Transcription of TJLJ Front Bumper - HANSON OFFROAD
1 12539 Jomani Drive Bakersfield, CA 93312 JEEP TJ/LJ Front Bumper INSTALLATION INSTRUCTIONSRC41102-PJR51202-PJR61102-PR C41103-PJR51302-PJR61202-PJR51102-PJR514 02-PJR61302-PINCLUDED PARTS LIST1 - Front BUMPER6 - 1/2 X BOLT6 - 1/2 FLAT WASHER6 - 1/2 LOCK WASHER1. Start by removing factory fog lamps ifyour vehicle came factory Remove fog light wiring from firewallB. Unplug fog light from wiring harnessC. Using a 13mm remove foglight remove as Remove the 4-T55 bolts on the top of Bumper . (2 on each side )3. Remove the 2-T55 bolts on the bottom of Bumper .
2 (1 on each side )Remove stock Bumper from If installing a winch, we recommend installing the fairlead plate (sold separately: W9500 / W8274) and winch to the Bumper for easy access to the bolts underneath the winch If not installing a winch and you would like to run fog lights install fog lights at this time. The tab will need to be bent flush (as shown in the photo)5. The factory fog lights can be installed in place of the winch as With the Front Bumper prepared and the stock Bumper removed, place Bumper on the end of the frame Bumper will align to frame as shown in the Two bolts mount on the topside of the frame and one installs on the Align Bumper by measuring off of the frame.
3 Stand back and double check that your Bumper looks centered. Realign if Tighten all 6 of the bolts using a wrench. Torque bolts to 75 all hardware after 500 miles and after off-road trips.
