TECHNICAL SERVICE GUIDE - Appliance Aid

1 G GE Consumer Home Services Training TECHNICAL SERVICE GUIDE . General Electric Side-by-Side Knob Control/Metal Liner Refrigerator MODEL SERIES: GSS20. GSS22. GSS25. ESS22. ESS25. HSS22. HSS25. SSS25. PUB # 31-9071 02/01. ! IMPORTANT SAFETY NOTICE. The information in this SERVICE GUIDE is intended for use by individuals possessing adequate backgrounds of electrical, electronic, and mechanical experience. Any attempt to repair a major Appliance may result in personal injury and property damage. The manufacturer or seller cannot be responsible for the interpretation of this information, nor can it assume any liability in connection with its use.

2 WARNING. To avoid personal injury, disconnect power before servicing this product. If electrical power is required for diagnosis or test purposes, disconnect the power immediately after performing the necessary checks. RECONNECT ALL GROUNDING DEVICES. If grounding wires, screws, straps, clips, nuts, or washers used to complete a path to ground are removed for SERVICE , they must be returned to their original position and properly fastened. GE Consumer Home Services Training TECHNICAL SERVICE GUIDE Copyright 2001. All rights reserved. This SERVICE GUIDE may not be reproduced in whole or in part in any form without written permission from the General Electric Company.

3 Table of Contents Introduction .. 2. Installation .. 3. Specifications .. 4. Nomenclature .. 5. Warranty Information .. 6. Operating Characteristics .. 7. General Locator Views .. 13. Mechanical Disassembly .. 15. Diagnostics .. 32. Component and Connector Locator Views .. 50. Schematics .. 54. Illustrated Parts Catalog .. 58. 1 . Introduction 2001 energy SxS models are being introduced in The freezer has adjustable shelves, slide-out response to the requirement for more energy - Spillproof shelf, QuickSpace shelf, and deep door efficient refrigerators by mid year 2001, along with shelves, based on model.

4 The fresh food section having feature and operation enhancements. The has a baking soda holder, fruit and vegetable primary differences in this refrigeration system are drawer, drawer dividers, adjustable humidity the adaptive defrost system (see Pub. # 31-9062), drawer, and convertible meat drawer. control board, software, and control systems that This new high-efficiency refrigerator is a operate independently in fresh food and freezer combination of the most efficient refrigeration sections. The new high-efficiency control system system and the most desirable customer features has the ability to cycle components and adjust fan available.

5 Speeds as required to maintain temperature- setting ranges in freezer and fresh food sections. Feedback systems are digital inputs and relay outputs. Sensors (thermistors) are used to measure temperature with communications to a main PC board, which controls the unit components. The refrigerator has versions that have control knobs or touchpads (Profile models). to provide inputs to a microprocessor. The freezer/. fresh food controls are temperature setpoint type and have settings of 0-9 with 9 being the coldest temperature possible. The new NO CLEAN.

6 Condenser is serviceable from the rear and is designed to prevent the customer from having to clean the condenser in normal usage conditions. Sealed system operation and compressor are functionally the same as previous models, with some minor changes. The 20', 22', and 25' side-by-side models are the models affected. These models are available with through-the-door chilled water and ice dispenser, and built-in water filter feature. On models requiring icemaker, the newest electronic icemaker (see Pub. # 31-9063) has been or can be installed.

7 2 . Installation ATTENTION INSTALLER: FOR A QUALITY INSTALLATION, FOLLOW THESE INSTRUCTIONS. RAISE. ROLLERS DO NOT 9 IS COLDEST.. ,,,,, @@@@ @, @, @, @, @, @, @, OVER- 0 IS OFF. ,,,,, @@@@ . TIGHTEN 4 5 6 4 5 6. STRAP. 3. 7. 3. 7. CARDBOARD. 2. 8. 2. 8. PROTECTS. DOOR EDGES. 1. 9. 1. 9. 0. ROLLER. ADJUSTMENT FREEZER FRESH FOOD. HEX-HEAD BOLTS (4) MAKE SURE FRONT. ROLLERS DO NOT TRUCK FROM. REST ON TRUCK SIDE ONLY. REMOVE AND DISCARD ADJUST FRONT ROLLERS SET BOTH CONTROLS TO 5 . SKIDBOARDS and bolts used to so that refrigerator is solid and SET ICEMAKER TO OFF until hold skidboards.

8 Doors close easily. water line is connected. Use PADDED HAND TRUCK LEAVE TAPE ON DOORS until MAKE SURE DOORS ARE EVEN. to protect refrigerator finish. refrigerator is in its final location. AT TOP. Check gasket seal. IMPORTANT: IMMEDIATELY REMOVE ALL CLEAR PROTECTIVE TAPE FROM TRIM. TO REMOVE TAPE RESIDUE AND HANDPRINTS, USE Appliance POLISH. REMOVE ALL TAPE AND OTHER PACKAGING MATERIAL FROM INSIDE REFRIGERATOR. DO NOT REMOVE SERIAL PLATE. IF NECESSARY TO REMOVE DOORS, REMOVE ALL HINGES. TO REINSTALL FOR DISPENSER MODELS: WHEN INSTALLING HINGE COVER.

9 TUBING CLIP. ALIGN DOORS EVENLY FRESH FOOD HINGE. AT TOP ADJUSTMENT PIN. COLLAR. 3 4 . 58 Reinstall lower hinges and tighten hinge screws firmly. Push tubing into connector Place door on lower hinge pin and install upper hinges. WIRING. PRESS THE WHITE COLLAR AS Tighten upper hinge screws firmly. YOU PULL OUT THE TUBING. (5 8 to 3 4 ) to prevent leakage. CONNECTORS. Align both doors evenly at top by adjusting pin on lower fresh food hinge. At lower left hinge, remove tubing At upper hinges, disconnect wiring connectors. from the clip. Reconnect wiring connectors and reinstall hinge covers.

10 Remove both hinges with each door to prevent Disconnect the water line. damage to tubing or wiring. Reinstall tubing by pushing tubing into connector. Put tubing back into clip. IMPORTANT: PLEASE READ CAREFULLY. FRAN AIS ESPANOL. PREFERRED. METHOD FOR PERSONAL SAFETY, THIS Appliance MUST BE PROPERLY GROUNDED. The power cord of this Appliance is equipped with a three-prong (grounding) plug that mates with a standard three-prong (grounding) wall receptacle to minimize the risk of electric shock hazard from this Appliance . The customer should have the wall receptacle and circuit checked by a qualified electrician to make sure the receptacle is properly grounded.