THIS MANUAL DESCRIBES THE SMARTCRAFT

1 Operation ManualTHIS MANUAL DESCRIBES THE SMARTCRAFTMERCMONITOR VERSION 2011, Mercury Marine90-8M0055062 411engi 2011 Mercury MarineMercMonitor Version 411 iiengengiii General InformationBasic Operation and Gateway Models Gateway Protocol Acceptance to a Non SMARTCRAFT Engine Detection Warnings with Descriptive and Using the Screen the Light and Contrast Menu Options ..20 Setting the the Screens the the the the External the the Tow (ECO) the Gauge to the Factory Default ivengPropulsion MenuUsing Propulsion Screens ..111 Available Propulsion Screens ..111 Troll Control Speed Pressure Synchronize Location Fuel Use ..122 Double Tachometer Speedometer Pressure Synchronize MenuUsing the Vessel Vessel (ECO) Data Waypoint Full ScreensFull Screens Features and Options.

2 161 Maintenance ScreensFavorites Screen Features and AssistanceLocal Repair Away from and Accessories Marine Service viengGENERAL INFORMATIONeng1 Basic Operation and FeaturesIMPORTANT: MercMonitor version can be assimilated intomany different power package configurations; from a single enginelow horsepower outboard motor, to a multiengine multistationdigital throttle and shift vessel. There may be some gauge features,displays, operations, and warnings that will not be applicable foryour power package. Some screens can be turned on, but will notshow any changes to the display. See your selling dealer for anexplanation of what information your power package can up: After the ignition is turned on, the front splash screenwill display the name of the gauge, the level of the gauge, and theversion of the software for approximately two : Adjusts the brightness and contrast of the : The "MODE" button is used for selecting informationscreens.

3 The "+" and " " buttons are used for setting engine speedfor cruise control, launch control, and setting gauge return to the previous screen, hold the "MODE" button down forthree to five control: Sets and controls the speed of the engine control: Controls the speed of acceleration from idle tocruise Guardian System: Monitors the critical sensors on theengine for any early indication of problems. The system willrespond to a problem by reducing engine speed and alerting theoperator to a potentially damaging system: The system sounds the warning horn anddisplays the warning "AL" in the right corner of the "Main Menu"screen. The alarm screen will pop up, flashing a warning icon inthe middle of the screen and the "AL" in the upper right side of thescreen. Press the "+" button to display the descriptive : Optional sensors such as depth, fuel, paddle wheel,and steering angle, should always be connected to the starboardengine when using SMARTCRAFT gauges version or INFORMATION 2engSYSTEM CHECK The system check screen will appear after the front splashscreen.

4 This option must be enabled to view it. Depending onthe installed power package, the system check screen willdisplay the overall condition of the battery and a few othersensor conditions that are important for that power component description will be displayed on the left sideof the monitor, its corresponding icon will be off center right,an icon in motion to the right will indicate what is beingchecked. When the component checks good, the icon inmotion will change to "OK." If the system check identifies aproblem, the icon in motion will change to a warning icon. Youcan bypass the system check by pressing the "MODE" buttonto skip the - Componentdescriptionb - Corresponding iconc - System check OKd - System checkwarning icone - Icon in motion After the system check is completed and no problem isidentified, the monitor screen reverts to the last screen thatwas visible before the key switch was turned off.

5 If a problemwas identified, the alarm screen will be displayed. Refer toAlarm Warnings with Descriptive CheckBattery[ SKIP ]Oil PsiWater PsiWater TempOKOK!30266abcdeMaintenanceGENERAL INFORMATIONeng3 PRODUCTS WITH EMISSIONS CONTROLA fter the ignition is turned on, the front splash screen will displaythe name of the gauge, the level of the gauge, and the version ofthe software for approximately two seconds. In the upper left handcorner of the display, a small engine icon will also be visible. Theicon is a representation the power package has emissions controlonboard diagnostics, also known as OBD. The icon will only beseen during the key up process unless a system fault is an OBD fault is detected, the OBD icon will be displayed inthe upper left hand corner on all system iconMercMonitor Gateway Models DescriptionThere are four MercMonitor gateway models available; basemodel with nine gateway features, RPM Smart Tow model with 20gateway features, Smart Tow Pro model with 25 gateway features(includes a GPS puck), and Gateway Premier model with 25gateway features.

6 Each model incorporates the use of NMEA20001. and J1939 software interface that allows or controls accessto other engine must have its own gateway monitor when using thebase or RPM Smart Tow models. Gateway Premier and Smart TowPro models can communicate and provide NMEA 2000/J11939with four engines or less. Gateway Premier and Smart Tow Promodels screen will only display single engine data. Premier doesnot include Smart Tow Pro control NMEA 2000 pending INFORMATION 4engBase Model (single engine, NMEA 2000 support selectable)NMEA 2000 and J1939 in/outsupportedRPMV oltageOil pressureCoolant temperatureFuel tank level percentNMEA 2000 only in/out supportedFluid level percent (Fuel 2, oil, water,waste)Trim positionWater pressureCheck engine alarmIMPORTANT: NMEA 2000/J1939 alarmdata is limited, refer to the MercMonitordisplay for descriptive fault INFORMATIONeng5 RPM Smart Tow Model (single engine, NMEA 2000 support selectable)NMEA 2000 and J1939 in/out supportedRPMV oltageOil pressureCoolant temperatureFuel tank level percentFuel flowEngine hoursBoost pressureOil temperatureNMEA 2000 only in/out supportedFluid level percent (Fuel 2, oil, water,waste)Trim positionWater pressureCheck engine alarmIMPORTANT.

7 NMEA 2000/J1939alarm data is limited, refer to theMercMonitor display for descriptivefault speed/COG/latitude, longitude(in only)DepthSeawater temperaturePaddle wheel speedPitot speedGENERAL INFORMATION 6engSmart Tow Pro Model with GPS puck (four engine or less, NMEA 2000 supportselectable)NMEA 2000 and J1939 in/outsupportedRPMV oltageOil pressureCoolant temperatureFuel tank level percentFuel flowEngine hoursBoost pressureOil temperatureNMEA 2000 in/out supported (only)Fluid level percent (Fuel 2, oil, water,waste)Trim positionWater pressureCheck engine alarmIMPORTANT: NMEA 2000/J1939alarm data is limited, refer to theMercMonitor display for descriptivefault speed/COG/latitude, longitude(in only)DepthSeawater temperaturePaddle wheel speedPitot speedRudder angleGear pressure (CMD diesel)Gear temperature (CMD diesel)Fuel pressureCapacity (English or metric)GENERAL INFORMATIONeng7 Gateway Premier (four engine or less, NMEA 2000 support selectable)(includes RPM Smart Tow)NMEA 2000 and J1939 in/outsupportedRPMV oltageOil pressureCoolant temperatureFuel tank level percentFuel flowEngine hoursBoost pressureOil temperatureNMEA 2000 in/out supported (only)Fluid level percent (Fuel 2, oil, water,waste)Trim positionWater pressureCheck engine alarmIMPORTANT.

8 NMEA 2000/J1939alarm data is limited, refer to theMercMonitor display for descriptivefault speed/COG/latitude, longitude(in only)DepthSeawater temperaturePaddle wheel speedPitot speedRudder angleGear pressure (CMD diesel)Gear temperature (CMD diesel)Fuel pressureCapacity (English or metric)GENERAL INFORMATION 8engMercMonitor Gateway Protocol AcceptanceDescriptionGateway is a software interface that allows or controls access toother programs through a NMEA 2000 or J1939 protocol; abackbone for communication to share information. The software iscapable of transmitting (TX) information to, and receiving (RX)information from various parameter group number (PGN) ModesTransmit (TX)Receive (RX)Transmits engine data to NMEA 2000/J1939compatible display data from NMEA2000/J1939 and RPM Smart Tow models require oneMercMonitor per engine requires itsown MercMonitorregardless of the model(base, RPM Smart Tow,Smart Tow Pro, GatewayPremier)Gateway Premier and Smart Tow Pro modelsrequire only one MercMonitor per vessel totransmit multiengine data to multifunctiondisplays (MFD) through the NMEA 2000 MercMonitor will display one engine onlyregardless of the model (base, RPM Smart Tow,Smart Tow Pro, Gateway Premier).

9 Mercury Engine Data to NMEA 2000 Capable ProductsSignalPGN NameNMEA 2000 PGNModeRated RPME ngine Parameter Static127498/0x1F20 ARX/TXCoolant PressureEngine Parameters RapidDynamic127489/0x1F201RX/TXSpeed Over WaterSpeed128259/0x1F503RX/TXRPME ngine Parameters RapidUpdate127488/0x1F200RX/TXVoltageEng ine Parameters RapidDynamic127489/0x1F201RX/TXGENERAL INFORMATIONeng9 Mercury Engine Data to NMEA 2000 Capable ProductsSignalPGN NameNMEA 2000 PGNModeCoolantTemperatureEngine Parameters RapidDynamic127489/0x1F201RX/TXFuel PressureEngine Parameters RapidDynamic127489/0x1F201RX/TXFuel LevelFluid Level127505/0x1F211RX/TXFuel Tank SizeFluid Level127505/0x1F211RX/TXFuel FlowEngine Parameters RapidDynamic127489/0x1F201RX/TXOil PressureEngine Parameters RapidDynamic127489/0x1F201RX/TXOil TemperatureEngine Parameters RapidDynamic127489/0x1F201RX/TXGear TempTransmission Dynamic127493/0x1F205RX/TXGear PressureTransmission Dynamic127493/0x1F205RX/TXBoost PressureEngine Parameters RapidUpdate127488/0x1F200RX/TXTrim positionEngine Parameters RapidUpdate127488/0x1F200RX/TXRudder AngleRudder127245/0x1F10 DRX/TXDepthDepth128267/0x1F50 BRX/TXDepth OffsetDepth128267/0x1F50 BRX/TXSeawater TempEnvironmentalParameters130310/0x1FD0 6RX/TXEngine hoursEngine Parameters RapidDynamic127489/0x1F201RX/TXManufactu rer IDAddress Claim (0 x 90 =Mercury)

10 060928/0xEE00RX/TXAlarm dataCheck Engine127489/0x1F201RX/TXTabsSmall Craft Status130576/0x1FE10RX/TXCourse over GroundCOG and SOG RapidUpdate129026/0x9F802 RXSpeed over GroundCOG and SOG RapidUpdate129026/0x9F802 RXGPS PositionPosition Rapid Update129025/0x1F801 RXGENERAL INFORMATION 10engMercury Engine Data to NMEA 2000 Capable ProductsSignalPGN NameNMEA 2000 PGNModeBatteryBattery Status127508/0x1F214RX/TXMercury Engine Data to J1939 Capable ProductsSignalPGN NameJ1939 PGNModeRPME lectronic EngineController #161444/0xF004 TXVoltageVehicle Electrical Power65271/0xFEF7 TXCoolant TemperatureEngine Temperature #165262/0xFEEETXFuel LevelDash Display65276/0xFEFCTXFuel ConsumptionFuel Economy (Liquid)65266/0xFEF2 TXFuel FlowFuel Economy (Liquid)65266/0xFEF2 TXOil PressureEngine Fluid Level/Press#165263/0xFEEFTXB oost PressureInlet/Exhaust Conditions65270/0xFEF6 TXEngine hoursTotal Engine Hours65253/0xFEE5 TXManufacturer IDAddress Claim (0 x 90 =Mercury)61182/0xEEFETXA larm data(Diagnostic messagesupported)Check Engine65226/0xFECATXLine Line AC RMS VoltGenerator Set Average65030/0xFE06RX/TXAC RMS FrequencyGenerator Set Average65030/0xFE06RX/TXConnection to a Non SMARTCRAFT NetworkThe use of the MercMonitor on a non SMARTCRAFT networkapplication requires the MercMonitor gateway set to "Receive.