TSC Sealing Compound - Cooper Industries

1 SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCEIF 1370 TSC Sealing CompoundSafety Data SheetIF 1370 08/17 Copyright 2017, Eaton s Crouse-Hinds Division Page 1 SECTION 1: PRODUCT & COMPANY IDENTIFICATIONC hemical Product Name: TSC Sealing Compound , Epoxy Putty, Crouse- Hinds Epoxy StickProduct Description: Sealing Compound , epoxy stickCAS Number: Mixture of 25068-38-6, 90-72-2, and 14807-96-6 Synonyms: NARecommended Use(s): Epoxy putty that, when applied and cured, provides an effective seal for cable fitting and electrical connectors Company Information: Eaton s Crouse-Hinds Division 1201 Wolf Street Syracuse, NY 13208 USAT elephone: (866) 764-5454 Emergency Phone: CHEMTREC (800) 424-9300 SECTION 2: HAZARDS IDENTIFICATION OSHA HCS Status: This product is a hazardous chemical, as defined by OSHA at 29 CFR Hazards identified are based on hazards of the ingredients.

2 This product has not been fully Route of Exposure/Target Organs: Eyes, dermal OSHA/GHS Signal Word and Hazard Statements:WARNING: Causes skin irritation. May cause an allergic skin reaction. Causes eye Classification and Pictograms:Skin irritation Category 2 Skin sensitization Category 1 Eye irritation Category 2 BOSHA/GHS Precautionary Statements:Prevention: Avoid breathing dust or fumes. Wash hands thoroughly after handling.

3 Contaminated work clothing should not be allowed out of the workplace. Wear protective gloves. Use personal protective equipment as required. Response: If on skin: Wash with plenty of soap and water. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs: Get medical advice/attention. If eye irritation persists: Get medical advice/attention. Take off contaminated clothing and wash before re-use. Wash contaminated clothing before : Dispose of contents/container in accordance with local/regional/national/international Hazard and Precautionary Statement Codes: See Section Not Otherwise Specified: Not 3: COMPOSITION & INFORMATION ON INGREDIENTSSECTION 4: FIRST AID MEASURESEye Contact: Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids.

4 Check for and remove any contact lenses. Continue to rinse for at least 10 Contact: Wash with plenty of soap and water. Remove contaminated clothing and shoes. Wash contaminated clothing thoroughly with water before removing it, or wear gloves. Continue to rinse for at least 10 minutes. Get medical attention. In the event of any complaints or symptoms, avoid further exposure. Wash clothing before re-use. Clean shoes thoroughly before : Remove victim to fresh air and keep at rest in a position comfortable for breathing. If not breathing, if breathing is irregular or if respiratory arrest occurs, provide artificial respiration or oxygen by trained personnel. It may be dangerous to the person providing aid to give mouth-to-mouth resuscitation.

5 Get medical attention. If unconscious, place in recovery position and get medical attention immediately. Maintain an open airway. Loosen tight clothing, such as collar, tie, belt or waistband. In case of inhalation of decomposition products in a fire, symptoms may be delayed. The exposed person may need to be kept under medical surveillance for 48 : Wash out mouth with water. Remove dentures, if any. Remove victim to fresh air and keep at rest in a position comfortable for breathing. If material has been swallowed and the exposed person is conscious, give small quantities of water to drink. Stop if the exposed person feels sick, as vomiting may be dangerous. Do not induce vomiting unless directed to do so by medical personnel.

6 If vomiting occurs, the head should be kept low so that vomit does not enter the lungs. Get medical attention. Never give anything by mouth to an unconscious person. If unconscious, place in recovery position and get medical attention immediately. Loosen tight clothing, such as collar, tie, belt or to Physician: In case of inhalation of decomposition products in a fire, symptoms may be delayed. The exposed person may need to be kept under surveillance for 48 Important Symptoms/Effects: Causes eye and skin of Immediate Medical Attention and Special Treatment Needed: Skin or eye 5: FIRE FIGHTING MEASURESS pecial Fire Fighting Procedures: No unusual fire hazards. Extinguishing media: Use media appropriate for surrounding Equipment: Firefighters should wear a NIOSH approved, full face piece self-contained breathing apparatus (SCBA) operated in positive pressure mode and full turnout or bunker gear with additional chemical protective clothing as necessary to protect against thermal decomposition Fire or Explosion Hazards: Water may be used to keep fire-exposed containers cool and knock down vapors.

7 Mists and sprays may be flammable at temperatures below normal flash point. No unusual fire hazards. If there is a fire, promptly isolate the scene by removing all persons from the vicinity of the incident. No action shall be taken involving any personal risk or without suitable Combustion Products: Not flammable. Thermal decomposition may produce carbon dioxide, carbon monoxide, nitrogen oxides, sulfur oxides, halogenated compounds and metal #%Reaction product: bisphenol-A-(epichlorhydrin) and epoxy resin25068-38-65-10 Phenol, 2,4,6-tris[(dimethylamino)methyl]-90-72- 21-5 Talc (not containing asbestiform fibers of respirable crystalline silica) 1370 08/17 Copyright 2017, Eaton s Crouse-Hinds Division Page 2 SECTION 6: ACCIDENTAL RELEASE MEASURES Personal Protection: No action shall be taken involving any personal risk or without suitable training.

8 Evacuate surrounding areas. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilled material. Provide adequate ventilation. Wear appropriate respirator when ventilation is inadequate. Put on appropriate personal protective equipment. If specialized clothing is required to deal with the spillage, take note of information in Section 8 on suitable and unsuitable materials. See also information in for non-emergency personnel. Spill Procedures: Small spill: Move containers from spill area. Avoid dust generation. Do not dry sweep. Vacuum dust with equipment fitted with a HEPA filter and place in a closed, labeled waste container. Dispose of via a licensed waste disposal contractor. See Section 1 for emergency contact information and Section 13 for waste Spill: Move containers from spill area.

9 Approach release from upwind. Prevent entry into sewers, waterways, basements and confined areas. Avoid dust generation. Do not dry sweep. Vacuum dust with equipment fitted with a HEPA filter and place in a closed, labeled waste container. Dispose of waste via a licensed waste disposal contractor. See Section 1 for emergency contact information and Section 13 for waste Precautions and Clean-up Methods: Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains and sewers. Inform the relevant authorities if the product has caused environmental pollution (sewers, waterways, soil or air). SECTION 7: HANDLING & STORAGE Precautions: Put on appropriate personal protective equipment (see Section 8). Persons with a history of skin sensitization problems should not work in or near any process in which this product is used.

10 Avoid exposure obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not get in eyes, on skin or on clothing. Do not ingest. If, during normal use, the material presents a respiratory hazard, use only with adequate ventilation or wear appropriate respirator. Keep in the original container or an approved alternate made from a compatible material, kept tightly closed when not in use. Empty containers retain product residue and can be hazardous. Do not reuse : Do not store above 35 C (95 F). Store in accordance with local regulations. Store in original container protected from direct sunlight in a dry, cool and well ventilated area, away from incompatible materials (see Section 10).