THIS MANUAL DESCRIBES THE SMARTCRAFT

1 Operation ManualTHIS MANUAL DESCRIBES THE SMARTCRAFTMERCMONITOR VERSION 2011, Mercury Marine90-8M0055062 411engi 2011 Mercury MarineMercMonitor Version 411 iiengengiii General InformationBasic Operation and Gateway Models Gateway Protocol Acceptance to a Non SMARTCRAFT Engine Detection Warnings with Descriptive and Using the Screen the Light and Contrast Menu Options ..20 Setting the the Screens the the the the External the the Tow (ECO) the Gauge to the Factory Default ivengPropulsion MenuUsing Propulsion Screens.

2 111 Available Propulsion Screens ..111 Troll Control Speed Pressure Synchronize Location Fuel Use ..122 Double Tachometer Speedometer Pressure Synchronize MenuUsing the Vessel Vessel (ECO) Data Waypoint Full ScreensFull Screens Features and Options ..161 Maintenance ScreensFavorites Screen Features and AssistanceLocal Repair Away from and Accessories Marine Service viengGENERAL INFORMATIONeng1 Basic Operation and FeaturesIMPORTANT: MercMonitor version can be assimilated intomany different power package configurations; from a single enginelow horsepower outboard motor, to a multiengine multistationdigital throttle and shift vessel.

3 There may be some gauge features,displays, operations, and warnings that will not be applicable foryour power package. Some screens can be turned on, but will notshow any changes to the display. See your selling dealer for anexplanation of what information your power package can up: After the ignition is turned on, the front splash screenwill display the name of the gauge, the level of the gauge, and theversion of the software for approximately two : Adjusts the brightness and contrast of the : The "MODE" button is used for selecting informationscreens.

4 The "+" and " " buttons are used for setting engine speedfor cruise control, launch control, and setting gauge return to the previous screen, hold the "MODE" button down forthree to five control: Sets and controls the speed of the engine control: Controls the speed of acceleration from idle tocruise Guardian System: Monitors the critical sensors on theengine for any early indication of problems. The system willrespond to a problem by reducing engine speed and alerting theoperator to a potentially damaging system: The system sounds the warning horn anddisplays the warning "AL" in the right corner of the "Main Menu"screen.

5 The alarm screen will pop up, flashing a warning icon inthe middle of the screen and the "AL" in the upper right side of thescreen. Press the "+" button to display the descriptive : Optional sensors such as depth, fuel, paddle wheel,and steering angle, should always be connected to the starboardengine when using SMARTCRAFT gauges version or INFORMATION 2engSYSTEM CHECK The system check screen will appear after the front splashscreen. This option must be enabled to view it. Depending onthe installed power package, the system check screen willdisplay the overall condition of the battery and a few othersensor conditions that are important for that power component description will be displayed on the left sideof the monitor, its corresponding icon will be off center right,an icon in motion to the right will indicate what is beingchecked.

6 When the component checks good, the icon inmotion will change to "OK." If the system check identifies aproblem, the icon in motion will change to a warning icon. Youcan bypass the system check by pressing the "MODE" buttonto skip the - Componentdescriptionb - Corresponding iconc - System check OKd - System checkwarning icone - Icon in motion After the system check is completed and no problem isidentified, the monitor screen reverts to the last screen thatwas visible before the key switch was turned off.

7 If a problemwas identified, the alarm screen will be displayed. Refer toAlarm Warnings with Descriptive CheckBattery[ SKIP ]Oil PsiWater PsiWater TempOKOK!30266abcdeMaintenanceGENERAL INFORMATIONeng3 PRODUCTS WITH EMISSIONS CONTROLA fter the ignition is turned on, the front splash screen will displaythe name of the gauge, the level of the gauge, and the version ofthe software for approximately two seconds. In the upper left handcorner of the display, a small engine icon will also be visible. Theicon is a representation the power package has emissions controlonboard diagnostics, also known as OBD.

8 The icon will only beseen during the key up process unless a system fault is an OBD fault is detected, the OBD icon will be displayed inthe upper left hand corner on all system iconMercMonitor Gateway Models DescriptionThere are four MercMonitor gateway models available; basemodel with nine gateway features, RPM Smart Tow model with 20gateway features, Smart Tow Pro model with 25 gateway features(includes a GPS puck), and Gateway Premier model with 25gateway features. Each model incorporates the use of NMEA20001.

9 And J1939 software interface that allows or controls accessto other engine must have its own gateway monitor when using thebase or RPM Smart Tow models. Gateway Premier and Smart TowPro models can communicate and provide NMEA 2000/J11939with four engines or less. Gateway Premier and Smart Tow Promodels screen will only display single engine data. Premier doesnot include Smart Tow Pro control NMEA 2000 pending INFORMATION 4engBase Model (single engine, NMEA 2000 support selectable)NMEA 2000 and J1939 in/outsupportedRPMV oltageOil pressureCoolant temperatureFuel tank level percentNMEA 2000 only in/out supportedFluid level percent (Fuel 2, oil, water,waste)Trim positionWater pressureCheck engine alarmIMPORTANT.

10 NMEA 2000/J1939 alarmdata is limited, refer to the MercMonitordisplay for descriptive fault INFORMATIONeng5 RPM Smart Tow Model (single engine, NMEA 2000 support selectable)NMEA 2000 and J1939 in/out supportedRPMV oltageOil pressureCoolant temperatureFuel tank level percentFuel flowEngine hoursBoost pressureOil temperatureNMEA 2000 only in/out supportedFluid level percent (Fuel 2, oil, water,waste)Trim positionWater pressureCheck engine alarmIMPORTANT: NMEA 2000/J1939alarm data is limited, refer to theMercMonitor display for descriptivefault speed/COG/latitude, longitude(in only)DepthSeawater temperaturePaddle wheel speedPitot speedGENERAL INFORMATION 6engSmart Tow Pro Model with GPS puck (four engine or less, NMEA 2000 supportselectable)NMEA 2000 and J1939 in/outsupportedRPMV oltageOil pressureCoolant temperatureFuel tank level percentFuel flowEngine hoursBoost pressureOil temperatureNMEA 2000 in/out supported (only)