Transcription of TORQUE SHAFT ASSEMBLY required when running TTI …
1 #SHT7174 TSA ( ). TORQUE SHAFT ASSEMBLY . TORQUE SHAFT ASSEMBLY required when running TTI Headers or Exhaust system to manifolds on some B & E body applications with column shift linkage A modified design TORQUE SHAFT ASSEMBLY is required if the drivers-side stock straight TORQUE SHAFT rod is mounted below the torsion bar. The stock straight TORQUE SHAFT rod passes directly through the space where the header tubes or the exhaust pipe must go. This precision bent TORQUE SHAFT ASSEMBLY with laser cut ends go up and over the header tubes or exhaust pipe which allows you to maintain your column shift linkage and is a direct bolt-on replacement of your stock straight TORQUE SHAFT rod.
2 Transmission Part #. 727 B7174 TSA-7 (Narrow bracket). 904 B7174 TSA-9 (Wide bracket). Bracket mounts to transmission after removing factory bracket. This side mounts to (904 bracket shown) frame with factory bracket. Rear rod transmission to TORQUE SHAFT ASSEMBLY Modification require to rear rod. Top view looking down (Modified rod shown). TRANSMISSION LEVER END. TORQUE SHAFT END. Side view looking toward transmission Tube Technologies Inc. - 1555 Consumer Circle - Corona, CA 92880-1726 - (951)371-4878 Fax (951)371-6143.
