% relative LevelGloss LevelGloss LevelGloss LevelGloss level greater than 90 Gloss units as per adequate ventilation during Ultimate Enamel Gloss : D1100 Page: 2 Low in VOC and low in PreparationSurface PreparationSurface PreparationSurface PreparationSurface must be clean, dry and free from all contaminants.

3 Treat mould with bleach then rinse with cleanwater. Fill in the surface defects with a suiatable filler, putty or WorkNew/Bare WorkNew/Bare WorkNew/Bare WorkPaper faced plaster board, fibre cement, masonary, timber and bricks: apply one coat ofTaubmans 3 in PaintedPreviously PaintedPreviously PaintedPreviously PaintedRemove all loose and flaking paint. Sand glossy and enamal surfaces thoroughly andundercoat with Taubmans 3 in colour before use. Apply two coats using a 5mm (length of nap or pile) roller or agood quality brush. Avoid overspreading. If painting a large flat trim area such as a door,apply by roller for best excess paint from equipment into a separate container. Wash up with water. Do notdispose of paint or wash water in drains or 10-12 sq.

4 M/litre, depending on the nature of the surface. Coverage on rough orabsorbant surfaces will be based Enamel paints yellow under certain conditions. Contact Taubmans CustomerService Department on 131 686 for after 4-6 hours at 25 deg. C and 50% relative humidity. Allow an hour longer forhumid or cold paint well with a 25mm wide flat stirrer in a circular lifting motion for at least 5 minutesbefore not use at temperatures below 10deg. C or above 35 deg. C.