Technical Information ApplicationsAnchor Bolt Sleeve

1 Pipe Schedules (Sizes)(800) 652-658712748 East Florence Ave. Santa Fe Springs, CA 90670 Tel: (562) 944-9549 Fax: (562) 944-9360 Visit our website at 4 PIPE SCHEDULESWALL THICKNESS1/81/43/81/23/411-1/41-1/222-1/ 233-1/244-1 120 140 (800) 652-658712748 East Florence Ave. Santa Fe Springs, CA 90670 Tel: (562) 944-9549 Fax: (562) 944-9360 Visit our website at 17 Anchor Bolt SleeveApplicationsBasic Use: The Wilson Anchor Bolt Sleeve is used as an in-place form to provide a grout pocket around an anchor bolt and is used toform a pocket into which a bolt may be grouted. Also may be used where metal pipe is objectionable due to rusting or cost. Use in foodprocessing areas is not a problem due to the inert : The Wilson Anchor Bolt Sleeve is not recommended where high heat is used, such as inside an InformationTechnical ServicesAssistance in the application, selectionand use of Wilson products is availablethrough the manufacturer or arearepresentative free of DataSee Table 1 for material test data.

2 EachSleeve is approximately twice the boltdiameter with a depth of 8 boltdiameters, minimumTests by a state Department ofTransportation laboratory indicates thatthe Wilson Anchor Bolt Sleeve providedgreater pullout strength than the regulargrout pocketThe grout pocket was formed in aconcrete mass and the Sleeve of thesame size was cast into the mass. Aftercuring the concrete, #5 reinforcing barswere set in each pocket, usingexpanding grout. When cured, bothbars were given a tensile load. Thestandard pocket failed when the barwith the grout attached pulled out. TheWilson Anchor Bolt Sleeve retained thegrout and failure occurred around thebar. The Sleeve remained used as a Sleeve for anchor boltsthe product is in an in-place form andnot considered a structural to its configuration 180 psi is themaximum compressive and MaterialsThe Wilson Anchor Bolt Sleeve ismanufactured of high impact plastic.

3 Itis non-rusting, non-conductive andlightweight. Single unit constructionprovides for reduction in installationlabor because no welding, threading orcleaning is required. The configurationis such that the grout and concrete"lock" it in place, providing greaterpullout strength than with in fifteen standard sizes. SeeTable 2: Size Schedule (4" and 5" notshown).Table 1: Material and Testing DataPlastic:High Density PolyethleneDensitym gms/cc:ASTM D 1505-68 .956 Vicat Softening Point F:ASTM D 1525-70 256 F/124 CBrittleness Temperature F:ASTM D 746-70 -180 F/-118 CTorch ApplicationSlow BurnCompression Test180 kg/sq. 2: Grout Volume RequiredBoltSize100100100100100505020202 0201010 BoltSize2" "2" "2" "2" "2" "3" "3" "4" "4" "4" "4" "6" "6" "ShellsPer CartonCubic Inches ofGrout Per of GroutPer "3/4"5/8"3/4"7/8"1"1-1/4"1-1/2"1-3/4"2"2 -1/4"2-1/2"3"NOTE: Grout Estimate based on.

4 87 cu. ft. yield per 100 lb. of non-corrosive Habla Espanol~S Habla Espanol